wiring Ram 3500 2016 User Guide

Load Capacity..................... .643, 644
Pressure Monitor System (TPMS) ............666
Pressure Warning Light ...................311
Quality Grading ....................... .891
Radial .............................. .651
Replacement .......................... .658
Rotation ............................. .663
Safety ........................... .636, 648
Sizes ............................... .638
Snow Tires ........................... .653
Spare Tire ........................ .654, 656
Spinning ............................ .657
Tread Wear Indicators ....................657
Tire Safety Information .....................636
Tongue Weight/Trailer Weight ................698
Tonneau Cover .......................... .840
Tonneau Cover Cleaning ....................840
Torque Converter Clutch .................510, 521
Tow Hooks, Emergency .....................777 Towing
............................ .689, 782
Disabled Vehicle ....................... .782
Guide .............................. .698
Recreational .......................... .716
Weight .............................. .698
Towing Vehicle Behind A Motorhome ...........716
Traction ............................... .590
Traction Control ......................... .626
Trailer Sway Control (TSC) ..................632
Trailer Towing .......................... .689
Cooling System Tips .....................710
Hitches ............................. .697
Minimum Requirements ..................699
Mirrors ............................. .144
Trailer And Tongue Weight ................698
Wiring .............................. .708
T

railer Towing Guide ...................... .698
Trailer Weight ........................... .698
Transfer Case ........................... .82910
INDEX 913

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.