ABS PORSCHE 911 GT3 2010 5.G User Guide
[x] Cancel search | Manufacturer: PORSCHE, Model Year: 2010, Model line: 911 GT3, Model: PORSCHE 911 GT3 2010 5.GPages: 251, PDF Size: 14.33 MB
Page 126 of 251

Instruments, On-Board Computer
125
Note
You can recall phone calls, e.g. calls that arrived
during your absence, via the menu item “Missed
calls”.Example:
Selecting from the telephone book and
calling
fSelect “Phone book” with the operating lever.fPush operating lever forward.
fSelect a person to call and push the operating
lever forward.
The connection is established.
10_GT3_21.book Seite 125 Donnerstag, 4. Juni 2009 12:48 12
Page 152 of 251

Warnings
151
Failure indicator Coolant indicator failed.
Have the fault remedied at an authorized Porsche dealer.
Failure
outside temp.
indicatorOutside temperature indicator failed.
Have the fault remedied at an authorized Porsche dealer.
Service
wear on
brake padsHave the brake pads changed immediately at an authorized Porsche dealer.
Warning
Brake fluid levelStop immediately in a suitable place.
Do not continue driving. Have the fault remedied at an authorized Porsche dealer.
Warning
Brake distributionStop immediately in a suitable place.
Do not continue driving. Have the fault remedied at an authorized Porsche dealer.
ABS failure Have the fault remedied at an authorized Porsche dealer.
SC off
Continuous display: SC offStability Control (SC) switched off.
SC+TC off
Continuous display: SC+TC offStability Control (SC) and Traction Control (TC) switched off.
SC+TC on Stability Control (SC) and Traction Control (TC) switched on.
PSM failure Have the fault remedied at an authorized Porsche dealer.
Instrument
panelOn-board
computerText display on on-board
computerMeaning/measure
10_GT3_21.book Seite 151 Donnerstag, 4. Juni 2009 12:48 12
Page 164 of 251

Maintenance, Car Care
163
Changing the brake fluid Brake fluid absorbs moisture from the air over
time. This accumulation of water lowers the
boiling point and, under certain operating condi-
tions, can affect the braking performance.
Therefore have the brake fluid changed in accor-
dance with the change intervals stated in the
brochure “Maintenance”. – The warning lights on the instrument panel and
on the on-board computer indicate an insuffi-
cient brake fluid level.
– If the warning light lights up on the instrument
panel and the warning message appears on
the on-board computer in combination with a
larger pedal travel, a brake circuit may have
failed.
If the warning lights should light up when
driving:
fStop immediately in a suitable place.
fDo not continue driving.
Consult an authorized Porsche dealer.
Warning light USA
Warning light Canada
10_GT3_21.book Seite 163 Donnerstag, 4. Juni 2009 12:48 12
Page 178 of 251

Maintenance, Car Care
177
Engine compartment The engine compartment and the surface of the
engine are treated with a corrosion-inhibitor at the
factory.
If degreasing solvents are used to clean the
engine compartment or the engine is washed
down, the process almost invariably removes the
corrosion-inhibiting coating. It is then absolutely
necessary to have a durable preservative applied
to all surfaces, body seams, joints and assemblies
in the engine compartment. This also applies
when corrosion-inhibitor parts are replaced.
Caution!
Risk of damage to the alternator.
fDo not point the cleaning jet directly at the alternator, or cover the alternator.
Effective corrosion-proofing is particularly impor-
tant during the cold weather season. If your car is
driven frequently in areas where salt has been
spread on the roads, the whole engine compart-
ment should be cleaned thoroughly after the
winter to prevent salt from causing any lasting
damage. A full under-body wash should also be
performed at the same time.
Windows The road dust which settles on the windshield and
windows contains particles of tire rubber and oil
residue. The interior trim and upholstery release
particles, particularly in strong sunlight, which
collect on the insides of the windows. These
deposits are augmented by impurities in the air
which enters the car through the fresh air vents.
fClean all windows regularly, inside and outside,
with Porsche window cleaner.
fIf you use a chamois leather for the windows,
do not use it for paintwork as it will otherwise
pick up a certain amount of preservative or
polish and could smear the windows and thus
impair vision.
fRemove dead insects with Porsche insect
remover.
Note
Door windows feature a water-repellent (hydro-
phobic) coating which prevents soiling of the
windows.
This coating is subject to natural wear and can be
renewed.
fConsult an authorized Porsche dealer.
Wiper blades Wiper blades that are in perfect condition are vital
for a clear view.
fReplace the wiper blades twice per year
(before and after the cold season) or whenever
wiper performance deteriorates.
fPeriodically clean the wiper blades with
Porsche window cleaner, especially after the
vehicle has been washed in a car wash.
If they are very dirty (e.g. with insect remains),
they can be cleaned with a sponge or cloth.
If the wiper blades rub or squeak, this can be as a
result of the following:
– If the vehicle is washed in an automatic car
wash, residues may adhere to the windshield.
These wax residues can be removed only by
using window cleaner concentrate.
– The wiper blades may be damaged or worn.
fReplace damaged wiper blades as soon as
possible.
Please see the chapter “WIPER BLADES” on
Page 173.
fPlease see the chapter “WASHER FLUID” on
Page 170.
fPlease contact your authorized Porsche dealer
for further information.
10_GT3_21.book Seite 177 Donnerstag, 4. Juni 2009 12:48 12
Page 182 of 251

Maintenance, Car Care
181
Storing your Porsche If you intend to store your Porsche for a prolonged
period, please consult your authorized Porsche
dealer. The staff will be glad to advise you on the
most suitable and necessary methods.
fClean your vehicle thoroughly inside and
outside.
Clean the engine compartment.
The under carriage and chassis components
should be free of dirt and salt deposits.
fFill up the fuel tank.
fChange the oil and oil filter, and run the engine
for several minutes.
fIncrease the tire pressure to 58 psi (4 bar).
It is not recommended to lift the vehicle, due to
the possibility of corrosion on shock absorber
piston shafts.
The vehicle should be moved slightly, approxi-
mately every four weeks, to prevent flat spot
on the tires. Climate control
The air conditioning system should be in good
working condition and fully charged.
Windshield/Headlight washer
fCheck and correct antifreeze/cleaning solution
level as necessary.
Electrical system
fRemove the battery from the vehicle and store
it in a cool dry place, not on a cement floor.
When the battery is disconnected, the
alarm system is deactivated.
fRecharge the battery every 3 months. If the
battery remains in the vehicle with the cables
connected, it is necessary to check, remove
and recharge the battery every 2-3 weeks.
Do not fast charge the battery.
fPlease see the chapter “BATTERY” on
Page 211.Vehicle interior
The interior must be dry, especially in the area of
the floor carpets. The use of drying agents (Silica-
Gel) is recommended in vehicles with leather
interior and in areas with high humidity. The
recommended amount is 3 fabric bags of 1.1 lbs.
(500 grams) each placed on the floor carpets.
Windows, doors and lids must be closed. The air
vents should be opened.
10_GT3_21.book Seite 181 Donnerstag, 4. Juni 2009 12:48 12
Page 222 of 251

Practical Tips, Emergency Service
221
3. Place socket wrench (tool kit) on the unlocking
spindle.
The handle of the wrench should point horizon-
tally to the rear.
4. Turn socket wrench approx. 180° A. The
headlight is unlocked and pushed forward
slightly during this process.
5. Turn socket wrench back until it is pointing
vertically downward B and leave in position.
6. The headlight is now unlocked and can be
pulled forward out of the fender.
Installing1. Insert headlight into the guide rails and push
fully into the fender.
2. Push headlight to the rear and at the same
time turn the socket wrench until it points
horizontally to the rear C.
The headlight locking device must perceptibly
and audibly engage.
3. Insert the rubber plug into the unlocking
opening and secure the carpet.
Check the function of all lights.
Low beam, high beam and additional high
beamOpening the lid of the headlight housing
1. Unscrew the 4 screws A.
2. First lift release tab B, then push both release
tabs C upwards and take off lid.
10_GT3_21.book Seite 221 Donnerstag, 4. Juni 2009 12:48 12
Page 224 of 251

Practical Tips, Emergency Service
223
Bi-Xenon headlight (without cornering light):
Changing bulb for additional high beam
Halogen headlights:
Changing bulb for low beam
1. Turn the bulb holder.
Turn it counter-clockwise on the left headlight
and clockwise on the right headlight.
Take bulb holder out of the headlight housing.2. Pull both plug release tabs apart.
Pull plug out of the bulb holder.
3. Replace the defective bulb with bulb holder.
4. Reassemble in reverse order.Closing lid of headlight housing
1. Push on lid until it perceptibly engages.
2. Fasten lid with the 4 screws.
10_GT3_21.book Seite 223 Donnerstag, 4. Juni 2009 12:48 12
Page 244 of 251

Index
243 Index
AABS (antilock brake system) .......................... 57
Warning light ........................................ 58
Adaptive sports seat..................................... 34
Adjusting Headlights.................................... 228
Advanced Airbag........................................... 42
Aerodynamic components ............................... 6
Air conditioning compressor .................. 98, 100
Air conditioning system ................................. 98
Air distribution ...................................... 98, 100
Air filter ...................................................... 172
Air intake.................................................... 101
Airbag
Advanced ............................................. 42
Cleaning covers .................................. 180
Deactivation device............................... 46
Function ............................................... 42
Maintenance ......................................... 45
Warning light ........................................ 45
Airbag Systems ............................................ 41
Alarm system ......................................... 26, 91
Deactivating passenger compartment
monitoring ............................................ 27
Fault indication...................................... 27
Function indication................................ 26
Not active .......................................... 208
Alcantara, cleaning ..................................... 180
Antenna ............................................... 91, 175
Antifreeze .................................................. 158
Antifreeze in coolant................................... 158Antilock brake system (ABS) .......................... 57
Warning light......................................... 58
Ashtray ........................................................ 81
Audio operation ...................................... 89, 90
Auto-button, air conditioning........................... 98
Automatic
Air conditioning system ......................... 98
Anti-glare mirrors .................................. 31
Car washes ........................................ 175
Door locking ................................... 21, 25
Garage door ......................................... 71
Headlight adjustment ............................. 74
Speed control ......................... 78, 79, 108
Automatic locking retractor ........................... 50
Automatic speed control.............................. 108
Indicator light...................................... 108
AUX, external audio source ............................ 93
Average consumption.......................... 118, 147
Average speed ................................... 118, 147
BBackrest
Adjustment ........................................... 33
Release ................................................ 33
Battery ....................................................... 211
Care................................................... 212
Charge state....................................... 211
Charging ............................................ 212
Putting vehicle into operation ...............213
Remote control ................................... 216
Removing ........................................... 214
Replacing ........................................... 213
Warning light....................................... 115
Winter operation.................................. 213
Before driving off ....................................11, 12
Belts ............................................................ 38
Cleaning ............................................. 180
Height adjustment ................................. 40
Tensioner ............................................. 38
Warning light......................................... 39
Blower adjustment ...................................... 101
Blower speed adjustment .............................. 99
Brake
Break in................................................ 13
Light .................................................. 227
Light, additional .................................. 227
Pads .................................................... 56
Pedal ................................................... 55
Wear .................................................... 56
10_GT3_21.book Seite 243 Donnerstag, 4. Juni 2009 12:48 12