check Ram 2500 2016 Diesel Supplement

LightsAirBag ............................. .191
Brake Warning ........................ .192
Cruise .......................... .223 , 225
Engine Temperature Warning ...............195
Fog .................................211
Low Fuel ............................ .209
Malfunction Indicator (Check Engine) .........202
Park ............................ .221 , 223
Seat Belt Reminder ..................... .190
Security Alarm ........................ .194
Tire Pressure Monitoring (TPMS) ............206
Turn Signal .......................... .222
Warning (Instrument Cluster Description) . .195 , 222
Maintenance Procedures ....................335
Maintenance Schedule ..................... .380
Malfunction Indicator Light (Check Engine) .......202
Manual Transmission ..................... .298Fluid Level Check
...................... .362
Shift Speeds .......................... .300
New Vehicle Break-In Period .................173
Noise Control Maintenance .......................... .367
Tampering Prohibited ....................368
Noise Emission Warranty ....................366
Oil Change Indicator ...................... .381
Oil Pressure Light ........................ .197
Oil, Engine ............................. .336
Capacity ............................ .373
Change Interval ....................... .337
Dipstick ............................. .336
Disposal ............................. .340
Filter ........................... .340 , 374
Filter Disposal ........................ .340
Identification Logo ..................... .337
8
INDEX - RAM 2500 / 3500 / 4500 / 5500 399

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.