jump start terminals PORSCHE CAYNNE 2004 1.G Owners Manual
[x] Cancel search | Manufacturer: PORSCHE, Model Year: 2004, Model line: CAYENNE, Model: PORSCHE CAYENNE 2004 1.GPages: 379, PDF Size: 13.91 MB
Page 307 of 379
Minor Repairs
307
Inflating tires on vehicles without air
suspension1. Please follow the operating instructions on the
compressor.
2. Screw filler hose of the compressor onto the
tire valve.
3. Remove cover A of the engine-compartment
cover.
Please see the chapter “CONNECTING
JUMPER CABLES” on Page 324.
+ = Positive terminal for emergency starting
with jumper cables
– = Grounding point for emergency starting
with jumper cables4. Connect clamps of the compressor to the
terminals for emergency starting with jumper
cables.
Always observe the following sequence:
– Open the cap of the positive terminal for emer-
gency starting with jumper cables (+).
– Connect positive lead (red) to the positive
terminal for emergency starting with jumper
cables (+).– Connect negative lead (black) to the negative
terminal for emergency starting with jumper
cables (
–).
Warning!
Danger of burning. The compressor filler
hose can become hot during the inflation
process.
fWear gloves.
5. Switch on compressor.
The required filling pressure will be reached
after a few minutes.
6. Switch off compressor.
7. Check filling pressure with pressure tester.
Then reduce tire pressure or add more air if
necessary. Recheck the filling pressure.
8. Unscrew filler hose of the compressor.Reducing filling pressure on vehicles
without air suspension1. Switch off compressor.
2. Open air bleed screw on the filling hose until
the correct filling pressure is achieved.
10_Cayenne_21_KW17.book Seite 307 Donnerstag, 9. April 2009 3:33 15
Page 323 of 379
Minor Repairs
323
Emergency Starting with Jumper
CablesIf the battery is discharged, e.g. in winter or after
the car has been parked for a long time, the bat-
tery of another car can be used for starting with
the help of jumper cables.
Make sure the voltage of both batteries is the
same.
The capacity (Ampere hours, Ah) of the booster
battery must not be substantially less than that of
the discharged battery.The discharged battery
must be correctly connected to the vehicle's elec-
trical system.
fPlease see the chapter “BATTERY” on
Page 320.
Note
Do not try to start the car by pushing or towing.
Damage to the catalytic converters and other
components of the car may result.
Danger!
Risk of short circuit, damage and explosion,
resulting in serious personal injury or death.
fUse only jumper cables of adequate diameter
cross-section and fitted with completely
insulated alligator clips.
fFollow all warnings and instructions of the
jumper cable manufacturer.
fWhen connecting jumper cables, make sure
that they cannot get caught in any moving
parts in the engine compartment.
The jumper cables must be long enough so
that neither vehicles nor cables touch another.
fThe vehicles must not be in contact, otherwise
current might flow as soon as the positive
terminals are connected.
fThe cable clamps must not be allowed to con-
tact each other when one end of the jumper ca-
bles are connected to a battery.
fCarefully ensure that tools or conductive jewe-
lery (rings, chains, watch straps) do not come
into contact with the positive jumper cable or
the positive battery post.
fImproper hook-up of jumper cables can ruin
the alternator.
Danger of caustic burns.
fDo not lean over the battery.Danger of gas explosion.
fImproper use of booster battery to start a
vehicle may cause an explosion, resulting in
serious personal injury or death.
fKeep sources of ignition away from the
battery, e.g. open flame, burning cigarettes or
sparking due to cable contact or welding work.
fA discharged battery can freeze even at
14 °F (−10 °C). Before connecting jumper
cables, a frozen battery must be thawed out.
10_Cayenne_21_KW17.book Seite 323 Donnerstag, 9. April 2009 3:33 15