clock PONTIAC G5 2010 Owner's Manual

If the vehicle has an accessory power outlet, do not
use the cigarette lighter.
If the vehicle only has a cigarette lighter, use the
cigarette lighter.
Do not pinch the power plug cord in the door or
window.
7. Start the vehicle. The vehicle must be running while using the air compressor.
8. Press the on/off (D) button to turn the tire sealant and compressor kit on.
The compressor will inject sealant and air into
the tire.
The pressure gage (E) will initially show a high
pressure while the compressor pushes the sealant
into the tire. Once the sealant is completely
dispersed into the tire, the pressure will quickly drop
and start to rise again as the tire inflates with air only.
9. Inflate the tire to the recommended inflation pressure using the pressure gage (E). The
recommended inflation pressure can be found
on the Tire and Loading Information label. See
Ination - Tire Pressure on page 6-55 .
The pressure gage (E) may read higher than the
actual tire pressure while the compressor is on. Turn
the compressor off to get an accurate pressure
reading. The compressor may be turned on/off until
the correct pressure is reached. Notice:
If the recommended pressure cannot be
reached after approximately 25 minutes, the vehicle
should not be driven farther. The tire is too
severely damaged and the tire sealant and
compressor kit cannot inate the tire. Remove the
power plug from the accessory power outlet
and unscrew the inating hose from the tire valve.
See Roadside Assistance Program on page 8-7 .
10. Press the on/off button (D) to turn the tire sealant and compressor kit off.
The tire is not sealed and will continue to
leak air until the vehicle is driven and the
sealant is distributed in the tire, therefore,
Steps 11 through 17 must be done immediately
after Step 10.
Be careful while handling the tire sealant and
compressor kit as it could be warm after usage.
11. Unplug the power plug (C) from the accessory power outlet in the vehicle.
12. Turn the sealant/air hose (F) counterclockwise to remove it from the tire valve stem.
13. Replace the tire valve stem cap.
14. Replace the sealant/air hose (F), and the power plug (C) back in their original location.
6-75

Using the Tire Sealant and Compressor
Kit without Sealant to Inate a Tire
(Not Punctured)
To use the air compressor to inflate a tire with air only
and not sealant:
Always do a safety check first. SeeIf a Tire Goes Flat
on page 6-70.
1. Remove the tire sealant and compressor kit from its storage location. See Tire Sealant and Compressor
Kit Storage on page 6-79 .
2. Unlock the air only hose (F) from the sealant canister (B) by pulling up on the lever. 3. Pull the air only hose (F) from the sealant
canister (B).
4. Remove the power plug (C) from the air compressor (A).
5. Place the kit on the ground. Make sure the tire valve stem is positioned close to
the ground so the hose will reach it.
6. Remove the tire valve stem cap by turning it counterclockwise.
7. Attach the air only hose (F) onto the tire valve stem and press the lever down to secure it.
8. Plug the power plug (C) into the accessory power outlet in the vehicle. Unplug all items from other
accessory power outlets. See Accessory Power
Outlet(s) on page 4-13 .
If the vehicle has an accessory power outlet, do not
use the cigarette lighter.
If the vehicle only has a cigarette lighter, use the
cigarette lighter.
Do not pinch the power plug cord in the door or
window.
9. Start the vehicle. The vehicle must be running while using the air compressor.
10. Press the on/off (D) button to turn the compressor on.
The compressor will inflate the tire with air only.
6-77

11. Inflate the tire to the recommended inflationpressure using the pressure gage (E). The
recommended inflation pressure can be found on
the Tire and Loading Information label. See
Ination - Tire Pressure on page 6-55 .
The pressure gage (E) may read higher than the
actual tire pressure while the compressor is on. Turn
the compressor off to get an accurate reading.
The compressor may be turned on/off until
the correct pressure is reached.
12. Press the on/off button (D) to turn the tire sealant and compressor kit off.
Be careful while handling the tire sealant and
compressor kit as it could be warm after usage.
13. Unplug the power plug (C) from the accessory power outlet in the vehicle.
14. Disconnect the air only hose (F) from the tire valve stem, by turning it counterclockwise, and replace
the tire valve stem cap.
15. Replace the air only hose (F) and the power plug (C) back in its original location.
16. Place the equipment in the original storage location in the vehicle.Removal and Installation of the Sealant
Canister
To remove the sealant canister:
1. Unlock the air only hose (F) from the sealant canister (B) by pulling up on the lever.
2. Pull the air only hose (F) from the sealant canister (B).
3. Unwrap the sealant/air hose (F) from the compressor (A).
6-78

4. Turn the sealant canister (B) so the inflator fillinghose is aligned with the slot in the compressor.
5. Lift the sealant canister (B) from the compressor and replace with a new sealant canister. See your
dealer/retailer for more information. To install a new sealant canister:
1. Align the sealant/air hose (F) with the slot in the air compressor.
2. Push the sealant canister (B) down and turn it clockwise.
3. Wrap the sealant/air hose (F) around the air compressor channel to stow it in its original location.
4. Push the air compressor inflator hose (F) onto the sealant canister inlet and push the lever down.
Tire Sealant and Compressor Kit
Storage
The tire sealant and compressor kit is located in the
trunk.
1. Open the trunk. See Trunk on page 3-11.
2. Lift the trunk liner.
6-79

You will need to turn the plastic wheel nut
counterclockwise to loosen the wheel wrench from
the jack.Press the button and then pull on the end of the wheel
wrench to extend the handle.
6-85

Removing the Flat Tire and
Installing the Spare Tire
1. Do a safety check before preceding. SeeChanging
a Flat Tire on page 6-80.
2. If your vehicle has plastic wheel covers, use the wheel wrench to loosen the plastic wheel nut caps.
Once you have loosened the plastic wheel nut caps
with the wheel wrench, you can finish loosening
them with your fingers. The plastic nut caps do not
come off.
3. If necessary, use the flat end of the wheel wrench to pry along the edge of the wheel cover until it
comes off.
Store the wheel cover in the trunk until you have
the flat tire repaired or replaced. 4. Turn the wheel wrench counterclockwise to loosen
all the wheel nuts. Do not remove them yet.
Notice: Make sure that the jack lift head is in the
correct position or you may damage your vehicle.
The repairs would not be covered by your warranty.
6-86

{WARNING:
Raising your vehicle with the jack improperly
positioned can damage the vehicle and even make
the vehicle fall. To help avoid personal injury and
vehicle damage, be sure to fit the jack lift head into
the proper location before raising the vehicle.
8. Turn the jack handle clockwise to raise the vehicle. Raise the vehicle far enough off the ground so
there is enough room for the compact spare tire to
fit under the vehicle. 9. Remove all of the
wheel nuts.
{WARNING:
Rust or dirt on a wheel, or on the parts to which it
is fastened, can make wheel nuts become loose
after time. The wheel could come off and cause an
accident. When changing a wheel, remove any rust
WARNING: (Continued)
6-88

WARNING: (Continued)
or dirt from places where the wheel attaches to
the vehicle. In an emergency, use a cloth or a
paper towel to do this; but be sure to use a
scraper or wire brush later, if needed, to get all
the rust or dirt off. SeeChanging a Flat Tire on
page 6-80.
10. Remove any rust or dirtfrom the wheel bolts,
mounting surfaces, and
spare wheel. 11. Place the compact spare tire on the wheel-mounting
surface.{WARNING:
Never use oil or grease on bolts or nuts because
the nuts might come loose. The vehicle’s wheel
could fall off, causing a crash.
12. Reinstall the wheel nuts with the rounded end of the nuts toward the wheel. Tighten each nut
clockwise by hand until the wheel is held against
the hub.
13. Lower the vehicle by turning the jack handle counterclockwise. Lower the jack completely.
6-89

Audio System................................................. 4-49
Audio Steering Wheel Controls ......................4-82
Radio Reception .......................................... 4-83
Setting the Clock ......................................... 4-50
Theft-Deterrent Feature ................................4-81
XM™ Satellite Radio Antenna System ............4-84
Audio System(s) ............................................. 4-51
Automatic Door Lock ......................................... 3-9
Automatic Transmission Fluid .......................................................... 6-19
Operation ................................................... 3-24
B
Back-Up Lamps - Ambulance Body
Bulb Replacement ....................................... 6-45
Battery .......................................................... 6-33
Electric Power Management ..........................4-12
Run-Down Protection ................................... 4-13
Belt Routing, Engine ....................................... 7-13
Bluetooth
®..................................................... 4-71
Brake Emergencies ................................................ 5-5
Brakes .......................................................... 6-29
Antilock ....................................................... 5-4
Parking ...................................................... 3-29
System Warning Light .................................. 4-26Braking
........................................................... 5-3
Braking in Emergencies ..................................... 5-5
Break-In, New Vehicle ..................................... 3-19
Bulb Replacement ........................................... 6-47
Back-Up Lamps - Ambulance Body ................6-45
Center High-Mounted Stoplamp (CHMSL) ........6-43
Fog Lamps ................................................. 4-11
Halogen Bulbs ............................................ 6-41
Headlamp Aiming ........................................ 6-38
Headlamps ................................................. 6-41
Headlamps, Front Turn Signal, Sidemarker, and Parking Lamps .................................. 6-42
License Plate Lamps .................................... 6-46
Taillamps and Turn Signal Lamps ..................6-44
Taillamps, Turn Signal, Stoplamps and Back-up Lamps ........................................ 6-44
Buying New Tires ........................................... 6-64
C
California
Perchlorate Materials Requirements ................. 6-4
Warning ....................................................... 6-4
California Fuel .................................................. 6-6
Canadian Owners ............................................... iii
Capacities and Specifications ..........................6-109
2

Carbon MonoxideEngine Exhaust ........................................... 3-33
Trunk ......................................................... 3-11
Winter Driving ............................................. 5-21
Care of Safety Belts ................................................ 6-96
CD, MP3 ....................................................... 4-63
Center Console Storage ................................... 3-36
Center High-Mounted Stoplamp (CHMSL) ...........6-43
Chains, Tire ................................................... 6-70
Charging System Light .................................... 4-25
Check Engine Lamp .............................................. 4-30
Checking Things Under the Hood ......................6-10
Chemical Paint Spotting .................................6-100
Child Restraints Infants and Young Children ...........................2-35
Lower Anchors and Tethers for Children ..........2-43
Older Children ............................................. 2-32
Securing a Child Restraint in a Rear Seat Position .................................................. 2-49
Securing a Child Restraint in the Right Front Seat Position ........................................... 2-52
Systems ..................................................... 2-39
Where to Put the Restraint ...........................2-41
Cigarette Lighter ............................................. 4-14
Circuit Breakers ............................................ 6-103Cleaning
Aluminum or Chrome-Plated Wheels ..............6-99
Exterior Lamps/Lenses ................................. 6-97
Fabric/Carpet .............................................. 6-95
Finish Care ................................................. 6-98
Instrument Panel, Vinyl, and Other Plastic Surfaces ................................................. 6-96
Interior ....................................................... 6-94
Leather ...................................................... 6-96
Tires ........................................................ 6-100
Underbody Maintenance .............................6-100
Washing Your Vehicle ................................... 6-97
Weatherstrips .............................................. 6-97
Windshield

and Wiper Blades ........................6-98
Climate Control System ................................... 4-14
Outlet Adjustment ........................................ 4-17
Climate Controls ............................................. 1-14
Clock, Setting ................................................. 4-50
Clutch, Hydraulic ............................................. 6-19
Collision Damage Repair .................................. 8-11
Compact Spare Tire ........................................ 6-93
Compressor Kit, Tire Sealant ............................6-72
Content Theft-Deterrent .................................... 3-15
Control of a Vehicle .......................................... 5-3
Convenience Net ............................................ 3-36
Coolant Engine ....................................................... 6-24
Engine Temperature Warning Light .................4-29
3