keyless PONTIAC G5 2010 Owner's Manual

EXT (Exterior) LIGHTS
If your vehicle has Remote Keyless Entry (RKE), this
feature, which allows the vehicle’s exterior perimeter
lighting to turn on each time the unlock button on the RKE
transmitter is pressed, can be enabled or disabled. When
EXT LIGHTS appears on the display, press and hold the
reset button for at least one second to scroll through the
available settings:
OFF:The exterior perimeter lighting will not turn on
when the unlock button on the RKE transmitter is
pressed.
ON (default): The exterior perimeter lighting will turn
on when the unlock button on the RKE transmitter
is pressed.
See Remote Keyless Entry (RKE) System Operation on
page 3-3 for more information.
To select a setting and move on to the next feature,
press the information button while the desired setting is
displayed on the DIC.
LANGUAGE
This feature allows you to select the language in which
the DIC will display. When LANGUAGE appears on
the display, press and hold the reset button for at least
one second to scroll through the available settings:
ENGLISH (default): All messages will appear in
English.
FRENCH: All messages will appear in French.
SPANISH: All messages will appear in Spanish.
GERMAN: All messages will appear in German.
To select a setting and exit out of the personalization
menu mode, press the information button while the
desired setting is displayed on the DIC.
Exiting Personalization Menu
The personalization menu will be exited when any of the
following conditions occur:
•A ten second time period has elapsed.
•The ignition is turned off.
•The end of the personalization menu list is reached.
4-48

California Proposition 65 Warning
Most motor vehicles, including this one, contain and/or
emit chemicals known to the State of California to
cause cancer and birth defects or other reproductive
harm. Engine exhaust, many parts and systems, many
fluids, and some component wear by-products
contain and/or emit these chemicals.
California Perchlorate Materials
Requirements
Certain types of automotive applications, such as
airbag initiators, seat belt pretensioners, and lithium
batteries contained in remote keyless transmitters,
may contain perchlorate materials. Special handling
may be necessary. For additional information, see
www.dtsc.ca.gov/hazardouswaste/perchlorate.
Doing Your Own Service Work
{WARNING:
You can be injured and the vehicle could be
damaged if you try to do service work on a vehicle
without knowing enough about it.
•Be sure you have sufficient knowledge,
experience, the proper replacement parts, and
tools before attempting any vehicle
maintenance task.
•Be sure to use the proper nuts, bolts, and
other fasteners. English and metric fasteners
can be easily confused. If the wrong fasteners
are used, parts can later break or fall off. You
could be hurt.
If doing some of your own service work, use the proper
service manual. It tells you much more about how to
service the vehicle than this manual can. To order
the proper service manual, see Service Publications
Ordering Information on page 8-15 .
This vehicle has an airbag system. Before attempting to
do your own service work, see Servicing Your
Airbag-Equipped Vehicle on page 2-69 .
6-4

TPMS Sensor Matching Process
Each TPMS sensor has a unique identification code.
Any time you replace one or more of the TPMS sensors
or rotate the vehicle’s tires, the identification codes need
to be matched to the new tire/wheel location. The sensors
are matched, to the tire/wheel locations, in the following
order: driver side front tire, passenger side front tire,
passenger side rear tire, and driver side rear tire using a
TPMS diagnostic tool. See your dealer/retailer for
service.
The TPMS sensors can also be matched to each
tire/wheel position by increasing or decreasing the tire’s
air pressure. When increasing the tire’s pressure, do
not exceed the maximum inflation pressure indicated on
the tire’s sidewall. To decrease the tire’s air-pressure
use the pointed end of the valve cap, a pencil-style
air pressure gage, or a key.
You have two minutes to match each tire and wheel
position. If it takes longer than two minutes to match any
tire and wheel position, the matching process stops
and you need to start over.
TPMS Matching Process for Vehicles
with Remote Keyless Entry (RKE)
1. Set the parking brake.
2. Turn the ignition switch to ON/RUN with theengine off.
3. Press and hold the Remote Keyless Entry (RKE) transmitter’s lock and unlock buttons, at the same
time, for about five seconds to start the TPMS learn
mode. The horn sounds twice indicating the
TPMS receiver is ready and in learn mode.
4. Start with the driver side front tire. The driver side front turn signal also comes on to indicate that
corner’s sensor is ready to be learned.
5. Remove the valve cap from the tire’s valve stem. Activate the TPMS sensor by increasing or
decreasing the tire’s air pressure for about
eight seconds. The horn chirp, can take up to
30 seconds to sound. It chirps one time and then all
the turn signals flash one time to confirm the sensor
identification code has been matched to the tire/
wheel position.
6. The passenger side front turn signal comes on to indicate that corner sensor is ready to be learned.
Proceed to the passenger side front tire and
repeat the procedure in Step 5.
6-60

7. The passenger side rear turn signal comes on toindicate that corner sensor is ready to be learned.
Proceed to the passenger side rear tire and
repeat the procedure in Step 5.
8. The driver side rear turn signal comes on to indicate that corner sensor is ready to be learned.
Proceed to the driver side rear tire, and repeat
the procedure in Step 5.
9. After hearing the single horn chirp for the driver side rear tire, two additional horn chirps sound to
indicate the tire learning process is done. Turn
the ignition switch to LOCK/OFF.
If no tires are learned after entering the TPMS learn
mode, or if communication with the receiver
stops, or if the time limit has expired, turn the
ignition switch to LOCK/OFF and start over
beginning with Step 2.
10. Set all four tires to the recommended air pressure level as indicated on the Tire and Loading
Information label.
11. Put the valve caps back on the valve stems.TPMS Matching Process for Vehicles
without Remote Keyless Entry (RKE)
1. Set the parking brake.
2. Turn the ignition switch to ON/RUN with the engine off.
3. Using the Driver Information Center (DIC), press the INFO and Set/Reset buttons at the same time
for about one second. Then press and release
the INFO button until the TIRE LEARN? message
displays.
4. Press and hold the Set/Reset DIC button for approximately three seconds to start the TPMS
learn mode. The horn sounds twice to indicate the
TPMS receiver is ready and the TIRE LEARN
ON message displays. The driver side front turn
signal also comes on to indicate that corner sensor
is ready to be learned.
5. Start with the driver side front tire.
6. Remove the valve cap from the tire’s valve stem. Activate the TPMS sensor by increasing or
decreasing the tire’s air pressure for about
eight seconds. The horn chirp, can take up to
30 seconds to sound. It chirps one time and then all
the turn signals flash one time to confirm the sensor
identification code has been matched to the tire/
wheel position.
6-61

Horn ............................................................... 4-3
How to Wear Safety Belts Properly...................2-16
Hydraulic Clutch ............................................. 6-19
I
Ignition Positions............................................. 3-19
Indicator/Warning LIghts Enhanced Traction System (ETS) ...................4-27
Infants and Young Children, Restraints ...............2-35
Inflation - Tire Pressure ................................... 6-55
Instrument Panel Brightness .................................................. 4-11
Cluster ....................................................... 4-20
Introduction ...................................................... 7-2
J
Jump Starting ................................................. 6-34
K
Keyless Entry
Remote (RKE) System ................................... 3-3
Keyless Entry System ....................................... 3-3
Keys ............................................................... 3-2
L
Labeling, Tire Sidewall ..................................... 6-49
Lamps Back-Up ..................................................... 6-45
Daytime Running (DRL) ................................4-10
Dome ........................................................ 4-11
License Plate .............................................. 6-46
Malfunction Indicator .................................... 4-30
Mirror Reading ............................................ 4-12
Taillamps and Turn Signal .............................6-44
Lap-Shoulder Belt ........................................... 2-25
LATCH System for Child Restraints ...................2-43
Lighting Entry/Exit ................................................... 4-12
Lights ............................................................. 4-9
Airbag Readiness ........................................ 4-23
Antilock Brake System (ABS) Warning ............4-27
Brake System Warning ................................. 4-26
Charging System ......................................... 4-25
Engine Coolant Temperature Warning .............4-29
Enhanced Traction System (ETS) Active .........5-11
Flash-to-Pass ............................................... 4-5
Fog Lamps ................................................. 4-34
Highbeam On ............................................. 4-34
High/Low Beam Changer ................................ 4-5
Oil Pressure ............................................... 4-33
On Reminder .............................................. 4-10
7

ProgramCourtesy Transportation ................................8-10
Programmable Automatic Door Unlock ...............3-10
Proposition 65 Warning, California ....................... 6-4
R
Radio Frequency
Identification (RFID) ..................................... 8-18
Statement ................................................... 8-18
Radio(s) ........................................................ 4-51
Radios Reception ................................................... 4-83
Setting the Clock ......................................... 4-50
Theft-Deterrent ............................................ 4-81
Range Adjustment, Headlamps ........................... 2-7
Rear Door Security Locks ................................3-10
Rearview Mirrors ............................................. 3-35
Reclining Seatbacks .......................................... 2-4
Recommended Fluids and Lubricants .................7-10
Recreational Vehicle Towing .............................5-30
Reimbursement Program, GM Mobility ................. 8-7
Remote Keyless Entry (RKE) System .................. 3-3Remote Vehicle Start
........................................ 3-6
Removing the Flat Tire and Installing the Spare Tire .................................................. 6-86
Removing the Spare Tire and Tools ...................6-81
Replacement Bulbs ......................................... 6-47
Replacement Parts Maintenance ............................................... 7-12
Reporting Safety Defects Canadian Government .................................. 8-15
General Motors ........................................... 8-15
U.S. Government ......................................... 8-14
Restraint System Check Checking the Restraint Systems ....................2-71
Replacing Restraint System Parts After a Crash ..................................................... 2-72
Retained Accessory Power (RAP) ......................3-22
Ride Control Systems ....................................... 5-6
Electronic Stability (ESC) ................................ 5-6
Roadside Assistance Program ............................ 8-7
Rocking Your Vehicle to Get it Out ....................5-24
Roof Sunroof ...................................................... 3-37
Running the Vehicle While Parked .....................3-34
10