brake RENAULT CLIO 2000 X65 / 2.G User Guide
[x] Cancel search | Manufacturer: RENAULT, Model Year: 2000, Model line: CLIO, Model: RENAULT CLIO 2000 X65 / 2.GPages: 184, PDF Size: 8.45 MB
Page 84 of 184
A
I
1 8 I U B * D T [ G 3 D J H
X65 - CLIOC:\Documentum\Checkout\Nu607-8gb_T2.WIN 30/9/2000 11:04-page12
2.12
PROACTIVE AUTOMATIC TRANSMISSION(continued)
Economical driving
On the open road, always leave the
lever in positionD. Press the
accelerator pedal lightly to ensure
that the gears change automatically
at a low engine speed.
Never use positions D3, 2, 1 and the
snow position unless special
circumstances apply.
Parking the vehicle
When the vehicle is stationary,
whilst keeping your foot on the
brake pedal, place the lever in
positionP: the automatic
transmission is in neutral and the
drive wheels are mechanically
locked by the transmission.
Apply the handbrake.
Operating faults
• If the lever remains locked in P
when your foot is on the brake
pedal, the lever may be moved
manually.
To do this, unclip coverIand then
press the raised area (under cover
I)and,atthesametime,press
unlocking buttonAto remove the
lever from positionP.
Take the vehicle to your Renault
Dealer.
•While driving,if this
warning light illuminates,
there is a fault. Refer to
the
information on the “Instrument
panel” in section 1.
•Towing a vehicle with an
automatic transmission,refer to
the information on “Towing” in
section 5.
Page 85 of 184
1
2
1 8 I U B * D T [ G 3 D J H
X65 - CLIOC:\Documentum\Checkout\Nu607-8gb_T2.WIN 30/9/2000 11:04-page13
2.13
GEAR LEVER HANDBRAKEPOWER ASSISTED STEERING
To select reverse
(vehicle stationary)
Move the lever to neutral, then lift
up ring1against the gear lever knob
to select reverse gear.
The reversing lights illuminate as
soon as reverse gear is selected
(ignition on).
To release
Pull the lever up slightly, press in
button2and lower the lever to the
floor.
If you are driving with the
handbrake incorrectly released, the
red warning light on the instrument
panel will remain illuminated.
To apply
Pull the lever upwards.
The lever should travel about 10
notches to hold the vehicle. Your
vehicle has self adjusting rear brake
shoes and the handbrake should
only be adjusted during a brake
overhaul.
When the vehicle is
stationary, make sure
that the handbrake is
properly applied so that
the vehicle does not move
unintentionally.
Make sure the handbrake is
properly released when driving,
otherwise overheating may
occur.Never leave the steering on full lock
when the vehicle is parked (risk of
damaging the power assisted
steering pump).
Never switch off the
engine when travelling
downhill, and avoid
doing so when driving in
general (power steering and
brake servo will not function).
Page 86 of 184
1 8 I U B * D T [ G 3 D J H
X65 - CLIOC:\Documentum\Checkout\Nu607-8gb_T2.WIN 30/9/2000 11:04-page14
2.14
ANTI-LOCK BRAKING SYSTEM (ABS)
When braking sharply, the two main
aims are to reduce the stopping
distance and to keep the vehicle
under control. However, depending
on the nature of the ground, the
atmospheric conditions and your
reactions, dangers due to loss of
adherence may exist: the wheels
may lock and directional control
may be lost. To avoid these risks,
your vehicle has been fitted with
the anti-lock braking system (ABS).
The safety enhancement is that the
brake control system prevents the
wheels from locking, even if the
brakes are applied too sharply,
allowing the vehicle to be steered
and thus its direction to be controlled.
Under these circumstances, it is quite
possible for the driver to steer the
vehicle and avoid an obstacle whilst
at the same time applying the brake.
This system also allows stopping
distances to be improved, especially
when adhesion is limited (wet roads,
slippery or uneven road surface).Although this system allows this
optimisation, the ABS system in no
way increases performance which is
physically related to the local
adherence conditions between the
tyres and the ground. You must still
follow the rules of good driving
practice (driving at a safe distance
from the vehicle in front etc.).The
fact that the vehicle’s safety has been
increased should not encourage you
to take risks.
Each time the system is activated,
you will feel a certain degree of
pulsation at the brake pedal. These
tangible signs will warn you that the
adhesion between the tyres and the
ground has reached its limit and
enable you to adapt your driving
style to suit the road conditions.Operating incidents
Two situations must be considered:
1 - The warning light is
illuminated on the instrument
panel.
Braking is still assured, but
without the action of the ABS
system. Consult a Renault Dealer
as soon as possible.
2 - The warning lights
are illuminated on the instrument
panel.
This indicates a fault in one of
the ABS braking components.
Braking may be partially assured.
It is howeverdangerous to brake
sharply,soyoumuststop
immediately as soon as traffic
conditions allow. Call for the
assistance of a Renault Dealer as
soon as possible.
The braking modulation provided by the ABS system is independent of the force applied at the pedal. In an
emergency, applyfirm, continuous pressureat the brake pedal - there is no need to pump it repeatedly.
Page 113 of 184
11
2
1 8 I U B * E T [ G 3 D J H
X65 - CLIOC:\Documentum\Checkout\Nu607-8gb_T3.WIN 30/9/2000 11:27-page27
3.27
LUGGAGE COMPARTMENT(continued)
Rear shelf
To remove, release the two return
cords1.
Do not place any objects,
in particular heavy or
hard objects, on the rear
parcel shelf. These may
pose a risk to the vehicle
occupants if the driver has to
brake suddenly or if the vehicle
is involved in an accident.Gently lift the shelf and pull it
towards you.
Refitting is the reverse of removal.
Built-in garment case2
This is located under the rear parcel
shelf and is closed by a zip fastener.
It can be used to store clothes.
The total weight of
luggage placed in the
built-in garment case
must not exceed 5 kg
(11 lbs).
Page 114 of 184
A
A
B
1 8 I U B * E T [ G 3 D J H
X65 - CLIOC:\Documentum\Checkout\Nu607-8gb_T3.WIN 30/9/2000 11:27-page28
3.28
LUGGAGE COMPARTMENT COVER - SEPARATING GRILLE:utility versions
The luggage compartment coverA
is made up of three rigid sections.
There are three positions for use:
• The luggage compartment cover
Ain the unfolded position.
Do not place any objects,
in particular heavy or hard
objects, on the luggage
compartment cover. These
may pose a risk to the vehicle
occupants if the driver has to
brake suddenly or if the vehicle
is involved in an accident.• The luggage compartment cover
Ain the semi-folded out position.• The luggage compartment cover
Ais removed.
To remove it, place the luggage
compartment cover in the
semi-folded position. Grip the
luggage cover at each end and
pull it towards you.
Separating grilleB.
Page 115 of 184
1 8 I U B * E T [ G 3 D J H
X65 - CLIOC:\Documentum\Checkout\Nu607-8gb_T3.WIN 30/9/2000 11:27-page29
3.29
TRANSPORTING OBJECTS IN THE LUGGAGE COMPARTMENT
Always place objects carried in the
luggage compartment so that their
largest dimension is against:
- the back of the rear bench seat, for
normal loading.
- the folded down seat, for
maximum loading.
Always put the heaviest
items directly onto the
floor. When the vehicle is
fitted with them, use the
lashing points located on the
floor at the rear to secure
transported items. Luggage
should be loaded in such a way
that no item will be thrown
forward and strike the occupants
if the driver has to brake
suddenly. Fasten the rear seat
belts, even if the seats are not
occupied.
Page 117 of 184
1 8 I U B * D T [ G 3 D J H
X65 - CLIOC:\Documentum\Checkout_47\Nu607-8gb_T4.WIN 16/10/2000 11:23-page1
4.01
Section 4: Maintenance
Bonnet ................................................................................................................................................................ 4.02
Engine oil level .................................................................................................................................... 4.03
¬4.07
Oil changes: Engine .......................................................................................................................................... 4.07
Levels: Brake fluid ............................................................................................................................................ 4.08
Coolant .................................................................................................................................................. 4.09
Battery ................................................................................................................................................... 4.10
Power steering pump .......................................................................................................................... 4.10
Screen washer reservoir ...................................................................................................................... 4.11
Air filter ............................................................................................................................................................. 4.11
Bodywork maintenance ......................................................................................................................... 4.12 - 4.13
Interior trim maintenance ................................................................................................................................ 4.14
Page 124 of 184
1
1 8 I U B * D T [ G 3 D J H
X65 - CLIOC:\Documentum\Checkout_47\Nu607-8gb_T4.WIN 16/10/2000 11:23-page8
4.08
LEVELS
Brake fluid
This must be checked frequently,
especially if you notice even the
slightest loss in braking efficiency.
Level1
The level falls naturally as the brake
pads wear, but it should never be
allowed to fall below the
MINIMUMwarning mark.Filling
After any operation on the
hydraulic circuit a specialist must
replace the brake fluid.
Only use products approved by
Renault’s Technical Department,
taken from a sealed container.
Fluid change frequency: Refer to
your vehicle’s Warranty and
Servicing booklet.
Take care when working
under the bonnet as the
engine cooling fan may cut
in at any moment.
Page 135 of 184
1
3
2
1 8 I U B * D T [ G 3 D J H
X65 - CLIOC:\Documentum\Checkout_47\Nu607-8gb_T5.WIN 16/10/2000 11:24-page5
5.05
CHANGING A WHEEL
•Remove the wheel embellisher
(see section on embellishers).
• Use the wheelbrace1to loosen
the wheel bolts slightly. Fit it so
that you press downwards and
not upwards.
• Offer up the jack horizontally, the
jack head must be slid
underneath the jacking point
under the body, nearest the wheel
concerned.
• Screw up the jack by hand at first
to align the base plate (which
should be inclined further
inwards than the jack head). Use a
piece of wood under the base
plate if on soft ground.• Insert the end of the wheelbrace2
into the jack3and turn a few
times to lift the wheel off the
ground:
• Remove the bolts.
• Take off the wheel.
• Position the emergency spare
wheel on the central hub and turn
it to locate the mounting holes in
the wheel and the hub.
• Tighten the bolts and lower the
jack.
• Tighten the bolts fully when the
wheel is on the ground.Park your vehicle on firm,
flat ground (if necessary,
placing a plank under the
base of the jack).
Switch on the hazard warning
lights.
Apply the handbrake and engage a
gear (first or reverse, orPon an
automatic gearbox).
Ask all the passengers to get out of
the vehicle and keep them away
from moving traffic.
If you have a puncture,
replace the wheel as soon
as possible.
A tyre which has been
punctured should always be
inspected (and repaired if possible)
by a specialist.
Page 155 of 184
A
I
1 8 I U B * E T [ G 3 D J H
X65 - CLIOC:\Documentum\Checkout_47\Nu607-8gb_T5.WIN 16/10/2000 11:24-page25
5.25
TOWING breakdown,(continued)
• Renault specifies the
use of a rigid towing
bar. If a rope or cable is
used (where the law
allows this), the vehicle being
towed must be able to brake.
• A vehicle must not be towed if
it is not fit to be driven.
• Do not accelerate or brake
suddenly when towing, as this
may result in damage being
caused to the vehicle.
• When towing a vehicle, it
is advisable not to exceed
15 mph (25 km/h).Towing a vehicle with
automatic transmission: special
notes
Engine switched off:The transmission
is no longer lubricated. It is
preferable to tow this type of
vehicle on a trailer or tow it with the
front wheels off the ground.
In exceptional cases, you can tow
the vehicle with all four wheels on
the ground for a maximum distance
of 30 miles (50 km).
The selector lever must be in
neutral (position N).
If the lever becomes jammed in P
position, even though you are
pressing down the brake pedal, the
lever can be released manually. To
do this, unclip coverI. Press on both
the raised part (under coverI)and
the unlocking buttonAat the same
time to move the lever from
positionP.