fuse Ram ProMaster City 2018 User Guide

Central Unit Fuse Panel
The central power fuse panel is located on the driver ’s side
under the instrument panel.
CavityMini Fuse Description
F1 10 Amp Red Front Heated Seat Passenger
F2 10 Amp Red Front Heated Seat Driver
F3 20 Amp Yellow Rear Power Window Driver side
F4 20 Amp Yellow Rear Power Window Passenger side
F5 15 Amp Blue Fog Lamps
Fuse Panel Cover
Fuse Panel
208 IN CASE OF EMERGENCY

ENGINE COMPARTMENT
Engine Compartment — 2.4L
1 — Air Cleaner Filter5 — Power Distribution Center (Fuses)
2 — Power Steering Fluid Reservoir 6 — Washer Fluid Reservoir
3 — Oil Fill Cap 7 — Engine Coolant Pressure Cap
4 — Brake Fluid Reservoir 8 — Engine Oil Dipstick
8
SERVICING AND MAINTENANCE 241

Folding Rear Seat...........................29
Four-Way Hazard Flasher .....................197
Freeing A Stuck Vehicle ..................... .231
Fuel ................................... .292
Additives ............................. .294
Clean Air ............................. .293
Ethanol .............................. .293
Filler Cap (Gas Cap) ..................... .178
Gasoline .............................. .292
Light ..................................87
Materials Added ........................ .294
Methanol ............................. .293
Octane Rating ....................... .292, 297
Specifications .......................... .297
Tank Capacity .......................... .296
Fuses .................................. .202
Gas Cap (Fuel Filler Cap) .....................178
Gasoline, Clean Air ........................ .293
Gasoline (Fuel) ........................... .292
Gasoline, Reformulated ..................... .293
Gear Ranges ............................. .163
Gear Select Lever Override ....................229
General Information ........................ .105
Glass Cleaning ........................... .288Gross Axle Weight Rating
.................180, 182
Gross Vehicle Weight Rating ...............180, 182
Guide, Body Builders .........................6
GVWR ................................. .180
Hazard Driving Through Flowing, Rising, Or Shallow
Standing Water ......................... .192
Hazard Warning Flasher ..................... .197
Headlights ................................41
Cleaning .............................. .285
Passing ................................42
Head Restraints ............................34
Heated Seats ...............................32
Heater, Engine Block ....................... .157
Hill

Start Assist .............................98
Hitches Trailer Towing .......................... .184
Holder, Cup ...............................65
Hood Prop ................................60
Hood Release ..............................60
Ignition ..................................19
Key ............................... .16, 19
Ignition Key Removal ........................19
336 INDEX

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENTSpecial design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.