homelink Ram 1500 2009 Owner's Manual
[x] Cancel search | Manufacturer: RAM, Model Year: 2009, Model line: 1500, Model: Ram 1500 2009Pages: 543, PDF Size: 7.75 MB
Page 92 of 543
Rear Park Assist — If Equipped ........... 163
▫ Rear Park Assist Sensors ............... 163
▫ Rear Park Assist Warning Display ........ 164
▫ Enable/Disable The Rear Park Assist ...... 167
▫ Service The Rear Park Assist ............ 168
▫ Cleaning The Rear Park Assist ........... 168
Rear Backup Camera — If Equipped ........ 168
▫ Turning The Rear Camera On Or Off — With
Navigation Radio .................... 170
▫ Turning The Rear Camera On Or Off —
Without Navigation Radio .............. 170
Overhead Console — If Equipped .......... 171
▫ Courtesy/Reading Lights .............. 172
Garage Door Opener — If Equipped ........ 174▫
Programming HomeLink .............. 175
▫ Gate Operator/Canadian Programming .... 178
▫ Using HomeLink ................... 178
▫ Reprogramming A Single HomeLink
Button ............................ 179
▫ Security ........................... 179
▫ Troubleshooting Tips .................. 179
▫ General Information .................. 180
Power Sunroof — If Equipped ............ 180
▫ Open Sunroof — Express Mode .......... 181
▫ Closing Sunroof — Express ............. 182
▫ Pinch Protect Feature ................. 182
▫ Pinch Protect Override ................ 182
90 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 176 of 543
GARAGE DOOR OPENER — IF EQUIPPED
HomeLinkreplaces up to three remote controls (hand-
held transmitters) that operate devices such as garage
door openers, motorized gates, lighting, or home security
systems. The HomeLink unit operates off your vehicle’s
battery.
The HomeLink buttons are located in the overhead
console, and contain one, two, or three dots/lines desig-
nating the different HomeLink channels.
NOTE:HomeLink is disabled when the Vehicle Secu-
rity Alarm is active.
HomeLink Buttons
174 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 177 of 543
WARNING!
•Your motorized door or gate will open and close
while you are training the Universal Transceiver.
Do not train the transceiver if people or pets are in
the path of the door or gate. Only use this trans-
ceiver with a garage door opener that has a “stop
and reverse” feature as required by federal safety
standards. This includes most garage door opener
models manufactured after 1982. Do not use a
garage door opener without these safety features.
Call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for safety information or as-
sistance.
•Vehicle exhaust contains carbon monoxide, a dan-
gerous gas. Do not run your vehicle in the garage
while training the transceiver. Exhaust gas can
cause serious injury or death.
Programming HomeLink
Before You Begin
If you have not trained any of the HomeLinkbuttons,
erase all channels before you begin training.
To do this, press and hold the two outside buttons for
20 seconds. The EVIC will display “CLEARING CHAN-
NELS”. Release the buttons when the EVIC message
states “CHANNELS CLEARED”.
It is recommended that a new battery be placed in the
hand-held transmitter of the device being programmed
to HomeLink for more efficient training and accurate
transmission of the radio-frequency signal.
It is also advised to park outside the garage while
training.
1. Turn the ignition switch to the ON/RUN position.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 175
Page 178 of 543
2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm)
from the HomeLinkbuttons while keeping the EVIC
display in view.
For optimal training, point the battery end of the hand-
held transmitter away from the HomeLink
3. Simultaneously press and hold both the chosen
HomeLink button and the hand-held transmitter button
until the EVIC display changes from “CHANNEL #
TRAINING” to “CHANNEL # TRAINED”.
Then release both the HomeLink and hand-held trans-
mitter buttons.
If the EVIC display states “DID NOT TRAIN” repeat
step 3. If the signal is too weak, replace the battery in the
original hand-held transmitter.
It may take up to 30 seconds, or longer, in rare cases. The
garage door may open and close while you train. NOTE:
Some gate operators and garage door openers
may require you to replace Step 3 with procedures noted
in the “Gate Operator/Canadian Programming” section.
4. Press and hold the just-trained HomeLink button. If
the channel has been trained, the EVIC display will now
state “CHANNEL # TRANSMIT”.
If the EVIC display still states “CHANNEL # TRAIN-
ING” repeat Step 3.
NOTE: After training a HomeLink channel, if the
garage door does not operate with HomeLink and the
garage door opener was manufactured after 1995, the
garage door opener may have rolling code. If so, proceed
to the heading “Programming A Rolling Code System.”
5. PROGRAMMING A ROLLING CODE SYSTEM
At the garage door opener motor (in the garage), locate
the “learn” or “training” button.
176 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 179 of 543
This can usually be found where the hanging antenna
wire is attached to the garage door opener motor (it is
NOT the button normally used to open and close the
door).6. Firmly press and release the “learn” or “training”
button. The name and color of the button may vary by
manufacturer.
NOTE:
There are 30 seconds in which to initiate the next
step after the “Learn” button has been pressed.
7. Return to the vehicle and press the programmed
HomeLink button twice (holding the button for two
seconds each time). If the device is plugged in and
activates, programming is complete.
If the device does not activate, press the button a third
time (for two seconds) to complete the training.
If you have any problems, or require assistance, please
call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for information or assistance.
To program the remaining two HomeLink buttons,
repeat each step for each remaining button. DO NOT
erase the channels.
1 — Garage Door Opener
2 — Training Button
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 177
Page 180 of 543
Gate Operator/Canadian Programming
Canadian radio-frequency laws require transmitter sig-
nals to “time-out” (or quit) after several seconds of
transmission – which may not be long enough for
HomeLinkto pick up the signal during programming.
Similar to this Canadian law, some U.S. gate operators are
designed to “time-out” in the same manner.
It may be helpful to unplug the device during the cycling
process to prevent possible overheating of the garage
door or gate motor.
If you are having difficulties programming a garage door
opener or a gate operator, replace “Programming
HomeLink” Step 3 with the following:
3. Continue to press and hold the HomeLink button
while you press and release - every two seconds
(“cycle”) your hand-held transmitter until HomeLink has successfully accepted the frequency signal. The EVIC
display will change from “CHANNEL # TRAINING” to
“CHANNEL # TRAINED.”
If you unplugged the device for training, plug it back in
at this time.
Then proceed with Step 4 under “Programming
HomeLink” earlier in this section.
Using HomeLink
To operate, simply press and release the programmed
HomeLink
button. Activation will now occur for the
trained device (i.e., garage door opener, gate operator,
security system, entry door lock, home/office lighting,
etc.) The hand-held transmitter of the device may also be
used at any time.
178 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 181 of 543
Reprogramming A Single HomeLinkButton
To reprogram a channel that has been previously trained,
follow these steps:
1. Turn the ignition switch to the ON/RUN position.
2. Press and hold the desired HomeLink button for
20 seconds until the EVIC display states “CHANNEL #
TRAINING.” Do not release the button.
3. Without releasing the button, proceed with Program-
ming HomeLink Step 2 and follow all remaining steps.
Security
It is advised to erase all channels before you sell or turn
in your vehicle.
To do this, press and hold the two outside buttons for
20 seconds until the EVIC message states “CHANNELS
CLEARED.” Note that all channels will be erased. Indi-
vidual channels cannot be erased. The HomeLink
Universal Transceiver is disabled when
the Vehicle Security Alarm is active.
Troubleshooting Tips
If you are having trouble programming HomeLink , here
are some of the most common solutions:
•Replace the battery in the original transmitter.
•Press the learn button on the garage door opener to
complete the training for rolling code.
•Did you unplug the device for training, and remember
to plug it back in?
If you are having any problems or require assistance,
please call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for information or assistance.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 179
Page 530 of 543
Fuel Saver............................. 251
Fuses ................................ 475
Garage Door Opener (HomeLink) ........... 174
Gas Cap (Fuel Filler Cap) ...............396,444
Gasoline (Fuel) ......................... 386
Conserving ........................ 251,252
Gasoline, Reformulated ................... 387
Gauges ............................... 243
Coolant Temperature ................... 227
Fuel ............................... 227
Oil Pressure .......................... 230
Speedometer ......................... 228
Tachometer .......................... 227
Voltmeter ............................ 235
Gear Ranges ........................ 315,322
General Information ...............17,25,127,385
Glass Cleaning .......................... 473
Grocery Bag Retainer ..................... 198 Gross Axle Weight Rating
.................. 399
Gross Vehicle Weight Rating ................ 399
Guide, Body Builders ...................... 6
GVWR ............................... 397
Hands-Free Phone (uconnect) ............... 99
Hazard Driving Through Flowing, Rising, or
Shallow Standing Water ................. 341
Hazard Warning Flasher ................... 420
Head Restraints ......................... 136
Headlights ............................ 481
Automatic ........................... 147
Cleaning ............................ 473
High Beam .......................... 153
High Beam/Low Beam Select Switch ........ 153
Lights On Reminder .................... 151
Passing ............................. 153
Switch .............................. 147
528 INDEX
Page 531 of 543
Heated Mirrors....................... 97,199
Heated Seats ........................... 138
Heater ............................... 293
Heater, Engine Block ..................... 311
High Beam/Low Beam Select (Dimmer) Switch . . 153
Hitches Trailer Towing ........................ 403
Hoisting .............................. 433
HomeLink (Garage Door Opener) Transmitter . . . 174
Hood Release .......................... 145
Ignition ............................... 14
Key ............................... 12,14
Ignition Key Removal ..................... 14
Illuminated Entry ........................ 19
Immobilizer (Sentry Key) ................... 15
Infant Restraint .......................... 69
Inflation Pressure Tires .................... 377
Information Center, Vehicle ................. 244 Inside Rearview Mirror
.................... 93
Instrument Cluster ................. 223,225,227
Instrument Panel and Controls .............. 222
Instrument Panel Lens Cleaning ............. 474
Integrated Power Module (Fuses) ............ 475
Interior Appearance Care .................. 472
Interior Lights .......................... 149
Intermittent Wipers (Delay Wipers) ........... 154
Introduction ............................. 4
Inverter Outlet (115V) ..................... 188
Jack Location ........................... 420
Jump Starting .......................... 433
Key, Programming ........................ 17
Key, Replacement ........................ 16
Key, Sentry (Immobilizer) ................... 15
Key-In Reminder ......................... 15
Keyless Entry System ...................... 20
10
INDEX 529
Page 534 of 543
Outside.............................. 94
Rearview ............................. 93
Mode Fuel Saver ........................ 251,252
Modifications/Alterations, Vehicle ............. 7
Monitor, Tire Pressure System ............... 381
Mopar Parts ......................... 446,516
Multi-Displacement Engine System ........... 349
Multi-Function Control Lever ............... 151
Navigation System (uconnect gps)........... 168
New Vehicle Break-In Period ................ 81
Occupant Restraints ................... 39,60,64
Occupant Restraints (Sedan) .............56,60,63
Octane Rating, Gasoline (Fuel) .............. 386
Odometer ............................. 231
Trip ................................ 231
Off-Pavement Driving (Off-Road) ............ 343Off-Road Driving (Off-Pavement)
............ 343
Oil Change Indicator .................. 233,249
Oil Change Indicator, Reset ..............233,249
Oil, Engine ......................... 448,489
Capacity ............................ 488
Change Interval ....................... 449
Dipstick ............................. 448
Disposal ............................ 450
Filter ............................ 450,489
Filter Disposal ........................ 450
Identification Logo ..................... 449
Materials Added to ..................... 450
Pressure Gauge ....................... 230
Recommendation ................... 449,488
Synthetic ............................ 450
Viscosity ......................... 449,488
Onboard Diagnostic System ..............444,445
Opener, Garage Door (HomeLink) ........... 174
Operating Precautions .................... 444
532 INDEX