turn signal PONTIAC G6 2007 Owners Manual

The following functions may be available if your
vehicle has the RKE system.
/(Remote Vehicle Start):If your vehicle has
this feature, the engine may be started from outside
the vehicle using the RKE transmitter. See “Remote
Vehicle Start” later in this section for more detailed
information.
Q(Lock):Press the lock button to lock all the
doors. The interior lamps will turn off after all of the
doors are closed. If enabled through the Driver
Information Center (DIC), the remote lock feedback
can be programmed to have the horn chirp and/or
the turn signals ash when the RKE transmitter is
used to lock the vehicle’s doors. See “LOCK
HORN” and “LIGHT FLASH” underDIC Vehicle
Personalization on page 216for more information.
Pressing the lock button may also arm the content
theft-deterrent system. SeeContent Theft-Deterrent
on page 118.
K(Unlock):Press the unlock button to unlock the
driver’s door. If the button is pressed again within
ve seconds, all remaining doors will unlock.
The interior lamps will turn on and stay on for
20 seconds or until the ignition is turned on. If
enabled through the DIC, the remote unlock
feedback can be programmed to have the horn
chirp and/or the turn signals ash when the RKE
transmitter is used to unlock the vehicle’s doors.
See “UNLOCK HORN” and “LIGHT FLASH” under
DIC Vehicle Personalization on page 216for more
information.
If enabled through the DIC, and it is dark enough
outside, the vehicle’s high-beam headlamps,
parking lamps, and back-up lamps will turn on each
time the unlock button on the transmitter is pressed.
These exterior lamps will stay on for 20 seconds,
or until a door is opened. See “EXT (Exterior)
LIGHTS” underDIC Vehicle Personalization on
page 216for additional information.
Pressing the unlock button on the RKE transmitter
will disarm the content theft-deterrent system. See
Content Theft-Deterrent on page 118.
102

V(Remote Trunk Release):Press and hold
this button for approximately one second to open
the trunk. The trunk will open using the transmitter
when the vehicle speed is less than 2 mph (3 km/h),
when the ignition is off, or when the vehicle shift
lever is in PARK (P), if your vehicle has an
automatic transaxle.
L(Vehicle Locator/Panic Alarm):This button
may be used to locate your vehicle. When you
press and release this button, the horn will sound
three times and the headlamps and turn signals will
ash three times. Press and hold the button for
approximately three seconds to sound the panic
alarm. The horn will sound and the headlamps and
turn signals will ash for 30 seconds. Press the
button again to cancel the panic alarm.
Matching Transmitter(s) to Your
Vehicle
Each RKE transmitter is coded to prevent another
transmitter from unlocking your vehicle. If a
transmitter is lost or stolen, a replacement can be
purchased through your dealer. Remember to
bring any additional transmitters so they can also
be re-coded to match the new transmitter.
Once your dealer has coded the new transmitter,
the lost transmitter will not unlock your vehicle.
Each vehicle can have up to four transmitters
matched to it.
103

/(Remote Start):If your vehicle has the remote
start feature, the RKE transmitter will have a button
with this symbol on it.
To start the vehicle using the remote start feature,
do the following:
1. Aim the transmitter at the vehicle.
2. Press and release the transmitter’s lock
button, then immediately press and hold
the transmitter’s remote start button until
the vehicle’s turn signal lamps ash.
3. When the vehicle starts, the parking lamps
will turn on and remain on while the engine
is running.
The engine will shut off automatically after
10 minutes, unless a time extension has been
done or the vehicle’s key is inserted into
the ignition switch and turned to ON.
If you enter the vehicle after a remote start,
and the engine is still running, insert the
key into the ignition switch and turn to ON
to drive the vehicle.4. To manually shut off a remote start, do any of
the following. The parking lamps will turn off
to indicate the engine is off.
Aim the RKE transmitter at the vehicle and
press and release the remote start button.
Turn on the hazard warning ashers.
Turn the ignition switch ON and then OFF.
Your vehicle’s engine can be started two times, per
ignition cycle, using the transmitter’s remote start
feature. If only one remote start procedure has
been done, since last driving the vehicle, or
resetting the remote start system, the engine may
be started again remotely by following the remote
start procedure a second time.
If the remote start procedure is used again before
the rst 10 minute time frame has ended, the
rst 10 minutes will immediately expire and
the second 10 minute time frame will start.
106

Delayed Locking
This feature lets the driver to delay the locking of
the vehicle. It will not operate with the key in
the ignition. SeeLockout Protection on page 112.
Press the driver’s power door lock switch or the
Remote Keyless Entry (RKE) transmitter lock
button once. With the key removed from the ignition
and the driver’s door open, the following will occur:
Three chimes will sound to signal the delay.
All doors will lock and the turn signals will ash
once ve seconds after the last door has been
closed.
The horn will chirp if the horn chirp feature is
enabled. SeeDIC Operation and Displays on
page 209.
If a door is opened before the ve seconds has
ended, the doors will not lock until ve seconds
after all doors are closed.
If the power door lock switch or the transmitter
lock button is pressed twice when leaving
the vehicle, the doors will lock immediately.
If the power door unlock switch or the transmitter
unlock button is pressed, the doors will unlock
immediately and do not lock automatically after
the doors are closed.This feature is turned on at the factory but may be
turned off through the Driver Information Center
(DIC). SeeDIC Vehicle Personalization on
page 216.
Automatic Door Lock
Your vehicle is programmed at the factory to lock all
doors automatically when the following are met:
All doors are closed.
The ignition is on.
The shift lever is moved out of PARK (P) for
vehicles with an automatic transaxle.
The vehicle speed is greater than 5 mph
(8 km/h) for vehicles with a manual transaxle.
This feature cannot be disabled.
If someone needs to exit the vehicle once the
doors are locked, have that person use the manual
lock knob or power door unlock switch.
110

Instrument Panel Overview........................ 164
Hazard Warning Flashers.......................... 166
Other Warning Devices............................. 166
Horn.......................................................... 167
Tilt Wheel.................................................. 167
Turn Signal/Multifunction Lever.................. 168
Turn and Lane-Change Signals................. 168
Headlamp High/Low-Beam Changer.......... 169
Flash-to-Pass............................................ 169
Windshield Wipers..................................... 169
Windshield Washer.................................... 171
Cruise Control........................................... 171
Headlamps................................................ 174
Headlamps on Reminder........................... 175
Headlamps Off in PARK (P)...................... 175
Delayed Headlamps.................................. 176
Daytime Running Lamps (DRL)................. 176
Automatic Headlamp System..................... 177
Fog Lamps................................................ 178
Instrument Panel Brightness...................... 178
Courtesy Lamps........................................ 178
Dome Lamp.............................................. 179
Entry/Exit Lighting...................................... 179
Parade Dimming........................................ 180Overhead Console Reading Lamps........... 180
Trunk Lamp............................................... 180
Battery Run-Down Protection..................... 181
Accessory Power Outlet(s)........................ 181
Climate Controls......................................... 182
Climate Control System............................. 182
Automatic Climate Control System............. 187
Outlet Adjustment...................................... 191
Warning Lights, Gages, and Indicators..... 192
Instrument Panel Cluster........................... 193
Speedometer and Odometer...................... 194
Trip Odometer........................................... 194
Tachometer............................................... 194
Safety Belt Reminder Light........................ 195
Passenger Safety Belt Reminder Light....... 195
Airbag Readiness Light............................. 196
Passenger Airbag Status Indicator............. 197
Charging System Light.............................. 199
Brake System Warning Light..................... 199
Anti-Lock Brake System Warning Light...... 200
Traction Control System (TCS)
Warning Light........................................ 201
Traction Control System Active Light......... 201
Section 3 Instrument Panel
161

The main components of your instrument panel are the following:
A. Side Air Outlets. SeeOutlet Adjustment on
page 191.
B. Side Window Outlets. SeeOutlet Adjustment
on page 191.
C. Turn Signal/Multifunction Lever. SeeTurn
Signal/Multifunction Lever on page 168.
D. Cruise Controls (If Equipped). SeeCruise
Control on page 171.
E. Instrument Panel Cluster. SeeInstrument
Panel Cluster on page 193.
F. Audio Steering Wheel Controls (If Equipped).
SeeAudio Steering Wheel Controls on
page 248.
G. Windshield Wiper and Washer Lever. See
Windshield Wipers on page 169andWindshield
Washer on page 171.
H. Ignition Switch. SeeIgnition Positions on
page 122.
I. Center Air Outlets. SeeOutlet Adjustment on
page 191.J. Hazard Warning Flashers Button. SeeHazard
Warning Flashers on page 166.
K. Audio System. SeeAudio System(s) on
page 219.
L. Adjustable Pedal Buttons (If Equipped). See
Adjustable Throttle and Brake Pedal (Automatic
Transaxle) on page 127.
M. Instrument Panel Brightness Control. See
Instrument Panel Brightness on page 178.
N. Fog Lamps (If Equipped). SeeFog Lamps on
page 178.
O. Hood Release Handle. SeeHood Release on
page 317.
P. Horn. SeeHorn on page 167.
Q. Climate Control System. SeeAutomatic
Climate Control System on page 187orClimate
Control System on page 182.
R. Shift Lever. SeeAutomatic Transaxle Operation
on page 129orManual Transaxle Operation
on page 134.
165

S. Accessory Power Outlet. SeeAccessory Power
Outlet(s) on page 181.
T. Traction Control System Button (If Equipped),
Enhanced Traction System Button (If
Equipped), and/or StabiliTrak
®(If Equipped).
SeeTraction Control System (TCS) on
page 262orEnhanced Traction System (ETS)
on page 263and/orStabiliTrak
®System on
page 265.
U. Passenger Airbag Status Indicator. See
Passenger Airbag Status Indicator on page 197.
V. Glove Box. SeeGlove Box on page 150.
Hazard Warning Flashers
Your hazard warning ashers let you warn others.
They also let police know you have a problem.
Your front and rear turn signal lamps will ash on
and off.The hazard warning
asher button is located
in the center of the
instrument panel.
Your hazard warning ashers work no matter what
position your key is in, and even if the key is
not in the ignition switch.
Press the button to make the front and rear turn
signal lamps ash on and off. Press the button
again to turn the ashers off.
When the hazard warning ashers are on, your
turn signals will not work.
Other Warning Devices
If you carry reective triangles, you can set them
up at the side of the road about 300 feet
(100 m) behind your vehicle.
166

Turn Signal/Multifunction Lever
The lever on the left side of the steering column
includes the following:
GTurn and Lane-Change Signals. See
Turn and Lane-Change Signals on page 168.
23Headlamp High/Low-Beam Changer.
SeeHeadlamp High/Low-Beam Changer on
page 169.
Flash-to-Pass. SeeFlash-to-Pass on
page 169.
OExterior Lamp Control. SeeHeadlamps on
page 174.
Turn and Lane-Change Signals
The turn signal has two upward (for right) and
two downward (for left) positions. These positions
allow you to signal a turn or a lane change.
To signal a turn, move the lever all the way up or
down. When the turn is nished, the lever will
return automatically.
An arrow on the
instrument panel cluster
will ash in the
direction of the turn or
lane change.
To signal a lane change, just raise or lower the
lever until the arrow starts to ash. Hold it
there until you complete your lane change. The
lever will return by itself when you release it.
As you signal a turn or a lane change, if the arrows
ash rapidly, a signal bulb may be burned out
and other drivers won’t see your turn signal.
168

If a bulb is burned out, replace it to help avoid an
accident. If the arrows don’t go on at all when
you signal a turn, check for burned-out bulbs and
then check the fuse. SeeFuses on page 415.
Headlamp High/Low-Beam Changer
To change the headlamps from low beam to
high beam, push the turn signal/multifunction lever
away from you.
When the high beams
are on, a light on the
instrument panel cluster
also will be on if the
ignition is on.
To change the headlamps from high beam to low
beam, pull the turn signal lever toward you.
Flash-to-Pass
This feature lets you use your high-beam
headlamps to signal a driver in front of you that
you want to pass.
To use it, pull the turn signal/multifunction lever
toward you until the high-beam headlamps
come on, then release the lever to turn them off.
Windshield Wipers
Use this lever, located on the right side of the
steering wheel, to operate the windshield wipers.
169

Delayed Headlamps
The delayed headlamps feature will continue to
illuminate the headlamps for 20 seconds after the
key is turned to OFF, then the headlamps will
automatically turn off.
To override the 20 second delayed headlamp
feature while it is active turn the turn signal/
multifunction lever up one position and then back
to AUTO.
Daytime Running Lamps (DRL)
Daytime Running Lamps (DRL) can make it easier
for others to see the front of your vehicle during
the day. DRL can be helpful in many different
driving conditions, but they can be especially
helpful in the short periods after dawn and before
sunset. Fully functional daytime running lamps
are required on all vehicles rst sold in Canada.
The vehicle has a light sensor on top of the
instrument panel. Make sure it is not covered, or
the head lamps will be on when not needed.The DRL system will make your low-beam
headlamps come on at a reduced brightness when
the following conditions are met:
The ignition is on.
The exterior lamps control is in AUTO.
The exterior lamps control is in the parking
lamps only position (this applies only to
vehicles that are rst sold in Canada).
The light sensor detects daytime light.
The parking brake is released (manual
transaxle) or the vehicle is not in PARK
(automatic transaxle).
When the DRL system is on, the taillamps,
sidemarker lamps, parking lamps, and instrument
panel lights will not be illuminated unless you
have turned the exterior lamps control to
the parking lamp position.
As with any vehicle, you should turn on the
regular headlamp system when you need it.
176