Transmission fluid level Ram 2500 2014 User Guide

NOTE:When refilling an axle with a Limited Slip Differ-
ential, (which requires a Limited Slip Additive), the
Limited Slip Additive should be added before the gear
lubricant is added to insure proper additive fill.
Transfer Case
Drain And Refill
Refer to the “Maintenance Schedule” for the proper
maintenance intervals.
Lubricant Selection
Refer to “Fluids, Lubricants, and Genuine Parts” in
“Maintaining Your Vehicle” for further information.
Fluid Level Check
This fluid level can be checked by removing the filler
plug. The fluid level should be to the bottom edge of the
filler plug hole with the vehicle in a level position.
Automatic Transmission
Selection Of Lubricant
It is important to use the proper transmission fluid to
ensure optimum transmission performance and life. Use
only the manufacturer ’s specified transmission fluid.
Refer to “Fluids, Lubricants, and Genuine Parts” in this
section for fluid specifications. It is important to maintain
the transmission fluid at the correct level using the
recommended fluid. No chemical flushes should be used
in any transmission; only the approved lubricant should
be used.
CAUTION!
Using a transmission fluid other than the manufac-
turer ’s recommended fluid may cause deterioration
in transmission shift quality and/or torque converter
(Continued)
708 MAINTAINING YOUR VEHICLE

CAUTION!(Continued)
shudder, and will require more frequent fluid and
filter changes. Refer to “Fluids, Lubricants, and
Genuine Parts” in this section for fluid specifica-
tions.
Special Additives
The manufacturer strongly recommends against using
any special additives in the transmission. Automatic
Transmission Fluid (ATF) is an engineered product and
its performance may be impaired by supplemental addi-
tives. Therefore, do not add any fluid additives to the
transmission. The only exception to this policy is the use
of special dyes for diagnosing fluid leaks. Avoid using
transmission sealers as they may adversely affect seals.
CAUTION!
Do not use chemical flushes in your transmission as
the chemicals can damage your transmission compo-
nents. Such damage is not covered by the New
Vehicle Limited Warranty.
Fluid Level Check — Eight-Speed Transmission
The fluid level is preset at the factory and does not require
adjustment under normal operating conditions. Routine
fluid level checks are not required, therefore the transmis-
sion has no dipstick. Your authorized dealer can check your
transmission fluid level using special service tools.
If you notice fluid leakage or transmission malfunction,
visit your authorized dealer immediately to have the
transmission fluid level checked. Operating the vehicle
with an improper fluid level can cause severe transmis-
sion damage.7
MAINTAINING YOUR VEHICLE 709

CAUTION!
If a transmission fluid leak occurs, visit your autho-
rized dealer immediately. Severe transmission dam-
age may occur. Your authorized dealer has the proper
tools to adjust the fluid level accurately.
Fluid Level Check — Six-Speed Transmission
It is best to check the fluid level when the transmission is
at normal operating temperature (170-180°F / 77-82°C).
This normally occurs after at least 15 miles (25 km) of
driving. At normal operating temperature the fluid can-
not be held comfortably between the fingertips. You can
read the transmission sump temperature in the EVIC
display (refer to “Electronic Vehicle Information Center
[EVIC]” for further information).Use the following procedure to check the transmission
fluid level properly:
1. Monitor the transmission temperature using the EVIC
display, and operate the vehicle as required to reach
the normal operating temperature.
2. Park the vehicle on level ground.
3. Run the engine at normal idle speed for at least 60 seconds, and leave the engine running for the rest of
this procedure.
4. Fully apply the parking brake and press the brake pedal.
5.
Place the shift lever momentarily into each gear position
(allowing time for the transmission to fully engage in
each position), ending with the transmission in PARK.
6. Remove the dipstick, wipe it clean and reinsert it until seated.
710 MAINTAINING YOUR VEHICLE

7. Remove the dipstick again and note the fluid level onboth sides. The fluid level reading is only valid if there
is a solid coating of oil on both sides of the dipstick.
Note that the holes in the dipstick will be full of fluid
if the actual level is at or above the hole. The fluid level
should be between the “HOT” (upper) reference holes
on the dipstick at normal operating temperature. If the
fluid level is low, add fluid through the dipstick tube
to bring it to the proper level. Do not overfill.Use
ONLY the recommended fluid (see Fluids, Lubri-
cants, and Genuine Parts for fluid specifications).
After adding any quantity of oil through the dipstick
tube, wait a minimum of two minutes for the oil to
fully drain into the transmission before rechecking the
fluid level. NOTE:
If it is necessary to check the transmission below
the operating temperature, the fluid level should be
between the two “COLD” (lower) holes on the dipstick
with the fluid at 60-70°F / 16-21°C. Only use the COLD
region of the dipstick as a rough reference when setting
the fluid level after a transmission service or fluid
change. Re-check the fluid level, and adjust as required,
once the transmission reaches normal operating tempera-
ture.
CAUTION!
If the fluid temperature is below 50°F (10°C) it may
not register on the dipstick. Do not add fluid until
the temperature is elevated enough to produce an
accurate reading. Run the engine at idle, in PARK, to
warm the fluid.
8. Check for leaks. Release the parking brake.
7
MAINTAINING YOUR VEHICLE 711

Severe Duty All Models
•Change Engine Oil at 4000 miles (6,500 km) if the
vehicle is operated in a dusty and off road environ-
ment. This type of vehicle use is considered Severe
Duty
Once A Month Or Before A Long Trip:
• Check engine oil level
• Check windshield washer fluid level •
Check tire pressure and look for unusual wear or dam-
age. Rotate tires at the first sign of irregular wear, even if
it occurs before the oil indicator system turns on.
• Check the fluid levels of the coolant reservoir, brake
master cylinder, power steering (2500/3500 Models
Only) and automatic transmission (six-speed only) as
needed
• Check function of all interior and exterior lights
8
M
A I
N T
E
N
A
N
C E
S
C
H E
D
U L
E
SMAINTENANCE SCHEDULES 751

Adding Engine Coolant (Antifreeze)............699
Adding Fuel ............................ .577
Additives, Fuel .......................... .571
Adjustable Pedals ........................ .180
Airbag ..................................67
Airbag Deployment ........................78
Airbag Light .............................74
Airbag Maintenance ........................79
Airbag, Side ..............................70
Airbag, Window (Side Curtain) ................71
Air Cleaner, Engine (Engine Air Cleaner Filter) . . . .689
Air Conditioner Maintenance .................691
Air Conditioning ......................... .356
Air Conditioning Controls ...................356
Air Conditioning Refrigerant .................691
Air Conditioning System ....................356
Air Pressure, Tires ........................ .541
Air Suspension .......................... .451
Alarm Light ............................ .283Alarm, Panic
.............................27
Alarm (Security Alarm) ......................21
Alarm System (Security Alarm) ................21
Alterations/Modifications, Vehicle ...............7
Antifreeze (Engine Coolant) ..................698
Disposal ............................. .701
Anti-Lock Brake System (ABS) ................517
Anti-Lock Warning Light ....................278
Appearance Care ........................ .712
Ashtray ............................... .224
Auto Down Power Windows ..................46
Automatic Door Locks ......................39
Automatic Headlights ..................... .163
Automatic Transmission ....................397
Adding Fluid ..........................711
Fluid and Filter Changes ..................712
Fluid Change ......................... .712
Fluid Level Check ...................... .708
Fluid Type ........................... .708
770 INDEX

Malfunction Indicator Light (Check Engine).......682
Manual, Service ......................... .766
Manual Transmission Fluid Level Check ...................... .708
Lubricant Selection ..................... .746
Memory Seat ........................... .156
Methanol .............................. .569
Mirrors ............................... .128
Electric Powered ....................... .137
Heated .............................. .139
Memory ............................. .156
Outside ............................. .135
Rearview ............................ .128
Trailer Towing ........................ .141
Modifications/Alterations, Vehicle ...............7
Monitor, Tire Pressure System ................557
Mopar Parts ............................ .683
MTBE/ETBE ........................... .569
Multi-Function Control Lever .................172Navigation System (Uconnect® gps)
............202
New Vehicle Break-In Period .................114
Occupant Restraints ........................49
Occupant Restraints (Sedan) ..................70
Octane Rating, Gasoline (Fuel) ................568
Off-Pavement Driving (Off-Road) ..............466
Off-Road Driving (Off-Pavement) ..............466
Oil, Engine ............................. .685
Capacity ............................ .742
Change Interval ....................... .686
Dipstick ............................. .685
Disposal ............................. .688
Filter ............................... .688
Filter Disposal ........................ .688
Identification Logo ..................... .686
Recommendation ...................... .686
Synthetic ............................ .688
V

iscosity ............................ .687
Oil Filter, Selection ....................... .688
10
INDEX 779