parking brake PONTIAC G6 2007 Owners Manual

Keys.............................................................. 99
Remote Keyless Entry System.................. 100
Remote Keyless Entry System
Operation............................................... 101
Doors and Locks........................................ 108
Door Locks................................................ 108
Power Door Locks..................................... 109
Door Ajar Reminder.................................. 109
Delayed Locking........................................ 110
Automatic Door Lock................................. 110
Programmable Automatic Door Unlock....... 111
Rear Door Security Locks......................... 111
Lockout Protection..................................... 112
Trunk........................................................ 113
Windows...................................................... 115
Power Windows........................................ 116
Sun Visors................................................ 117
Theft-Deterrent Systems............................. 118
Content Theft-Deterrent............................. 118
PASS-Key
®III+......................................... 120
PASS-Key®III+ Operation......................... 120Starting and Operating Your Vehicle......... 122
New Vehicle Break-In................................ 122
Ignition Positions....................................... 122
Retained Accessory Power (RAP)............. 124
Starting the Engine.................................... 125
Adjustable Throttle and Brake Pedal
(Automatic Transaxle)............................ 127
Engine Coolant Heater.............................. 128
Automatic Transaxle Operation.................. 129
Manual Transaxle Operation...................... 134
Parking Brake........................................... 135
Shifting Into Park (P)
(Automatic Transaxle)............................ 136
Shifting Out of Park (P)
(Automatic Transaxle)............................ 138
Parking Your Vehicle
(Manual Transaxle)................................ 138
Parking Over Things That Burn................. 139
Engine Exhaust......................................... 140
Running the Engine While Parked............. 141
Section 2 Features and Controls
97

Starting the Engine
To place the transaxle in the proper gear:
Automatic Transaxle
Move your shift lever to PARK (P) or
NEUTRAL (N). Your engine will not start in
any other position -- this is a safety feature.
To restart when you are already moving, use
NEUTRAL (N) only.
Notice:Shifting into PARK (P) with the vehicle
moving could damage the transaxle. Shift into
PARK (P) only when your vehicle is stopped.
Manual Transaxle
The shift lever should be in the NEUTRAL position
and the parking brake engaged. Hold the clutch
pedal to the oor and start the engine. Your vehicle
will not start if the clutch pedal is not all the way
down. That is a safety feature.
Starting Procedure
1. With your foot off the accelerator pedal, turn
the ignition key to START. When the engine
starts, let go of the key. The idle speed will
go down as your engine gets warm. Do not
race the engine immediately after starting it.
Operate the engine and transaxle gently to
allow the oil to warm up and lubricate all
moving parts.
Your vehicle has a Computer-Controlled
Cranking System. This feature assists in
starting the engine and protects components.
If the ignition key is turned to the START
position, and then released when the engine
begins cranking, the engine will continue
cranking for a few seconds or until the
vehicle starts. If the engine does not start
and the key is held in START for many
seconds, cranking will be stopped after
15 seconds to prevent cranking motor damage.
125

Instead of trying to list everything here, we ask that
you contact your dealer in the area where you will
be parking your vehicle. The dealer can give you
the best advice for that particular area.
Automatic Transaxle Operation
Your automatic transaxle has a shift lever located
on the console between the seats.
PARK (P):This position locks your front wheels.
It is the best position to use when you start
the engine because your vehicle cannot move
easily.
{CAUTION:
It is dangerous to get out of your vehicle
if the shift lever is not fully in PARK (P)
with the parking brake rmly set. Your
vehicle can roll.
Do not leave your vehicle when the engine
is running unless you have to. If you have
left the engine running, the vehicle can
move suddenly. You or others could be
injured. To be sure your vehicle will not
move, even when you are on fairly level
ground, always set your parking brake
and move the shift lever to PARK (P). See
Shifting Into Park (P) (Automatic Transaxle)
on page 136. If you are pulling a trailer, see
Towing a Trailer on page 296.
Make sure the shift lever is fully in PARK (P)
before starting the engine. Your vehicle has an
automatic transaxle shift lock control system.
SE ModelGT and GTP Models
129

You can use LOW (L) on very steep hills, or in deep
snow or mud. If the shift lever is put in LOW (L), the
transaxle will not shift into rst gear until the vehicle
is going slowly enough.
Notice:Driving in LOW (L) for more than
25 miles (40 km) or at speeds over 55 mph
(90 km/h) may damage the transaxle. Also,
shifting into LOW (L) at speeds above 65 mph
(105 km/h) can cause damage. Drive in
THIRD (3) or DRIVE (D) instead of LOW (L).
Notice:Spinning the tires or holding the
vehicle in one place on a hill using only the
accelerator pedal may damage the transaxle.
If you are stuck, do not spin the tires. When
stopping on a hill, use the brakes, or parking
brake to hold the vehicle in place.
MANUAL MODE (M):This position, available on
the GT/GTP models, allows you to change gears
similar to a manual transaxle. If your vehicle has
this feature, see Manual Shift Mode (MSM)
following.Manual Shift Mode (MSM)
(Automatic Transaxle)
To use this feature, do the following:
1. Move the shift lever from DRIVE (D) rearward
and then to the right into the MANUAL
MODE (M).
While driving in manual shift mode, the
transaxle will remain in the driver gear selected.
When coming to a stop in the manual position,
the vehicle will automaticaly shift to
FIRST (1) gear.
2. Press the shift level forward to upshift or
rearward to downshift.
The odometer display on the instrument panel
cluster will change from the vehicle’s mileage to
the letter M, for manual shift mode, and a number
indicating the requested gear range when
moving the shift lever forward or rearward. See
Speedometer and Odometer on page 194for more
information.
While using the MSM feature the vehicle will have
rmer shifting and sportier performance. You can
use this for sport driving or when climbing hills to
stay in gear longer or to downshift for more power
or engine braking.
132

Also, use REVERSE (R), along with the parking
brake, for parking your vehicle.
Once the shift lever is in REVERSE (R), the
ignition can be turned to OFF and the key
removed.
Parking Brake
To set the parking brake, pull up on the parking
brake handle. If the ignition is on, the brake system
warning light will come on. SeeBrake System
Warning Light on page 199.
To release the parking brake:
1. Hold the brake pedal down.
2. Pull the parking brake handle up until you can
press the release button.
3. Hold the release button in as you move the
brake handle all the way down.
Notice:Driving with the parking brake on can
overheat the brake system and cause premature
wear or damage to brake system parts. Verify
that the parking brake is fully released and the
brake warning light is off before driving.
If you are towing a trailer and you are parking on
a hill, seeTowing a Trailer on page 296.
GT and GTP Shown, SE Similar
135

Shifting Into Park (P)
(Automatic Transaxle)
{CAUTION:
It can be dangerous to get out of your
vehicle if the shift lever is not fully in
PARK (P) with the parking brake rmly
set. Your vehicle can roll. If you have left
the engine running, the vehicle can move
suddenly. You or others could be injured.
To be sure your vehicle will not move,
even when you are on fairly level ground,
use the steps that follow. If you are
pulling a trailer, seeTowing a Trailer on
page 296.Use the following procedure to shift into PARK (P):
1. Hold the brake pedal down with your right
foot and set the parking brake.
2. Move the shift lever into PARK (P) by holding
in the button on the shift lever and pushing
the lever all the way toward the front of
the vehicle.
3. Turn the ignition key to OFF.
4. Remove the key and take it with you. If you
can leave your vehicle with the ignition key in
your hand, your vehicle is in PARK (P).
136

Leaving Your Vehicle With the Engine
Running (Automatic Transaxle)
{CAUTION:
It can be dangerous to leave your vehicle
with the engine running. Your vehicle
could move suddenly if the shift lever is
not fully in PARK (P) with the parking
brake rmly set. And, if you leave the
vehicle with the engine running, it could
overheat and even catch re. You or
others could be injured. Do not leave
your vehicle with the engine running.
If you have to leave your automatic transaxle
vehicle with the engine running, be sure
your vehicle is in PARK (P) and your parking
brake is rmly set before you leave it. After you
have moved the shift lever into PARK (P), hold the
regular brake pedal down. Then, see if you can
move the shift lever away from PARK (P) without
rst pushing the button.If you can, it means that the shift lever was not
fully locked into PARK (P).
Torque Lock (Automatic Transaxle)
If you are parking on a hill and you do not shift your
automatic transaxle into PARK (P) properly, the
weight of the vehicle may put too much force on
the parking pawl in the transaxle. You may nd it
difficult to pull the shift lever out of PARK (P). This is
called torque lock. To prevent torque lock, set the
parking brake and then shift into PARK (P) properly
before you leave the driver’s seat. To nd out how,
see “Shifting Into Park (P)” previously in the section.
When you are ready to drive, move the shift lever
out of PARK (P) before you release the parking
brake.
If torque lock does occur, you may need to have
another vehicle push yours a little uphill to take
some of the pressure from the parking pawl in the
transaxle, so you can pull the shift lever out of
PARK (P).
137

Shifting Out of Park (P)
(Automatic Transaxle)
The automatic transaxle shift lock control system
locks the shift lever in PARK when the ignition is
in OFF. In addition, you have to fully apply your
regular brakes before you can shift from PARK (P)
when the ignition is in ON. SeeAutomatic
Transaxle Operation on page 129.
If you cannot shift out of PARK (P), ease pressure
on the shift lever and push the shift lever all the way
into PARK (P) as you maintain brake application.
Press the shift lever button and then move the shift
lever into the desired gear.
Parking Your Vehicle
(Manual Transaxle)
Before leaving your vehicle, fully press the clutch
pedal in, rmly apply the parking brake, and move
the shift lever into REVERSE (R). Once the shift
lever has been placed in REVERSE (R) with the
clutch pedal pressed in, you can turn the ignition
key to OFF, remove the key and release the clutch.
SeeManual Transaxle Operation on page 134.
138

Running the Engine While Parked
It is better not to park with the engine running. But if
you ever have to, here are some things to know.
{CAUTION:
Idling the engine with the climate control
system off could allow dangerous exhaust
into your vehicle. See the earlier caution
underEngine Exhaust on page 140.
Also, idling in a closed-in place can let
deadly carbon monoxide (CO) into your
vehicle even if the climate control fan is at
the highest setting. One place this can
happen is a garage. Exhaust — with
CO — can come in easily. NEVER park
in a garage with the engine running.
Another closed-in place can be a blizzard.
SeeWinter Driving on page 282.
{CAUTION:
It can be dangerous to get out of your
vehicle if the automatic transaxle shift
lever is not fully in PARK (P) with the
parking brake rmly set. Your vehicle can
roll. Do not leave your vehicle when the
engine is running unless you have to.
If you have left the engine running, the
vehicle can move suddenly. You or others
could be injured. To be sure your vehicle
will not move, even when it is on fairly
level ground, always set the parking brake
and move the automatic transaxle shift
lever to PARK (P), or the manual transaxle
shift lever to NEUTRAL.
Follow the proper steps to be sure your vehicle
will not move. If you have an automatic transaxle,
seeShifting Into Park (P) (Automatic Transaxle)
on page 136.
If you are parking on a hill and if you are pulling a
trailer, seeTowing a Trailer on page 296.
141

Lowering the Retractable Hardtop
Notice:Leaving the retractable hardtop down
and exposing the interior of your vehicle to
outdoor conditions may cause damage. Always
close the retractable hardtop if leaving your
vehicle outdoors.
Notice:Lowering the top if it is damp, wet, or
dirty can cause stains, mildew, and damage
to the inside of your vehicle. Dry off the
top before lowering it.
Notice:If you lower the retractable hardtop in
cold weather (0°F/−18°C or lower), you may
damage top components. Do not lower
the retractable hardtop in cold weather.
1. Park on a level surface and apply the parking
brake. Shift the automatic transaxle into
PARK (P). The vehicle must be in PARK (P),
and the engine must be running, or the ignition
turned to the ON position, to operate the
retractable hardtop.2. The trunk cargo cover must be fully closed,
and the trunk must be closed before lowering
the hardtop.
3. Make sure that nothing or no one is on or
around the hardtop. Make sure there is
nothing on top or in front of the cargo cover.
154