fuel cap Ram 3500 2018 Quick Reference Guide

Adding Diesel Fuel And Diesel
Exhaust Fluid (DEF)• Ensure appropriate fluid is added to theapplicable fill port on the vehicle. The
smaller blue capped fill port is for DEF. The
cap-less green fill port is for diesel fuel only.
• If DEF or gasoline is accidentally added to the diesel fuel tank, DO NOT START the
engine. This will result in severe damage to
your engine, which is not covered by your
New Vehicle Limited Warranty. Have your
RAM towed to your authorized dealer for
service.
For further information, and applicable warnings
and cautions, please refer to the Diesel Supplement
at
www.mopar.com/en-us/care/owners-manual.html
(U.S. Residents) orwww.owners.mopar.ca (Cana-
dian Residents).
DIESEL ENGINE STARTING
• Your RAM is equipped with state-of-the-art
ceramic glow plugs to ensure quick starts.
• Some delay of engine cranking may occur while the glow plugs reach operating tem-
perature. The length of time will vary from
1 to 5 seconds depending on the engine and
ambient temperatures.
• Remote start operation of your vehicle will also automatically activate the glow plugs as
needed and no additional steps are required.
With Engine ST ART/STOP Button
• To start your engine, press and hold the
brake pedal while pressing the ENGINE
START/STOP button once.
• When the “Wait to Start” telltale goes out in the instrument cluster, engine cranking will
begin automatically.
Fill Locations
1 — Diesel Exhaust Fluid (DEF) Fill
Location
2 — Diesel Fuel Fill Location
ADDING DIESEL FUEL AND
DEF RAM 1500 3.0L DIESEL

• There is an electric heater inside the DEFtank that automatically works when neces-
sary. And if the DEF supply does freeze, the
truck will operate normally until it thaws.
• Ensure the DEF cap is reinstalled prior to filling vehicle with diesel fuel to avoid spill-
ing diesel fuel into the DEF Filler.
AUXILIARY SWITCHES
There can be up to five auxiliary switches located
in the lower switch bank of the instrument panel,
which can all be used to power various electronic
devices and PTO (Power Take Off) – if equipped.
Connections to the switches are found under the
hood in the connectors attached to the auxiliary
Power Distribution Center.
The system has the ability to configure the
functionality of the auxiliary switches via the
Instrument Cluster Display. All switches can
now be configured for ignition or battery power,
saving or not saving the state across a key cycle,
and momentary or latching switch operation. For further information on using the auxiliary
switches, please refer to the Ram Body Builders
Guide by accessing
www.rambodybuilder.com
and choosing the appropriate links.
For general questions on upfitting commercial
vehicles, including:
• Loose rear park assist installation
• Programmable auxiliary switches
• PTO (Power Take Off) system
• Wiring diagrams
• Vehicle dimensions
• Snow plow installation
• Weight charts and trailer towing
Please consult the Body Builders Guide at
www.rambodybuilder.com.For further information, and applicable warnings
and cautions, please refer to the Owner’s Manual at
www.mopar.com/en-us/care/owners-manual.html
(U.S. Residents) or www.owners.mopar.ca (Cana-
dian Residents).
USB Port
Uconnect Media Hub
1 — USB Port
2 — AUX Jack
3 — USB Port
FRONT USB PORT/AUDIO
JACK (AUX) PORT