cooling Ram 1500 2011 User Guide

▫Windshield Wiper Blades ............... 540
▫ Adding Washer Fluid ................. 540
▫ Exhaust System ..................... 541
▫ Cooling System ..................... 544
▫ Brake System ....................... 550
▫ Rear Axle And 4X4 Front Driving Axle Fluid
Level ............................. 553
▫ Transfer Case ....................... 554
▫ Automatic Transmission ............... 554
▫ Appearance Care And Protection From
Corrosion .......................... 557
 Fuses .............................. 564
▫ Totally Integrated Power Module ......... 564
 Vehicle Storage ....................... 569 
Replacement Bulbs .................... 570
 Bulb Replacement ..................... 571
▫ Dual Or Quad Headlamp/Front Park And
Turn Signal — If Equipped ............. 571
▫ Fog Lamps ......................... 573
▫ Rear Tail/Stop, Turn Signal And Backup
Lamps ............................ 573
▫ Center High-Mounted Stoplamp (CHMSL)
With Cargo Lamp .................... 575
▫ Cab Top Clearance Lamps — If Equipped . . . 576
▫ Rear Lamp Bar ID Marker
(Dual Rear Wheels) — If Equipped ........ 578
▫ Side Marker Lamps (Dual Rear Wheels) — If
Equipped .......................... 579
 Fluid Capacities ...................... 580
524 MAINTAINING YOUR VEHICLE

Cooling System
WARNING!
You or others can be badly burned by hot coolant or
steam from your radiator. If you see or hear steam
coming from under the hood, do not open the hood
until the radiator has had time to cool. Never try to
open a cooling system pressure cap when the radiator
is hot.
Engine Coolant Checks
Check the engine coolant (antifreeze) protection every
12 months (before the onset of freezing weather, where
applicable). If the engine coolant (antifreeze) is dirty or
rusty in appearance, the system should be drained,
flushed and refilled with fresh coolant. Check the front of
the A/C condenser for any accumulation of bugs, leaves,
etc. If dirty, clean by gently spraying water from a garden
hose vertically down the face of the condenser.Check the coolant recovery bottle tubing for brittle rub-
ber, cracking, tears, cuts and tightness of the connection
at the bottle and radiator. Inspect the entire system for
leaks.
With the engine at normal operating temperature (but
not running), check the cooling system pressure cap for
proper vacuum sealing by draining a small amount of
engine coolant (antifreeze) from the radiator drain cock.
If the cap is sealing properly, the engine coolant (anti-
freeze) will begin to drain from the coolant recovery
bottle. DO NOT REMOVE THE COOLANT PRESSURE
CAP WHEN THE COOLING SYSTEM IS HOT.
Cooling System – Drain, Flush, And Refill
If the engine coolant (antifreeze) is dirty or contains a
considerable amount of sediment, clean and flush with a
reliable cooling system cleaner. Follow with a thorough
rinsing to remove all deposits and chemicals. Properly
dispose of old engine coolant (antifreeze) solution.
544 MAINTAINING YOUR VEHICLE

Refer to the “Maintenance Schedule” for the proper
maintenance intervals.
Selection Of Coolant
Use only the manufacturer’s recommended engine cool-
ant (antifreeze). Refer to “Fluids, Lubricants, and Genu-
ine Parts” in “Maintaining Your Vehicle” for further
information.
CAUTION!
•Mixing of engine coolant (antifreeze) other than
specified HOAT engine coolant (antifreeze), may
result in engine damage and may decrease corro-
sion protection. If a non-HOAT engine coolant
(antifreeze) is introduced into the cooling system
in an emergency, it should be replaced with the
specified engine coolant (antifreeze) as soon as
possible.(Continued)
CAUTION! (Continued)
•Do not use water alone or alcohol-based engine
coolant (antifreeze) products. Do not use addi-
tional rust inhibitors or antirust products, as they
may not be compatible with the engine coolant
(antifreeze) and may plug the radiator.
•This vehicle has not been designed for use with
Propylene Glycol based engine coolant (anti-
freeze). Use of Propylene Glycol based engine
coolant (antifreeze) is not recommended.
7
MAINTAINING YOUR VEHICLE 545

Adding Coolant
Your vehicle has been built with an improved engine
coolant (antifreeze) that allows extended maintenance
intervals. This engine coolant (antifreeze) can be used up
to five years or 104,000 miles (169 000 km) before
replacement. To prevent reducing this extended mainte-
nance period, it is important that you use the same
engine coolant (antifreeze) throughout the life of your
vehicle.
Please review these recommendations for using Hybrid
Organic Additive Technology (HOAT) engine coolant
(antifreeze). When adding engine coolant (antifreeze):
•The manufacturer recommends using MOPAR
Antifreeze/Coolant 5 Year/100,000 Mile Formula
HOAT (Hybrid Organic Additive Technology) or
equivalent.
•Mix a minimum solution of 50% HOAT engine coolant
and distilled water. Use higher concentrations (not to
exceed 70%) if temperatures below 34°F (37°C) are
anticipated.
•Use only high purity water such as distilled or deion-
ized water when mixing the water/engine coolant
(antifreeze) solution. The use of lower quality water
will reduce the amount of corrosion protection in the
engine cooling system.
Please note that it is the owner’s responsibility to main-
tain the proper level of protection against freezing ac-
cording to the temperatures occurring in the area where
the vehicle is operated.
NOTE: Mixing engine coolant (antifreeze) types will
decrease the life of the engine coolant (antifreeze) and
will require more frequent coolant changes.
546 MAINTAINING YOUR VEHICLE

Cooling System Pressure Cap
The cap must be fully tightened to prevent loss of engine
coolant (antifreeze), and to ensure that the engine coolant
(antifreeze) will return to the radiator from the coolant
recovery bottle.
The cap should be inspected and cleaned if there is any
accumulation of foreign material on the sealing surfaces.WARNING!
•The warning words “DO NOT OPEN HOT” on
the cooling system pressure cap are a safety pre-
caution. Never add engine coolant (antifreeze)
when the engine is overheated. Do not loosen or
remove the cap to cool an overheated engine. Heat
causes pressure to build up in the cooling system.
To prevent scalding or injury, do not remove the
pressure cap while the system is hot or under
pressure.
•Do not use a pressure cap other than the one
specified for your vehicle. Personal injury or en-
gine damage may result.
Disposal Of Used Coolant
Used ethylene glycol-based engine coolant (antifreeze) is
a regulated substance requiring proper disposal. Check
with your local authorities to determine the disposal
7
MAINTAINING YOUR VEHICLE 547

•Do not overfill the coolant recovery bottle.
•Check engine coolant (antifreeze) freeze point in the
radiator and in the coolant recovery bottle. If engine
coolant (antifreeze) needs to be added, contents of
coolant recovery bottle must also be protected against
freezing.
•If frequent engine coolant (antifreeze) additions are
required, or if the level in the coolant recovery bottle
does not drop when the engine cools, the cooling
system should be pressure tested for leaks.
•Maintain engine coolant (antifreeze) concentration at
50% HOAT engine coolant (antifreeze) (minimum)
and distilled water for proper corrosion protection of
your engine, which contains aluminum components.
•Make sure that the radiator and coolant recovery
bottle overflow hoses are not kinked or obstructed.
•Keep the front of the radiator clean. If your vehicle is
equipped with air conditioning, keep the front of the
condenser clean, also.
•Do not change the thermostat for Summer or Winter
operation. If replacement is ever necessary, install
ONLY the correct type thermostat. Other designs may
result in unsatisfactory engine coolant (antifreeze)
performance, poor gas mileage, and increased
emissions.
Brake System
In order to assure brake system performance, all brake
system components should be inspected periodically.
Refer to the “Maintenance Schedule” for the proper
maintenance intervals.
550 MAINTAINING YOUR VEHICLE

U.S.Metric
Cooling System
3.7L Engine (MOPAR Antifreeze/Coolant 5 Year/100,000 Mile
Formula or equivalent) 14 Quarts
13 Liters
4.7L Engine (MOPAR Antifreeze/Coolant 5 Year/100,000 Mile
Formula or equivalent) 14 Quarts
13 Liters
5.7L Engine — 1500 Models (MOPAR Antifreeze/Coolant 5
Year/100,000 Mile Formula or equivalent) 16 Quarts
15 Liters
5.7L Engine — 2500/3500 Models (MOPAR Antifreeze/Coolant 5
Year/100,000 Mile Formula or equivalent) 18.7 Quarts
17.7 Liters
5.7L Engine — 2500/3500 Models w/Heavy Duty (MOPAR
Antifreeze/Coolant 5 Year/100,000 Mile Formula or equivalent) 19.2 Quarts
18.2 Liters
7
MAINTAINING YOUR VEHICLE 581

Coolant Pressure Cap (Radiator Cap).......... 547
Cooling System ......................... 544
Adding Coolant (Antifreeze) ............. 546
Coolant Capacity ..................... 580
Coolant Level .................... 544,548
Disposal of Used Coolant ............... 547
Drain, Flush, and Refill ................ 544
Inspection .......................... 548
Points to Remember .................. 549
Pressure Cap ........................ 547
Radiator Cap ....................... 547
Selection of Coolant (Antifreeze) ....545,580,582
Cruise Control (Speed Control) .............. 134
Cupholders ............................ 169
Customer Assistance ..................... 605
Data Recorder, Event ...................... 66
Daytime Running Lights ................... 127
Dealer Service .......................... 531 Defroster, Rear Window
................... 180
Defroster, Windshield ................84,293,299
Delay (Intermittent) Wipers ................. 130
Differential, Limited-Slip .................. 365
Dipsticks Automatic Transmission ................ 556
Power Steering ...................... 391
Disabled Vehicle Towing ................... 518
Disposal Antifreeze (Engine Coolant) ............. 547
Door Locks ............................. 29
Door Locks, Automatic .................... 30
Door Opener, Garage ..................... 152
Driving Off-Pavement ....................... 347
Off-Road .......................... 347
Through Flowing, Rising, or Shallow Standing
Water ............................. 366
Driving to Achieve Maximum Fuel Economy .... 235
10
INDEX 617

Trailer Towing.......................... 456
Cooling System Tips .................. 473
Hitches ............................ 460
Minimum Requirements ................ 463
Mirrors ............................ 100
Trailer and Tongue Weight .............. 462
Wiring ............................ 470
Trailer Towing Guide ..................... 461
Trailer Weight .......................... 461
Transfer Case ........................... 554
Electronically Shifted ...............329,336
Fluid ............................. 583
Transmission ........................... 313
Automatic .................... 313,318,554
Fluid ............................. 583
Maintenance ........................ 554
Shifting ........................... 312
Transmitter Battery Service
(Remote Keyless Entry) .................... 24 Transmitter Programming
(Remote Keyless Entry)
.................... 20
Transmitter, Garage Door Opener (HomeLink®) . . 152
Transmitter, Remote Keyless Entry (RKE) ........ 20
Tread Wear Indicators .................... 422
Trip Odometer ....................... 214,215
Turn Signals ................... 128,210,571,573
UCI Connector ....................... 274,280
Uconnect™ (Hands-Free Phone) ............. 101
Uniform Tire Quality Grades ................ 611
Universal Consumer Interface (UCI)
Connector .......................... 274,280
Universal Transmitter ..................... 152
Untwisting Procedure, Seat Belt .............. 47
Utility Rails, Rear Cargo Area ............... 196
Variance, Compass ....................... 241
Vehicle Identification Number (VIN) ............ 7
10
INDEX 631