spare wheel PONTIAC FIREBIRD 1997 Owners Manual

If your vehicle has this option, it has a theft-deterrent
alarm system. Once armed, the system will sound the
horn and flash the parking lamps if the vehicle is
broken into.
Shock Sensor
Coupe Convertible
The shock sensor is what triggers the alarm when it
detects a blow to your vehicle. It
is located over the
right rear wheelhouse near the spare
tire in the hatch
area. There are two levels of alarms via the shock
sensor: Two horn blasts and parking lamp flashes for
non-threatening blows to the vehicle and
a full two
minute alarm for harder blows to the vehicle. Its
sensitivity can be adjusted if more or less sensitivity is
desired. (Note: If sensitivity is increased too much,
it
may give false alarms caused by gusts of wind or other
natural events that may shake the vehicle).
To adjust, remove the label covering the adjustment
knob on the sensor and adjust as desired. Turn clockwise
to increase sensitivity and turn counterclockwise to decrease sensitivity. The shock sensor
is ignored by the
alarm system when the ignition is on, when the hatch is
open, when the alarm is disarmed, when it is customized
to be ignored and for five seconds after
the horn sounds
an alarm or chirp. The shock sensor is ignored after
triggering three full alarms until the system is rearmed.
2-13

LOW
TRAC
This light will come on
when your traction control
system is limiting wheel
spin. See “Low Traction
Light” in the Index.
You
may feel or hear the system
working, but this is normal.
TCS
OFF
When the system is on,
this warning light will
come on to let you how
if
there’s a problem with your
traction control. system.
See “Traction Control
System Warning Light”
in the Index.
The traction control system may operate on dry roads
under some conditions, and you may notice a reduction
in acceleration when this happens. This is normal and
doesn’t mean there’s a problem with your vehicle.
Examples of these conditions include a hard acceleration
in
a turn, or an abrupt upshift or downshift. Also, when
the compact spare tire is on
the rear axle, the traction
control system will cycle and limit acceleration for about
the first 15 seconds of driving after each engine start.
If your vehicle is in cruise control when the traction
control system begins to limit wheel spin, the cruise
control will automatically disengage. When road
conditions allow you to safely use it again, you may
re-engage the cruise control. (See “Cruise Control’’ in
the Index.)
When this warning light is on, the system will not limit
wheel spin. Adjust your driving accordingly.
The traction control system automatically comes on
whenever you start your vehicle.
To limit wheel spin,
especially in slippery road conditions, you should
always leave the system on. But you can turn the
traction control system off
if you ever need to. (You
should turn the system off if your vehicle ever gets stuck
in sand, mud,
ice or snow. See “Rocking Your Vehicle”
in the Index.)
4-9

If you have speakers in the trim panel, you may have to
disconnect the wire from the speaker. The speaker wire
may be long enough to remove the trim panel without
disconnecting
the wire.
Remove the wing nut and adapter and
pull out the spare.
To remove the jack and wheel wrench, loosen and
remove the bolt and remove the plastic cover.
5-28

Removing the Flat Tire and Installing the Spare Tire
1. Using the wheel wrench, loosen all the wheel nuts.
Don’t remove them yet. Position the
jack under the vehicle. There
is a notch
in the vehicle’s rocker flange
on the coupe model.
Raise the jack head until
it fits firmly into the notch
nearest the flat tire.
On convertible models, place
the jack in a
similar location.
5-31

3. Remove any rust or dirt
from the wheel bolts,
mounting surfaces and spare wheel.
Raise the vehicle
by rotating the wheel wrench
clockwise. Raise the vehicle far enough
off the
ground
so there is enough room for the spare tire to
fit. Remove all the wheel nuts and take
off the
flat tire.
5-33

Incorrect wheel nuts or improperly tightened
wheel nuts can cause the wheel
to become loose
and even come
off. This could lead to an accident.
Be sure to use the correct wheel nuts.
If you have
to replace them, be sure to get new
GM original
equipment wheel nuts.
Stop somewhere as
soon as you can and have the
1 nuts tightened with a torque wrench to 100 lb-ft
(140 N.m).
--
NOTICE:
Improperly tightened wheel nuts can lead to
brake pulsation and rotor damage.
To avoid
expensive brake repairs, evenly tighten the
wheel
nuts in the proper sequence and to the proper
torque specification.
Don’t try to put a center cap on your compact spare
tire. It won’t fit. Store the center
cap in the rear area
until you have the flat tire repaired or replaced.
NOTICE:
Center caps won’t fit on your compact spare. If
you try to put a center cap on your compact
spare, you could damage the cover or @he spare.
Sto-5g a Flat or Spr-s Tirp --d To&
Storing a jack, a tire or other equipment in the
passenger compartment
of the vehicle could
cause injury.
In a sudden stop or collision, loose
1 equipment could strike someone. Store all these
~ in the proper place.
5-36

Replace the jack, wheel wrench and flat tire using the
storage instructions. When
you replace the trim panel,
be sure to tuck
it under the weatherstrip.
1 : Trim Panel
2. Bolt
3. Cover
4. Jack
5. Wing Nut
6. Adapter
7. Compact Spare Tire
8. Full-Size Tire
9. Carpet Flap
10. Tire Storage Bolt
11. Convertible Top Protection
12. Knob
5-37

NOTICE:
When the compact spare is installed, don’t take
your vehicle through an automatic vehicle wash
with guide rails. The compact spare can get
caught on the rails. That can damage the
tire and
wheel, and maybe other parts
of your vehicle.
Don’t use your compact spare on other vehicles.
And don’t mix your compact spare tire or wheel with
other wheels or tires. They won’t fit. Keep your spare
tire and its wheel together.
NOTICE:
Tire chains won’t fit your compact spare. Using
them can damage your vehicle and can damage
the chains
too. Don’t use tire chains on your
compact spare.
:f You’re Stuck: In Sand, Mud,
Ice or Snow
What you don’t want to do when your vehicle is stuck is
to spin your wheels too fast. The method known as
“rocking” can help you get out when you’re stuck, but
you must use caution.
1
If you let your tires spin at high speed, they can
explode, and you
or others could be injured. And,
the transmission or other parts
of the vehicle can
overheat. That could cause an engine
compartment fire or other damage. When you’re
stuck, spin the wheels as little as possible. Don’t
spin the wheels above
35 mph (55 km/h) as shown
on the speedometer.
5-39

When to Check
Check your tires once a month or more.
uon’t forget your compact spare tire. It should be at
60 psi (420 kPa).
How to Check
Use a good quality pocket-type gage to check tire
pressure.
You can’t tell if your tires are properly inflated
simply by looking at them. Radial tires may
look
properly inflated even when they’re underinflated.
Be sure to put the valve caps back on the valve
stems. They help prevent leaks by keeping out dirt
and moisture.
Tire Inspection and Rotation
Tires should be rotated every 6,000 to 8,000 miles
(10 000 to 13 000 km). Any time you notice unusual
wear, rotate your tires as soon as possible and check
wheel alignment. Also check for damaged tires or
wheels. See “When It’s
Time for New Tires” and
“Wheel Replacement’’ later in this section for
more information. The
purpose
of regular rotation is to achieve more
uniform wear for all tires on the vehicle. The first
rotation
is the most important. See “Scheduled
Maintenance Services” in the Index for scheduled
rotation intervals.
If you don’t have P245/5OZR16 or P275/40ZR17
Goodyear Eagle GS-C tires, use the rotation pattern
shown above for your tires.
6-51

If you have P245/50ZRl6 or P27940ZR17 Goodyear
Eagle
GS-C tires, they must roll in a certain direction
for the best overall performance. The direction is shown
by an arrow on the sidewall. Because these tires are
directional, they should be rotated
as shown here. These
tires should
only be moved from front to rear and rear to
front on the same side of the vehicle.
Don’t include the compact spare tire in your tire
rotation.
After the tires
have been rotated, adjust the front and
rear inflation pressures as shown on the Tire-Loading
Information label. Make
certain that all wheel nuts
are properly tightened. See “Wheel Nut Torque” in
the Index.
I
Rust or dirt on a wheel, or on the pa; cJ to which
it is fastened, can make wheel nuts become loose
after a time.
The wheel could come off and caus’e
an accident.
When you change a wheel, remove
any rust or dirt frolm places where the wheel
attaches to the vehicle.
In an emergency, you can
use
a cloth or a paper towel to do this; but be
sure
to use a scraper or wire brush later, if you
need to,
to get all the rust or dirt off. (See
“Changing a Flat Tire” in the Index.)
6-52