coolant level PONTIAC FIREBIRD 1996 Owners Manual

Low Coolant Light (V8 Engine)
LOW
COOLANT
I
This warning light should
come on while
you are
starting your engine. If the
light doesn’t come on, have
it repaired.
Your Firebird
is equipped with a LOW COOLANT
indicator which is designed to detect when the coolant
level
drops below set limits. If the low coolant level
sensor (on the radiator)
drops while the engine is
running, ‘the LOW COOLANT indicator will light
and remain lit until the ignition switch is turned to
the
OFF position. Check coolant level and add coolant
as needed. The LOW COOLANT light might stay on
after filling the radiator., Turn the ignition switch to the
OFF position, then restart the engine to verify that the
LOW COOLANT light goes out. See “Engine Coolant”
in the Index.
~
NOTICE:
Driving with the LOW COOLANT light on could
cause your Pontiac to overheat. See “Engine
Overheating’’
in the^ Index. Your Pontiac could be
damaged md it wouldn’t be covered by your
warranty.
2-82
ProCarManuals.com

The air conditioner compressor operates in MAX, A/C,
BI-LEVEL, BLEND and DEFROST when the outside
temperature is above freezing. When the air conditioner
is on, you may sometimes notice slight changes
in your
vehicle’s engine speed and power. This is normal because
the system .is designed to cycle the compressor on and off
to keep
the desired cooling and help fuel economy.
Cooling
The air conditioner works best if you keep your
windows closed.
On very hot days, open the windows
just long enough for the hot air to escape.
1. Turn the air control knob to A/C for normal cooling.
2. Turn the temperature control knob to a
3. Move the fan control knob to the desired speed. For faster cooling, move
the knob to
MAX.
comfortable setting. During initial start-up
only, if your vehicle
is equipped
with an optional engine coolant heater, you can use it in
cold weather (around
+20 O F/-8 O C or lower) to improve
heater performance on start up. Because an engine
coolant heater warms the engine coolant, your vehicle’s
‘heating system can more efficiently provide heat for the
passenger area
of your vehicle. See “Engine Coolant
Heater” in the Index.
Bi-Level Heating
You may want to use bi-level heating on cool, but sunny
days. This setting directs cool air toward your body and
warmer air toward your feet.
1. Turn the air control knob to BI-LEVEL.
2. Turn the temperature control knob to a
comfortable setting.
3. Turn the fan control knob to the desired speed.
Heating
The heater works best if you keep your windows closed
while using it.
1. Turn the air control knob to HEATER.
2. Turn the fan control knob to the desired speed.
3. Turn the temperature control knob to a
comfortable setting.
3-3
ProCarManuals.com

An electric fan under the hood can start up even
when the engine
is not running and can injure
you. Keep hands, clothing
and tools away from
any underhood electric fan,
If the coolant inside the coolant recovery tank is boiling,
don’t do anything
else until it cools down.
When it is cool, remove the coolant recovery tank cap
and
look at the dipstick.
The coolant level should be at FULL COLD. If it
isn’t, you may have a leak in the radiator hoses, heater
hoses, radiator, water pump or somewhere else in
the
cooling system.

5-16
ProCarManuals.com

Heater and radiator hoses, and other engine
parts, can be very hot. Don’t touch them.
If you
do, you can be burned.
Don’t run the engine if there is a leak.
If you run
the engine, it could lose all coolant. That could
cause
an engine fire, and you could be burned.
Get any leak fixed before you drive the vehicle.

NOTICE:
Engine damage from running your engine
without coolant isn’t covered by your warranty.
If there seems to be no leak, with the engine on, check to
see if the electric engine fan is running. If the engine
is
overheating, the fan should be running. If it isn’t, your
vehicle needs service.
How to Add Coolant to the Coolant
Recovery Tank
If you haven’t found a problem yet, but the coolant level
isn’t at
FULL COLD, add a 50/50 mixture of clean
water
(preferably distilled) and DEX-COOL TM
(orange-colored, silicate-free) antifreeze at the coolant
recovery tank. (See “Engine Coolant” in the Index for
more information.)
I A CAUTION:
Adding only plain water to your cooling system
can be dangerous. Plain water, or some other
liquid like alcohol, can boil before the proper
coolant mix
will. Your vehicle’s coolant warning
system is set for the proper coolant mix. With
plain water or the wrong mix, your engine could
get too hot but you wouldn’t get the overheat
warning. Your engine could catch fire and you or
others could be burned. Use a
50/50 mix of clean
water and
DEX-COOL TM antifreeze.
ProCarManuals.com

6. Start the engine and let it run until you can feel the
upper radiator hose getting hot. Watch out for the
engine
fan.
filler neck may be lower. If the level is lower, add
more
of the proper mix through the filler neck until
the level reaches the base
of the filler neck.
7. By this time the coolant level inside the radiator
8. Then replace the pressure cap. At any time during
this procedure if coolant begins to flow out
of the
filler neck, reinstall the pressure cap. Be sure the
arrows on the pressure cap line up like this.
, 'I I
5-22
ProCarManuals.com

4. Fill with the proper mix. Add coolant until you
see a steady stream of coolant coming from the
bleed valves.
.. i L . -8
-.
5. Close the bleed valves.
6. Continue to fill the radiator up to the base of the
7. Rinse or wipe the spilled coolant from the engine
and compartment.
8. Start the engine and allow it to run in idle for
approximately four minutes. By this time, the
coolant level inside the radiator will be lower.
Add
more of the proper mix through the filler neck until
the level reaches the base of the filler neck.
filler
neck.
I. . :-
ProCarManuals.com

9. Shut the engine off and replace the pressure cap. Be
sure the arrows on the cap line up like this.
10. Then fill the coolant recovery tank to the proper
level.
For a complete
drain, flush and refill, see your Pontiac
dealer or a Pontiac Firebird Service Manual. To
purchase a service manual, see “Service and Owner
Publications”
in the Index.
5-26
ProCarManuals.com

Rear Axle
When to Check and Change Lubricant
Refer to the Maintenance’ Schedule to determine how
often to check the lubricant and when to change it. See
“Periodic Maintenance Inspections” in the Index.
How to Check Lubricant
If the level is below the bottom of the filler plug hole,
you’ll need to add some lubricant.. Add enough lubricant
to raise the level to the bottom of the filler plug hole.
What to Use
Standard Differential
Use Axle Lubricant (GM Part No. 12345977) or
SAE 8OW-90 GL-5 gear lubricant. -
Limited-Slip Differential
To add lubricant when the level is low, use Axle
Lubricant
(GM Part No. 12345977). To completely refill
after draining, add
2 ounces (59 ml) of Limited-Slip
Differential Lubricant Additive
(GM Part No. 1052358).
Then fill to the bottom of the filler plug hole with Axle
Lubricant (GM,Part No. 12345977).
/
Engine Coolant
The cooling system in your vehicle is filled with new
DEX-COOL TM (orange-colored, silicate-free) engine
coolant. This coolant is designed to remain in your
vehicle
for 5 years or 100,000 miles (166 000 km),
whichever occurs first.
The following explains your cooling system and how to
add coolant when it is
low. If you have a problem with
engine overheating or if you need to add coolant to your
radiator, see “Engine Overheating” in the Index.
A 50/50 mixture of water and the proper coolant for
your Pontiac will:
0
0
0
a
a
Give freezing protection down to -34 OF (-3 7 O C).
Give boiling protection up to 265 OF ( 129°C).
Protect against rust and corrosion.
Help keep the proper engine temperature.
Let the warning lights and gages work as they should.
,. .:
. .( , <.
6-26
ProCarManuals.com

NOTICE:
If you use an improper coolant mix, your engine
could overheat and be badly damaged. The
repair cos’t wouldn’t be covered by your
warranty.
Too much water in the mix can freeze
and crack the engine, radiator, heater core and
other parts.
If you have to add coolant more than four times a year,
have your dealer check your cooling system.
NOTICE:
If you use the proper coolant, you don’t have to
add extra inhibitors or additives which claim to
improve the system. These
can be harmful.
Checking Coolant
When your engine is cold, check the dipstick on the cap
of the coolant recovery tank. The coolant level should
be at COLD, or a little higher. When your engine is
warm, the level on the dipstick should be up to HOT, or
a little higher.
6-28
ProCarManuals.com

Fuse Usage
CIGAWACCY Cigarette Lighter, Data Link
Connector (DLC), Auxiliary
Accessory Wire
DEFOG/SEATS Rear Defogger SwitchiTimer,
Rear Defogger Timermelay,
Power Seats
EVAP Canister Purge
Vacuum Switch, EVAP Canister
Purge Valve, Transmission
Wiperwasher Switch
Express-Down Module, Coolant
Level Latching Module,
Convertible Top Switch
PCM IGN Powertrain Control Module (PCM),
WIPEWASH Wiper Motor Assembly,
WINDOWS Power Windows
Switch (RH, LH),
Fuse
Usage
I/P DIMMER Door
Illumination Lamp (RH, LH),
Headlamp Switch,
Fog Lamp
Switch, Instrument Cluster,
HVAC Control Assembly,
PRNDL Illumination Lamp,
Ashtray Lamp, Radio, Steering
Wheel Controls-Radio,
Rear Window Defogger
Switch/Timer,
Performance/Traction
Control Switch
Body Control Module (BCM),
Radio, Amplifier, Steering Wheel
Controls-Radio
RADIO
6-66
ProCarManuals.com