service RENAULT CLIO 1997 X57 / 1.G Petrol Engines Workshop Manual

Renault 1991
ENGINES (petrol)
4 cylinders - Cast-Iron
Types Vehicles
E5F Clio
E6J Extra
Clio
Renault 19
E7F Clio
Renault 19
E7J Extra
Clio
Renault 19
Mé
gane
77 11 193 633APRIL 1997Edition anglaise
."The repair methods given by the manufacturer in this document are based on the
technical specifications current when it was prepared.
The methods ma
y be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories
from which his vehicles are constructed."All cop
yrights reserved by Renault.
Cop
ying or translating, in part or in full, of this document or use of the service partreference numbering system is forbidden without the prior written authority of
Renault
C
Cancels and replaces Part No. 77 11 091 458
Workshop Repair Manual
Page 1 of 1 E_Series_1
04.08.2003 http://jester.com.ua/renault/motors/e/E_Series/css/E_Series_1.htm

ENGINE AND PERIPHERALS
En
gine repair10
99179R1
Refit the sump and tighten to a torque value of
1 daN.m.
NOTE : A tight seal for the sump can only be ob-
tained using the special seal supplied by the afte
r-
sales service, except for engine
E7J 764 in which a
tight seal is achieved by using
RHODOR-SEAL
5661. Bead (D) should be
3 mm wide.
Do not forget to replace the two "half-moon"
seals at (A) with new ones.
Coat the flywheel bearing surface on the cranks-
haft with
AUTOFORM Loctite.
Fit the flywheel or the converter plate and immo-
bilise it with the toothed segment
Mot. 582-01.
Apply a drop of
FRENETANCH Loctite to the
bolts and tighten them to
5 - 5.5 daN.m.
Centre the clutch disc and secure the mechanism.
92068R
Refit the water pump, sealing it with
Loctite 518.
The bead (H) should be
0.6 to 1 mm wide and
should be applied as shown in the diagram below.
REFITTING THE CYLINDER HEAD
Remove the liner tool
Mot. 588.
Clean the gasket surfaces of the cylinder bloc
k
and the cylinder head.
Refit the cylinder head centring dowl.
The new cylinder head gasket.
The cylinder head (lubricate the threads and
underneath the bolt heads).
All the cylinder head bolts must be replaced
systematically after any removal.
10-44
Page 1 of 1 E_Series_46
04.08.2003 http://jester.com.ua/renault/motors/e/E_Series/css/E_Series_46.htm