center console Ram ProMaster 2020 Owner's Manual
[x] Cancel search | Manufacturer: RAM, Model Year: 2020, Model line: ProMaster, Model: Ram ProMaster 2020Pages: 264, PDF Size: 10.11 MB
Page 28 of 264
26GETTING TO KNOW YOUR VEHICLE
Dome Lights
The interior lights can be set to three different
positions (off/left position, center position, on/
right position). Using the switch on the bottom
of the overhead console:
Push the switch to the on/right position
from its center position and the lights are
always on.
Push the switc h to the off/left po sitio n
from its c enter positio n and the lights are
always o ff.
Leave the switch in the center position, and
the lights are turned on and off when the
doors are opened or closed.
Map Lights
The switches on the left and right sides of the
overhead console controls the map or reading
function of the lights. Push the switch on the
right position to turn the right light on, push
again to turn the right light off. Push the switch
on the left position to turn the left light on, also
push again to turn the left light off.
Rear Lights
The Rear Cargo Lamp is located at the upper
rear cargo area above the rear doors.
Rear Cargo Lamp
Your vehicle may be equipped with a Side Cargo
Lamp located at the upper rear area of the
passenger side sliding door opening. Side Cargo Lamp
The Cargo Lamps can be set to three different
positions (off/right position, center position,
on/left position).
Push the Cargo Lamp lens to the right from its
center position and the lamp is always off.
Leave the Cargo Lamp lens in the center posi -
tion, and the lamp is turned on and off when
the sliding doors or rear doors are opened or
closed.
Push the Cargo Lamp lens to the left from its
center position and the lamp is always on.
CAUTION!
Before getting out of the vehicle be sure that
the switch is in the center position or that the
lights are off to avoid draining the battery.
20_VF_OM_EN_US_t.book Page 26
Page 130 of 264
128IN CASE OF EMERGENCY
(Continued)
2. Using a suitable tool, flex the housing to lift
the light pod cover away from the unit.
Dome Lamp Light Pod Cover
3. Remove and replace the bulbs as needed.
Dome Lamp Light Bulbs 4. Close the housing cover making sure it
snaps together properly and connect the
lamp.
5. Install overhead console into place making sure to seat the assembly’s forward end
first and then snapping it flush so that the
tension spring is fully seating in the housing.
FUSESUnderhood Fuses
The Front Power Distribution Center is located
on the driver’s side of the engine compartment.
To access the fuses, remove the cover.
Front Power Distribution Center
The ID number of the electrical component
corresponding to each fuse can be found on the
back of the cover.WARNING!
When replacing a blown fuse, always use
an appropriate replacement fuse with the
same amp rating as the original fuse. Never
replace a fuse with another fuse of higher
amp rating. Never replace a blown fuse with
metal wires or any other material. Do not
place a fuse inside a circuit breaker cavity
or vice versa. Failure to use proper fuses
may result in serious personal injury, fire
and/or property damage.
Before replacing a fuse, make sure that the
ignition is off and that all the other services
are switched off and/or disengaged.
If the replaced fuse blows again, contact an
authorized dealer.
If a general protection fuse for safety
systems (air bag system, braking system),
power unit systems (engine system, trans -
mission system) or steering system blows,
contact an authorized dealer.
WARNING!
(Continued)
20_VF_OM_EN_US_t.book Page 128