cluster Ram ProMaster 2014 Owner's Guide

functions similarly to a limited-slip differential, and
controls the wheel spin across a driven axle. If one wheel
on a driven axle is spinning faster than the other, the
system will apply the brake of the spinning wheel. This
will allow more engine torque to be applied to the wheel
that is not spinning. This feature remains active even if
the ESC is in the “Partial Off” mode.
The “ESC Activation/Malfunction Indicator Light” (in
the instrument cluster) will start to flash as soon as the
tires lose traction and the wheels begin to spin. This
indicates that the TCS is active. If the indicator light
flashes during acceleration, ease up on the accelerator
and apply as little throttle as possible. Be sure to adapt
your speed and driving to the prevailing road conditions,
and do not switch off the ESC or TCS.WARNING!
•The TCS cannot prevent the natural laws of physics
from acting on the vehicle, nor can it increase the
traction afforded.
• The TCS cannot prevent collisions, including those
resulting from excessive speed in turns, or hydro-
planing.
• The capabilities of a TCS-equipped vehicle must
never be exploited in a reckless or dangerous
manner, which could jeopardize the user’s safety or
the safety of others.
5
STARTING AND OPERATING 217

WARNING!(Continued)
•Trailer Sway Control (TSC) is disabled when the
ESC system is in the Partial Offmode.
NOTE: To improve the vehicle’s traction when driving
with snow chains, or starting off in deep snow, sand or
gravel, it may be desirable to switch to the “Partial Off”
mode by pressing the “ESC Off” switch. Once the situa-
tion requiring ESC to be switched to the “Partial Off”
mode is overcome, turn ESC back on by momentarily
pressing the “ESC Off” switch. This may be done while
the vehicle is in motion.
ESC Activation/Malfunction Indicator Light And
ESC OFF Indicator Light
The “ESC Activation/Malfunction Indicator
Light” in the instrument cluster will come on
when the ignition switch is turned to the ON
position. It should turn off with the engine running. If the “ESC Activation/Malfunction Indicator
Light” comes on continuously with the engine running, a
malfunction has been detected in the ESC system. If this
light remains on after several ignition cycles, and the
vehicle has been driven several miles (kilometers) at
speeds greater than 30 mph (48 km/h), see your autho-
rized dealer as soon as possible to have the problem
diagnosed and corrected.
The “ESC Activation/Malfunction Indicator Light” (lo-
cated in the instrument cluster) starts to flash as soon as
the tires lose traction and the ESC system becomes active.
The “ESC Activation/Malfunction Indicator Light” also
flashes when TCS is active. If the “ESC Activation/
Malfunction Indicator Light” begins to flash during ac-
celeration, ease up on the accelerator and apply as little
throttle as possible. Be sure to adapt your speed and
driving to the prevailing road conditions.
5
STARTING AND OPERATING 221

Under-inflation also reduces fuel efficiency and tire
tread life, and may affect the vehicle’s handling and
stopping ability.
• The TPMS is not a substitute for proper tire mainte-
nance, and it is the driver ’s responsibility to maintain
correct tire pressure using an accurate tire gauge, even
if under-inflation has not reached the level to trigger
illumination of the Tire Pressure Monitoring Telltale
Light.
• Seasonal temperature changes will affect tire pressure,
and the TPMS will monitor the actual tire pressure in
the tire.Base System
This is the TPMS warning indicator located in the
instrument cluster.
The TPMS uses wireless technology with wheel rim
mounted electronic sensors to monitor tire pressure levels.
Sensors, mounted to each wheel as part of the valve stem,
transmit tire pressure readings to the Receiver Module.
NOTE: It is particularly important for you to check the
tire pressure in all of the tires on your vehicle regularly
and to maintain the proper pressure.
The TPMS consists of the following components:
• Receiver Module.
• Four Tire Pressure Monitoring Sensors.
• Tire Pressure Monitoring Telltale Light.
252 STARTING AND OPERATING

Tire Pressure Monitoring Low Pressure Warnings
The Tire Pressure Monitoring Telltale Light will illumi-
nate in the instrument cluster, an audible chime will be
activated, and the “Check tire pressure” text message will
display when one or more of the four active road tire
pressures are low. Should this occur, you should stop as
soon as possible, check the inflation pressure of each tire
on your vehicle, and inflate each tire to the vehicle’s
recommended cold placard pressure value. The system
will automatically update and the Tire Pressure Monitor-
ing Light will extinguish once the updated tire pressures
have been received. The vehicle may need to be driven
for up to 20 minutes above 15 mph (24 km/h) to receive
this information.
Check TPMS Warnings
The Tire Pressure Monitoring Telltale Light will flash on
and off for 75 seconds and remain on solid when a system
fault is detected, an audible chime will be activated and
the “Tire Pressure Monitoring Unavailable” text message
will display. If the ignition key is cycled, this sequence
will repeat providing the system fault still exists. The Tire
Pressure Monitoring Telltale Light will turn off when the
fault condition no longer exists. A system fault can occur
with any of the following scenarios:
1. Jamming due to electronic devices or driving next tofacilities emitting the same radio frequencies as the
TPM sensors.
2. Installing some form of aftermarket window tinting that affects radio wave signals.
3. Snow or ice around the wheels or wheel housings.
5
STARTING AND OPERATING 253

When cleaning the rear view mirror, spray cleaner on the
towel or rag that you are using. Do not spray cleaner
directly on the mirror.
Cleaning Plastic Instrument Cluster Lenses
The lenses in front of the instruments in this vehicle are
molded in clear plastic. When cleaning the lenses, care
must be taken to avoid scratching the plastic.
1. Clean with a wet soft rag. A mild soap solution may beused, but do not use high alcohol content or abrasive
cleaners. If soap is used, wipe clean with a clean damp
rag.
2. Dry with a soft cloth.
Seat Belt Maintenance
Do not bleach, dye, or clean the belts with chemical
solvents or abrasive cleaners. This will weaken the fabric.
Sun damage can also weaken the fabric. If the belts need cleaning, use MOPAR® Total Clean, a
mild soap solution, or lukewarm water. Do not remove
the belts from the vehicle to wash them. Dry with a soft
cloth.
Replace the belts if they appear frayed or worn or if the
buckles do not work properly.
WARNING!
A frayed or torn belt could rip apart in a collision and
leave you with no protection. Inspect the belt system
periodically, checking for cuts, frays, or loose parts.
Damaged parts must be replaced immediately. Do
not disassemble or modify the system. Seat belt
assemblies must be replaced after a collision if they
have been damaged (i.e., bent retractor, torn web-
bing, etc.).
354 MAINTAINING YOUR VEHICLE

Switch................................91
Head Restraints ...........................86
Heated Mirrors ............................74
Heated Seats .............................85
Heater ................................ .186
Heater, Engine Block ...................... .196
High Beam/Low Beam Select (Dimmer) Switch .....93
Hill Start Assist .......................... .223
Hitches Trailer Towing ........................ .267
Hood Release .............................88
Ignition .................................12
Key..................................12
Ignition Key Removal .......................12
Illuminated Entry ..........................18
Immobilizer (Sentry Key) ....................15
Infant Restraint ...........................52
Inside Rearview Mirror ......................72 Instrument Cluster
....................... .127
Instrument Panel and Controls ................125
Instrument Panel Cover .....................352
Instrument Panel Lens Cleaning ...............354
Interior Appearance Care ....................352
Intermittent Wipers (Delay Wipers) .............98
Introduction ..............................4
Jump Starting ........................... .308
Key-In Reminder ..........................14
Key, Replacement ..........................16
Keys ...................................12
Key, Sentry (Immobilizer) ....................15
Lane Change Assist ........................93
Lap/Shoulder Belts .........................28
Latches .................................68
Lead Free Gasoline ....................... .255
398 INDEX

Leaks, Fluid..............................68
Life of Tires ............................ .244
Light Bulbs ..............................67
Lights ..................................67
Airbag ................................45
Anti-Lock ............................ .141
Brake Assist Warning ....................221
Brake Warning ........................ .132
Bulb Replacement ...................... .366
Check Engine (Malfunction Indicator) .........133
Cruise .............................. .131
Daytime Running ........................92
Dimmer Switch, Headlight .................90
Electronic Stability Program (ESP) Indicator .....221
Engine Temperature Warning ...............136
Exterior ...............................67
Fog ................................ .128
Hazard Warning Flasher ..................283
Headlights .............................91 High Beam
............................93
High Beam Indicator .....................128
Illuminated Entry ........................18
Instrument Cluster ..................... .128
Lights On Reminder ......................92
Low Fuel ............................ .137
Map Reading ...........................95
Oil Pressure .......................... .131
Park .................................93
Passing ...............................94
Seat Belt Reminder ..................... .140
Service .............................. .366
Tire Pressure Monitoring (TPMS) ............138
Traction Control ....................... .221
Turn Signal ............................67
Wait to Start .......................... .130
Warning (Instrument Cluster Description) ......128
Loading Vehicle ......................... .262
Capacities ........................... .264
10
INDEX 399

Traction Control......................... .216
Traction Control Switch .....................216
Trailer Sway Control (TSC) ..................222
Trailer Towing .......................... .264
Cooling System Tips .....................279
Hitches ............................. .267
Minimum Requirements ..................272
Tips................................ .278
Trailer and Tongue Weight .................271
Wiring .............................. .276
Trailer Towing Guide ...................... .268
Trailer Weight ........................... .268
Transaxle Automatic .............................12
Transmission Automatic ........................... .196
Fluid ............................... .346
Transmitter Battery Service (Remote Keyless Entry) . .20
Tread Wear Indicators ..................... .244Trip Odometer
.......................... .129
Turn Signals ............................ .128
Uniform Tire Quality Grades .................389
Unleaded Gasoline ....................... .255
Untwisting Procedure, Seat Belt ................33
Upholstery Care ......................... .352
Vehicle Certification Label ...................262
Vehicle Identification Number (VIN) .............6
Vehicle Loading ......................... .232
Vehicle Modifications/Alterations ...............7
Vehicle Storage .......................... .365
Viscosity, Engine Oil ...................... .328
Wait to Start Light ........................ .130
Warning Lights (Instrument Cluster Description) . . .128
Warnings and Cautions .......................6
Warranty Information ..................... .386
10
INDEX 405