remote start Ram 3500 2016 Diesel Supplement

Remote Start Comfort Systems — If Equipped
When remote start is activated, the heated steering
wheel, and driver heated seat features will automatically
turn on in cold weather. In warm weather, the driver
vented seat feature will automatically turn on when the
remote start is activated. These features will stay on
through the duration of remote start or until the ignition
switch is turned to the ON position.
The Remote Start Comfort System can be activated and
deactivated through the EVIC/DID. For more informa-
tion on Remote Start Comfort System operation refer to
your Owners Manual.
ENGINE BREAK-IN RECOMMENDATIONS
The Cummins turbocharged diesel engine does not re-
quire a break-in period due to its construction. Normal
operation is allowed, providing the following recommen-
dations are followed:•
Warm up the engine before placing it under load.
• Do not operate the engine at idle for prolonged
periods.
• Use the appropriate transmission gear to prevent
engine lugging.
• Observe vehicle oil pressure and temperature indica-
tors.
• Check the coolant and oil levels frequently.
• Vary throttle position at highway speeds when carry-
ing or towing significant weight.
NOTE: Light duty operation such as light trailer towing
or no load operation will extend the time before the
engine is at full efficiency. Reduced fuel economy and
power may be seen at this time.
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 141

•Unstored Messages Until RUN
These messages deal primarily with the Remote Start
feature. This message type is displayed until the ignition
is in the RUN state. Examples of this message type are
“Remote Start Aborted - Door Ajar” and “Press Brake
Pedal and Push Button to Start”.
• Five Second Unstored Messages
When the appropriate conditions occur, this type of
message takes control of the main display area for five
seconds and then returns to the previous screen. An
example of this message type is “Automatic High Beams
On”.
Diesel Indicator Lights
This area will show reconfigurable amber telltales that
relate to your diesel. These telltales include:
NOTE: “Refer to your OM on DVD for additional telltale
information” Water In Fuel Indicator Light
The “Water In Fuel Indicator Light” will illu-
minate when there is water detected in the fuel
filters. If this light remains on, DO NOT start
the vehicle before you drain the water from the
fuel filters to prevent engine damage. Refer to “Mainte-
nance Procedures/Draining Fuel/Water Separator Fil-
ters” in “Maintaining Your Vehicle” for further informa-
tion.
Wait To Start Light
The “Wait To Start” telltale will illuminate for
approximately two seconds when the ignition is
turned to the RUN position. It’s duration may be longer
based on colder operating conditions. Vehicle will not
initiate start until telltale is out. Refer to “Starting Proce-
dures” in “Starting And Operating” for further informa-
tion.
4
UNDERSTANDING YOUR INSTRUMENT PANEL 175

starting the vehicle. This vehicle is equipped with a
clutch interlocking ignition system. It will not start unless
the clutch is fully pressed.
Automatic Transmission — If Equipped
Start the engine with the transmission in the NEUTRAL
or PARK position. Apply the brake before shifting to any
driving range.
Tip Start Feature
Do notpress the accelerator. Turn the ignition switch
briefly to the START position and release it. The starter
motor will continue to run but will automatically disen-
gage when the engine is running.
Keyless Enter-N-Go — If Equipped
This feature allows the driver to oper-
ate the ignition switch with the push
of a button, as long as the Remote
Start/Keyless Enter-N-Go Key Fob is
in the passenger compartment.
Normal Starting
Using The ENGINE START/STOP Button
1. The transmission must be in PARK or NEUTRAL.
2. Press and hold the brake pedal while pushing the ENGINE START/STOP button once.
3. The system takes over and attempts to start the vehicle. If the vehicle fails to start, the starter will
disengage automatically after 25 seconds.
5
STARTING AND OPERATING 197

less than engine speed when the torque converter clutch
is not engaged and will be same as engine speed when
the torque converter clutch is engaged.
Stationary Mode
To operate the PTO in this mode the vehicle must meet
the following conditions:
•Be in PARK position (vehicles equipped with auto-
matic transmission.)
• PTO switch has been activated.
• Parking brake applied (vehicles equipped with
manual transmission).
• Brake pedal must not be applied.
• Vehicle engine must be running.
• No vehicle, brake or clutch switch faults present. •
PTO must be correctly installed using the vehicle
provided circuits.
The Electronic Vehicle Information Center (EVIC) or
Driver Information Display (DID) will display a PTO
On message for five seconds if the above conditions are
met. Otherwise, the EVIC/DID will display a message
To Operate PTO Shift To Park indicating what operator
action should be taken to engage the PTO mode.
The customer has the choice to operate the PTO by
utilizing the cruise control switches or by utilizing a
remote control (provided by the PTO supplier). To oper-
ate the feature using the cruise control switches, the
customer must first activate the PTO switch which will
turn on the PTO. In order to increase or decrease the
engine idle speed, to optimize the PTO function, the
“RESUME/ACCEL” and “DECEL” cruise switches can
240 STARTING AND OPERATING

be used respectively. To disengage PTO operation and
return to “standard vehicle operation” simply toggle the
PTO switch to the OFF position.
The torque converter clutch (TCC) will automatically
engage at engine speeds above 1,200 RPM (engine speed)
in PTO stationary mode. Once engaged, the TCC will
remain applied and will not disengage until the engine
speed falls below 1,000 RPM. TCC engagement is desir-
able for certain types of PTO applications (Automatic
Transmission Only).
To operate the PTO via a remote switch, the customer
must make sure the above conditions are met. It is vital
for proper operation that the PTO and remote have been
installed correctly, paying special attention to ensure the
vehicle provided wiring has been connected properly.
This is the responsibility of the installer of the PTO and
switches/remote system. It is the responsibility of the
PTO manufacturer to ensure that their electrical (switchesand remote) system is compatible with the vehicle’s
electrical architecture and software functionality.
NOTE:
Single set speed can be programmed via the PTO
menu on the EVIC/DID screen. Further details are avail-
able at the Ram Truck Bodybuilders web site located
at
www.rambodybuilder.com.
Mobile Mode
To operate the PTO in this mode the vehicle must meet
the following conditions:
• Mobile mode is activated via the menu on the EVIC/
DID screen.
• (ON/OFF) switch has been activated.
• Vehicles with automatic transmission must be in PARK
or DRIVE.
• Parking brake must not be applied.5
STARTING AND OPERATING 241

Information Center, Vehicle...................25
Instrument Cluster .........................16
Intervention Regeneration Strategy ..............32
Keyless Enter-N-Go ........................65
Maintenance Procedures .....................91
Maintenance Schedule ..................... .120
New Vehicle Break-In Period ..................13
Oil, Engine ...............................92
Capacity ..............................113
Change Interval .........................93
Dipstick ...............................92
Disposal ..............................94 Filter
.............................94,114
Filter Disposal ..........................94
Materials Added To ......................94
Recommendation ........................92
Viscosity ..............................93
Radiator Cap (Coolant Pressure Cap) ...........105
Remote Starting System ......................12
Schedule, Maintenance .....................120
Selection Of Coolant (Antifreeze) ..............114
Starting .................................63
Automatic Transmission ...................64
Engine Block Heater ...................66,73
Remote ...............................12
Starting Procedures .........................63
Starting Procedures (Diesel Engines) .............63
328 INDEX - RAM 1500

Noise Emission Warranty....................303
Oil Change Indicator ...................... .314
Oil, Engine ............................. .271
Capacity ............................ .308
Change Interval ....................... .273
Dipstick ............................. .271
Disposal ............................. .276
Filter ........................... .276 , 309
Filter Disposal ........................ .276
Identification Logo ..................... .273
Materials Added To ..................... .275
Recommendation ...................... .273
Synthetic ............................ .275
Viscosity ............................ .274
Overdrive .............................. .232
Overdrive OFF Switch ..................... .232
Perform Service Indicator, Reset ...............316Power
Take-Off Adapter ...................... .239
Take-Off Operation ..................... .239
PTO (Power Take-Off) ..................... .239
Radiator Cap (Coolant Pressure Cap) ...........291
Remote Starting System .....................138
Resetting Perform Service Indicator ............316
Selection Of Coolant (Antifreeze) ..............309
Shifting ............................... .220
Automatic Transmission ..................222
Manual Transmission ....................234
Speed Control Accel/Decel .......................... .147
Cancel .............................. .146
Speed Control (Cruise Control) ................144
Starting ............................... .196
Automatic Transmission ..................197
8
INDEX - RAM 2500 / 3500 / 4500 / 5500 333

Engine Block Heater.................202 , 217
Manual Transmission ....................196
Remote ............................. .138
Starting Procedures ....................... .196
Starting Procedures (Diesel Engines) ............196
Synthetic Engine Oil ...................... .275
Tip Start ............................... .197
Torque Converter Clutch ....................233
Traction Control ......................... .298
Transfer Case Fluid ................................311 Transmission
Automatic ........................... .222
Fluid ................................311
Manual ......................... .196 , 234
Shifting ............................. .220
Viscosity, Engine Oil ...................... .274
Voltmeter .............................. .208
Water Separator, Diesel Fuel ..................280
334 INDEX - RAM 2500 / 3500 / 4500 / 5500