lock Ram 5500 Chassis Cab 2011 Owner's Manual

When changing a rear wheel, assemble the jack drive
tube to the jack and connect the drive tube to the
extension tube. Securely place the jack under the sway
bar bracket (unless both tires are flat on one side, then
place jack under shock bracket) facing forward in vehicle.
Connect the jack tube extension and lug wrench.Before raising the wheel off the ground, make sure that
the jack will not damage surrounding truck parts and
adjust the jack position as required.
NOTE:
If the jack will not lower by turning the dial
(thumbwheel) by hand, it may be necessary to use the
jack drive tube in order to lower the jack.
4. By rotating the wheel wrench clockwise, raise the
vehicle until the wheel just clears the surface.
WARNING!
Raising the vehicle higher than necessary can make
the vehicle unstable and cause an accident. It could
slip off the jack and hurt someone near it. Raise the
vehicle only enough to remove the tire.
Rear Jacking Location
6
WHAT TO DO IN EMERGENCIES 363

5. Remove the wheel nuts and pull the wheel off. Install
the spare wheel and wheel nuts with the cone shaped end
of the nuts toward the wheel on single rear wheel (SRW)
models. On dual rear wheel models (DRW) the lug nuts
are a two-piece assembly with a flat face. Lightly tighten
the nuts. To avoid risk of forcing the vehicle off the jack,
do not fully tighten the nuts until the vehicle has been
lowered.
6. Using the wheel wrench, finish tightening the nuts
using a crisscross pattern. The correct nut tightness is
135 ft lbs (183 N·m) torque for single rear wheel (SRW)
models and 145 ft lbs (197 N·m) for dual rear wheel
models. If in doubt about the correct tightness, have them
checked with a torque wrench by your authorized dealer
or at a service station.WARNING!
A loose tire or jack thrown forward in a collision or
hard stop could injure someone in the vehicle. Al-
ways stow the jack parts and the extra tire and wheel
in the places provided.
7. Install wheel center cap (if equipped) and remove
wheel blocks. Do not install chrome or aluminum wheel
center caps on the spare wheel. This may result in cap
damage.
8. Lower the jack to its fully closed position. If the jack
will not lower by turning the dial (thumbwheel) by hand,
it may be necessary to use the jack drive tube in order to
lower the jack. Stow the replaced tire, jack, and tools as
previously described.
9. Adjust the tire pressure when possible.
364 WHAT TO DO IN EMERGENCIES

Preparations for Jump-Start
The battery in your vehicle is located in the front of the
engine compartment, behind the left headlight assembly.
NOTE:The positive battery post is covered with a
protective cap. Lift up on the cap to gain access to the
positive battery post.WARNING!
•Take care to avoid the radiator cooling fan when-
ever the hood is raised. It can start anytime the
ignition switch is on. You can be injured by
moving fan blades.
•Remove any metal jewelry such as watch bands or
bracelets that might make an inadvertent electrical
contact. You could be seriously injured.
•Batteries contain sulfuric acid that can burn your
skin or eyes and generate hydrogen gas which is
flammable and explosive. Keep open flames or
sparks away from the battery.
1. Set the parking brake, shift the automatic transmission
into PARK and turn the ignition to LOCK.
2. Turn off the heater, radio, and all unnecessary electri-
cal accessories.
Positive Battery Post
6
WHAT TO DO IN EMERGENCIES 371

Body Lubrication
Locks and all body pivot points, including such items as
seat tracks, door hinge pivot points and rollers, liftgate,
tailgate, sliding doors and hood hinges, should be lubri-
cated periodically with a lithium based grease, such as
MOPARSpray White Lube or equivalent, to assure
quiet, easy operation and to protect against rust and
wear. Prior to the application of any lubricant, the parts
concerned should be wiped clean to remove dust and
grit. After lubricating, excess oil and grease should be
removed. Particular attention should also be given to
hood latching components to ensure proper function.
When performing other underhood services, the hood
latch, release mechanism and safety catch should be
cleaned and lubricated.
The external lock cylinders should be lubricated twice a
year, preferably in the Fall and Spring. Apply a small amount of a high quality lubricant such as MOPAR
Lock Cylinder Lubricant or equivalent directly into the
lock cylinder.
Windshield Wiper Blades
Clean the rubber edges of the wiper blades and the
windshield periodically with a sponge or soft cloth and a
mild nonabrasive cleaner. This will remove accumula-
tions of salt or road film.
Operation of the wipers on dry glass for long periods
may cause deterioration of the wiper blades. Always use
washer fluid when using the wipers to remove salt or dirt
from a dry windshield.
Avoid using the wiper blades to remove frost or ice from
the windshield. Keep the blade rubber out of contact with
petroleum products such as engine oil, gasoline, etc.
NOTE:
Life expectancy of wiper blades varies depend-
ing on geographical area and frequency of use. Poor
392 MAINTAINING YOUR VEHICLE

Cavity CartridgeFuseMini
Fuse Description
J03 25 Amp Natural Bat – Passenger Door
Node
J04 40 Amp Green Bat – ABS Pump
J05 30 Amp Pink Bat – ABS Valve
J06 30 Amp Pink Bat – H/Lamp Wash/
MTV/CM2200/Elec
Vac Pump
J07 25 Amp Natural Bat – Driver Door
Node
J08 30 Amp Pink Bat – DTCM/Axle
Locks
J09 30 Amp Pink Bat – Plg/Electric
Brake
J10 40 Amp Green Bat – L/Bar/Off-RoadCavity Cartridge
FuseMini
Fuse Description
J11 30 Amp Pink Bat – Sway/
Thatchum/Rear
Doors
J12 40 Amp Green Starter Solenoid
J13 60 Amp Yellow Bat – Rad Fan #1/#2/
SSR
J14 40 Amp Green Bat – Folding Seat/
PZEV
J15 60 Amp Yellow Bat – IOD Main
J16 40 Amp Green Frt HVAC Motor
M17 25 Amp
NaturalBat – Sunroof/
Skylight
M18 25 Amp
NaturalTCM/Trans Range
7
MAINTAINING YOUR VEHICLE 415

Cavity CartridgeFuseMini
Fuse Description
M19 5 Amp
Ta nIgn R/ACC –
Sunroof/Window Sw
Illum
M20 25 Amp
NaturalFrt Wiper
M21 25 Amp
NaturalDoor Locks
M22 20 Amp
YellowFuel Pump
M23 20 Amp
YellowBat – Trlr Light/Pre-
Safe #2
M24 20 Amp
YellowBat – Trlr Tow BUX/
HGM
M25 10 Amp
RedBat – J1962 Diag/
Mirrors
M26 10 Amp
RedBat – Ign Sw, WIN,
PASSCavity Cartridge
FuseMini
Fuse Description
M27 15 Amp
BlueBat – CHMSL/Brake
Sw
M28 10 Amp
RedBat – Corax TPM/
PEM/HVAC Htr
Pump
M29 15 Amp
BlueBat – Folding Mirror
M30 25 Amp
NaturalBat – Inverter
M31 20 Amp
YellowBat – Pwr Out #1
M32 20 Amp
YellowFr/Rr Washer
M33 15 Amp
BlueBat – NGC/EATX/
PCM
M34 15 Amp
BlueBat – CCN/Interior
Light/SCM/Sw Bank
416 MAINTAINING YOUR VEHICLE

VEHICLE STORAGE
If you are storing your vehicle for more than 21 days, we
recommend that you take the following steps to mini-
mize the drain on your vehicle’s battery:
•Disconnect the Ignition-Off Draw (IOD) fuse located in
the Integrated Power Module, located in the engine
compartment. The IOD cavity includes a snap-in re-
tainer that allows the fuse to be disconnected without
removing it from the fuse block.
•As an alternative to the above steps you may discon-
nect the negative cables from both batteries.
•Any time you store your vehicle or keep it out of
service (i.e., vacation) for two weeks or more, run the
air conditioning system at idle for about five minutes
in the fresh air and high blower setting. This will
ensure adequate system lubrication to minimize the
possibility of compressor damage when the system is
started again.NOTE:
•When reinstalling the IOD fuse push firmly until fully
seated; the gauges in the instrument cluster will do a
full sweep when the ignition switch is turned to the
RUN position. This is a normal condition.
•When the vehicle is shipped from the factory, the IOD
fuse is in the up or extracted position. If the radio,
interior lamps, keyless entry or other features do not
work with the key OFF, check the position of the fuse
(or check to see if the fuse is blown) to ensure that it is
fully seated. When the IOD fuse is extracted, the
instrument cluster in the odometer window will dis-
play
NO FUSE.”
7
MAINTAINING YOUR VEHICLE 419

7. Reach into the front wheel house ahead of the front
wheel, remove the fastener, and lift the cover over the
access hole in the front of the wheel house splash shield.
Access to the rear of the lamp can be gained through this
access hole.8. Reach through the access hole of the wheel house
splash shield and lift the slide lock upward far enough to
disengage it from the lock post on the back of the front
lamp unit housing.
9. Remove the headlamp assembly. Grasp the outboard
edge of the lamp and pull it straight forward to disen-
gage the ball stud from the plastic grommet.
7
MAINTAINING YOUR VEHICLE 421

10. Disconnect electrical connectors.
11. Replace bulb(s) as necessary.
CAUTION!
•Do not contaminate the bulb glass by touching it
with your fingers or by allowing it to contact other
oily surfaces. Shortened bulb life will result.
•Always use the correct bulb size and type for
replacement. An incorrect bulb size or type may
overheat and cause damage to the lamp, the bulb
socket, or the lamp wiring.
NOTE: There are access covers over both headlamp
bulb access holes in the quad front lamp unit housing (if
equipped). These covers MUST be reinstalled after the
bulb has been replaced.
Fog Lamps – If Equipped
1. Reach under and behind the front bumper to access
the back of the front fog lamp housing.
2. Disconnect the fog lamp wiring harness connector
from the fog lamp bulb.
3. Rotate the bulb counterclockwise
14turn to unlock the
bulb from the housing.
4. Pull the bulb straight out from the housing.
CAUTION!
Do not contaminate the bulb glass by touching it
with your fingers or by allowing it to contact other
oily surfaces. Shortened bulb life will result.
422 MAINTAINING YOUR VEHICLE

Adding Fuel........................... 326
Adjustable Pedals ....................... 148
Air Cleaner, Engine (Engine Air Cleaner Filter) . . . 388
Air Conditioner Maintenance ............... 390
Air Conditioning ........................ 249
Air Conditioning Controls ................. 249
Air Conditioning, Operating Tips ............ 260
Air Conditioning Refrigerant .............390,391
Air Conditioning System .............249,253,390
Air Pressure, Tires .................... 308,317
Airbag ................................ 50
Airbag Deployment ....................... 56
Airbag Light ................... 51,55,59,75,191
Airbag Maintenance ....................... 58
Airbag, Side ............................ 54
Airbag, Window (Side Curtain) ............... 54
Alarm Light ........................... 183
Alarm, Panic ............................ 24
Alarm (Security Alarm) .................... 18 Alarm System (Security Alarm)
............... 18
Alterations/Modifications, Vehicle ............. 7
Antenna, Satellite Radio ................... 243
Antifreeze (Engine Coolant) ..............397,398
Capacities ........................... 426
Disposal ............................ 400
Anti-Lock Warning Light ...............191,296
Anti-Theft Security Alarm (Theft Alarm) ........ 18
Anti-Theft System ........................ 18
Appearance Care ........................ 409
Ashtray ............................... 159
Assistance Towing ....................... 102
Auto Down Power Windows ................ 35
Automatic Dimming Mirror ................. 82
Automatic Headlights .................... 139
Automatic Temperature Control (ATC) ......... 253
Automatic Transmission Adding Fluid ......................... 407
Fluid and Filter Changes ................. 408
458 INDEX