brake light PONTIAC GRAND PRIX 2007 Owners Manual

Parking Brake
The parking brake is
located to the left of the
brake pedal near the
driver’s door. To set the
parking brake, hold
the regular brake pedal
down with the right
foot. Push down on the
parking brake pedal,
with the left foot.
To release the parking brake, hold the regular
brake pedal down with the right foot and push the
parking brake pedal with the left foot. When the
left foot is lifted, the parking brake pedal will lift to
the released position.
A warning chime will sound if the parking brake is
set, the ignition is on, and the shift lever is not
in PARK (P) or NEUTRAL (N).The brake light will also appear on the instrument
panel cluster when the parking brake is set. It will
stay on if the parking brake does not release fully.
The PARKING BRAKE ON message will also
appear in the Driver Information Center (DIC)
when the parking brake is set. SeeDIC Warnings
and Messages on page 200for more information.
Notice:Driving with the parking brake on
can overheat the brake system and cause
premature wear or damage to brake system
parts. Verify that the parking brake is fully
released and the brake warning light is
off before driving.
If the vehicle is towing a trailer and parked on a
hill, seeTowing a Trailer on page 324. That
section shows what to do rst to keep the trailer
from moving.
115

Instrument Panel Overview........................ 132
Hazard Warning Flashers.......................... 134
Other Warning Devices............................. 134
Horn.......................................................... 134
Tilt Wheel.................................................. 135
Turn Signal/Multifunction Lever.................. 135
Turn and Lane-Change Signals................. 136
Headlamp High/Low-Beam Changer.......... 137
Flash-to-Pass............................................ 137
Windshield Wiper Lever............................. 138
Cruise Control........................................... 140
Exterior Lamps.......................................... 144
Headlamps on Reminder........................... 145
Daytime Running Lamps (DRL)................. 145
Fog Lamps................................................ 146
Exterior Lighting Battery Saver.................. 146
Interior Lamps........................................... 146
Instrument Panel Brightness...................... 147
Courtesy Lamps........................................ 147
Dome Lamp.............................................. 147
Entry Lighting............................................ 148
Delayed Entry Lighting.............................. 148
Delayed Exit Lighting................................. 149
Front Reading Lamps................................ 149
Overhead Console Reading Lamps........... 149Rear Assist Handle Reading Lamps.......... 149
Electric Power Management...................... 150
Battery Run-Down Protection..................... 151
Head-Up Display (HUD)............................ 151
Accessory Power Outlet(s)........................ 156
Ashtray(s) and Cigarette Lighter................ 157
Climate Controls......................................... 157
Climate Control System............................. 157
Dual Automatic Climate Control System.... 162
Outlet Adjustment...................................... 166
Passenger Compartment Air Filter............. 166
Warning Lights, Gages, and Indicators..... 168
Instrument Panel Cluster........................... 169
Speedometer and Odometer...................... 170
Tachometer............................................... 171
Safety Belt Reminder Light........................ 171
Passenger Safety Belt Reminder Light....... 172
Airbag Readiness Light............................. 172
Passenger Airbag Status Indicator............. 173
Up-Shift Light............................................ 175
Brake System Warning Light..................... 176
Anti-Lock Brake System Warning Light...... 177
Low Tire Pressure Warning Light.............. 178
Section 3 Instrument Panel
129

The CRUISE SET message will also appear
briey on the Head-Up Display (HUD), if your
vehicle has one, when the cruise control lever is
pushed to the minus (set) or the plus
(resume/accelerate) positions.
A cruise control light will also appear on the
instrument panel cluster when the cruise control is
on. This light will disappear when the brakes
are applied or the cruise control is cancelled. It will
reappear when the set cruise speed is resumed.
The light will go out when the cruise control is
turned off. SeeCruise Control Light on page 185.
Resuming a Set Speed
Once you are going about 25 mph (40 km/h) or
more, you can move the cruise control switch
briey from on to resume/accelerate.
Your vehicle will go back up to your previously
chosen speed and stay there.
If you hold the switch at resume/accelerate the
vehicle will keep going faster until you release the
switch or apply the brake. Do not hold the
switch at resume/accelerate, unless you want the
vehicle to go faster.
Increasing Speed While Using
Cruise Control
There are two ways to go to a higher speed:
Use the accelerator pedal to get to the higher
speed. Press the set button at the end of the
lever, then release the button and the
accelerator pedal. You will now cruise at the
higher speed. If the accelerator pedal is
held longer than 60 seconds, cruise control
will turn off.
Move the cruise switch from on to resume/
accelerate. Hold it there until you get up to the
speed desired, and then release the switch.
To increase the vehicle speed in very small
amounts, move the switch briey to resume/
accelerate. Each time you do this, your vehicle
will go about 1 mph (1.6 km/h) faster.
The acceleration feature will only work after the
cruise control speed has been set by pushing the
cruise control set button.
142

Reducing Speed While Using
Cruise Control
There are two ways to reduce the vehicle’s speed
while using cruise control:
Press and hold the set button until you reach
the lower speed desired, then release it.
To slow down in very small amounts,
briey press the set button. Each time you do
this your vehicle will slow down about
one mph (1.6 km/h).
Passing Another Vehicle While Using
Cruise Control
Use the accelerator pedal to increase the vehicle’s
speed. When you take your foot off the pedal,
the vehicle will slow down to the cruise control
speed set earlier.
Using Cruise Control on Hills
How well the cruise control will work on hills
depends upon the vehicle’s speed, its load, and
the steepness of the hills. When going up
steep hills, the accelerator pedal might have to be
used in order to maintain the vehicle’s speed.
When going downhill, the brakes might have to be
applied, or the transaxle might have to be
shifted to a lower gear to keep the vehicle’s speed
down. Doing either of these things will take the
vehicle out of cruise. It may be better not to
use the cruise control if the brakes constantly have
to be applied, or the vehicle continuously needs
to be shifted to a lower gear.
Ending Cruise Control
There are two ways to turn off the cruise control:
Step lightly on the brake pedal
Move the cruise control switch to off
Erasing Speed Memory
When the cruise control or the ignition is turned
off, the cruise control set speed memory is erased.
143

Exterior Lamps
The exterior lamp control is located to the left of
the steering wheel on the multifunction lever.
O(Exterior Lamp Control):Turn the band with
this symbol on it to operate the exterior lamps.
The exterior lamp band has four positions:
O(Off):Turning the band to this position turns
off all lamps.
AUTO (Automatic):Turning the band to this
position sets the exterior lamps in automatic mode.
AUTO mode will turn the exterior lamps on and
off depending on how much light is available
outside the vehicle.To override AUTO mode, turn the control to off.
To reset to AUTO mode turn the control to exterior
lamps and then back to AUTO. Automatic mode
will also reset when your vehicle is turned off
and then back on again when the control is left in
the AUTO position.
;(Parking Lamp):Turning the band to this
position turns on the parking lamps together with
the following:
Sidemarker Lamps
Taillamps
License Plate Lamps
Instrument Panel Lights
The parking brake indicator light will come on and
stay on when the parking lamps are on with the
engine off and the ignition to ACC.
5(Headlamps):Turning the control to this
position turns on the headlamps, together with the
previously listed lamps and lights.
144

Headlamps on Reminder
A warning chime will sound if the vehicle’s ignition
is off and the driver’s door is opened when the
exterior lamp control is left on in either the
headlamp or parking lamp position.
Daytime Running Lamps (DRL)
Daytime Running Lamps (DRL) can make it easier
for others to see the front of your vehicle during
the day. DRL can be helpful in many different
driving conditions, but they can be especially
helpful in the short periods after dawn and before
sunset. Daytime running lamps are required to
function at all times on all vehicles rst sold
in Canada.
A light sensor on top of the instrument panel
makes the DRL work, so be sure it is not covered.
The DRL system will make the low-beam
headlamps come on at reduced brightness when
the following conditions are met:
The ignition is on.
The exterior lamps control is off.
The parking brake is released.While the DRL are on, only the vehicle’s low-beam
headlamps will be on at reduced brightness.
The turn signal, taillamps, sidemarker and other
lamps will not be on. The instrument panel cluster
will not be lit up either.
When it is dark enough outside, the DRL will turn
off and the vehicle’s headlamps and parking
lamps will turn on. The other lamps that come on
with the headlamps will also come on.
When it is bright enough outside, the headlamps
will go off and the DRL will come on.
To idle the vehicle with the DRL off, turn the
exterior lamp control off and then do one of the
following:
Turn the exterior lamp control to the parking
lamp position.
Turn the exterior lamp control to the headlamp
position.
Turn the exterior lamp control from AUTO to
off and back to AUTO.
This feature is not available for vehicles rst sold
in Canada.
145

Brake System Warning Light
The vehicle’s hydraulic brake system is divided
into two parts. If one part is not working, the other
part can still work and stop the vehicle. For
good braking, though, both parts should be
working well.
This light should come on briey when the ignition
key is turned to RUN. If it does not come on
then, have it xed so it will be ready to warn you if
there is a problem.When the ignition is on, the brake system warning
light will also come on when the parking brake
is set. The light will stay on if the parking
brake does not release fully. If it stays on after the
parking brake is fully released, it means the
vehicle has a brake problem.
The PARKING BRAKE ON message will also
appear in the Driver Information Center (DIC)
when the parking brake is set and the vehicle is
going faster than 5 mph. SeeDIC Warnings
and Messages on page 200for more information.
The brake warning light may also come on
when the brake uid is low. If this occurs, the
LOW BRAKE FLUID message will also appear in
the Driver Information Center (DIC). SeeDIC
Warnings and Messages on page 200for more
information.
If the brake warning light comes on while the
vehicle is being driven, pull off the road and stop
carefully. The brake pedal may be harder to
push, or it may go closer to the oor. It may also
take the vehicle longer to stop. If the light is
still on, have the vehicle towed for service. See
Towing Your Vehicle on page 322.
United StatesCanada
176

{CAUTION:
Your brake system may not be working
properly if the brake system warning light
is on. Driving with the brake system
warning light on can lead to an accident.
If the light is still on after you have pulled
off the road and stopped carefully, have
the vehicle towed for service.
Anti-Lock Brake System
Warning Light
If the vehicle has the
Anti-lock Brake System
(ABS), this light will
come on when the
engine is started and
may stay on for several
seconds. That is normal.If the ABS warning light comes on and stays on,
there may be a problem with the anti-lock
portion of the brake system. If the brake system
warning light is not on, the vehicle still has brakes,
but it does not have anti-lock brakes. SeeBrake
System Warning Light on page 176.
If the light stays on, the vehicle needs service.
If the light comes on while the vehicle is being
driven, stop as soon as possible and turn the
ignition off. Then start the vehicle again to reset the
system. If the light still stays on, or comes on again
while driving, the vehicle needs service. If the
regular brake system warning light is not on, the
vehicle still has brakes, but it does not have
anti-lock brakes. If the brake system warning light is
also on, the vehicle does not have anti-lock brakes
and there is a problem with the regular brakes. See
Brake System Warning Light on page 176. If both
the brake system warning light and the anti-lock
brake system light is on, pull off the road and have
the vehicle towed for service.
The anti-lock brake system warning light will come
on briey when the ignition key is turned to
RUN. This is normal. If the light does not come on
then, have it xed so it will be ready to warn
you if there is a problem.
177

Low Tire Pressure Warning Light
This light should come
on briey as you start
the engine.
This light will also come on when one or more of
your tires is signicantly under-inated. Stop and
check your tires as soon as it is safe to do so.
If underinated, inate them to the proper pressure.
SeeTires on page 400for more information. This
light will ash for 60 seconds and then turn on solid
if a problem is detected with the Tire Pressure
Monitor System. SeeTire Pressure Monitor System
on page 409for more information.
Traction Control System (TCS)
Warning Light
If the vehicle has the
Traction Control
System (TCS), this light
may come on for the
following reasons:
The traction control button, located on the
center console, is pressed, turning the
system off. The light will stay on. To turn the
system back on, press the button again
and the warning light should go out. See
Traction Control System (TCS) on page 292
for more information.
If there is a brake system problem that is
specically related to traction control, the TCS
will turn off and the warning light will come on.
If the brakes begin to overheat, the TCS will
turn off and the warning light will come on until
the brakes cool down.
If the TCS warning light comes on and stays on
for an extended period of time when the system is
turned on, the vehicle needs service.
178

Oil Pressure Light
If there is a problem
with the vehicle’s oil
pressure, this light may
stay on when the
engine is started.
It may also come on while the vehicle is being
driven. This indicates that the engine could be low
on oil or could have some other oil problem.
Have it xed right away.
The oil light could also come on in two other
situations:
When the ignition is on but the engine is not
running, the light will come on as a test to
indicate it is working. The light will go out when
the ignition is turned to RUN. If it does not come
on while the ignition is in the on position, there
may be a problem with the fuse or bulb. See
Fuses and Circuit Breakers on page 460.
If the brakes are applied quickly and the vehicle
makes a hard stop, the light may come on for a
moment. This is normal.
{CAUTION:
Do not keep driving if the oil pressure is
low. If you do, your engine can become so
hot that it catches re. You or others
could be burned. Check your oil as soon
as possible and have your vehicle
serviced.
Notice:Lack of proper engine oil maintenance
may damage the engine. The repairs would
not be covered by your warranty. Always follow
the maintenance schedule in this manual for
changing engine oil.
184