instrument panel RENAULT CLIO 2000 X65 / 2.G Owner's Manual

A
B
C
E
F
G
H
18IUB*DT[G      3DJH 
X65 - CLIOC:\Documentum\Checkout\Nu607-8gb_T2.WIN 30/9/2000 11:04-page10
2.10
PROACTIVE AUTOMATIC TRANSMISSION
Selector lever
The displayEand tell-tale lightsF,
G,Hon the instrument panel
indicate the position of the gear
lever1and/or the operating mode of
the automatic transmission.
P: Park
R: Reverse
N: Neutral
D: Drive in automatic
(gears authorised: 1, 2, 3 and 4)
2: 2nd gear hold
(gears authorised: 1, 2)
1: 1st gear holdPosition D3 or 3rd gear hold
(Gears authorised: 1, 2, 3).
With the selector lever in position
D, press buttonB. A tell-tale lightH
will illuminate on the instrument
panel. Press buttonBagain to
deselect this position. (The tell-tale
light will extinguish.)
Note:When the tell-tale light is
illuminated, the system will
prevent 4th gear being selected.For safety reasons, certain positions
may not be selected until the
mechanism is released: press buttonA.
The lever may only be moved to D
or R when the vehicle is stationary,
with your foot on the brake and the
accelerator pedal released.
Moving off forwards
With the lever in position PorN,
switch on the ignition.
With your foot on the brake pedal,
move the lever out of positionPorN.
For safety reasons, to take the lever
out of position P, the brake pedal
must be pressed before pressing the
releasing buttonA.

A
I
18IUB*DT[G      3DJH 
X65 - CLIOC:\Documentum\Checkout\Nu607-8gb_T2.WIN 30/9/2000 11:04-page12
2.12
PROACTIVE AUTOMATIC TRANSMISSION(continued)
Economical driving
On the open road, always leave the
lever in positionD. Press the
accelerator pedal lightly to ensure
that the gears change automatically
at a low engine speed.
Never use positions D3, 2, 1 and the
snow position unless special
circumstances apply.
Parking the vehicle
When the vehicle is stationary,
whilst keeping your foot on the
brake pedal, place the lever in
positionP: the automatic
transmission is in neutral and the
drive wheels are mechanically
locked by the transmission.
Apply the handbrake.
Operating faults
• If the lever remains locked in P
when your foot is on the brake
pedal, the lever may be moved
manually.
To do this, unclip coverIand then
press the raised area (under cover
I)and,atthesametime,press
unlocking buttonAto remove the
lever from positionP.
Take the vehicle to your Renault
Dealer.
•While driving,if this
warning light illuminates,
there is a fault. Refer to
the
information on the “Instrument
panel” in section 1.
•Towing a vehicle with an
automatic transmission,refer to
the information on “Towing” in
section 5.

1
2
18IUB*DT[G      3DJH 
X65 - CLIOC:\Documentum\Checkout\Nu607-8gb_T2.WIN 30/9/2000 11:04-page13
2.13
GEAR LEVER HANDBRAKEPOWER ASSISTED STEERING
To select reverse
(vehicle stationary)
Move the lever to neutral, then lift
up ring1against the gear lever knob
to select reverse gear.
The reversing lights illuminate as
soon as reverse gear is selected
(ignition on).
To release
Pull the lever up slightly, press in
button2and lower the lever to the
floor.
If you are driving with the
handbrake incorrectly released, the
red warning light on the instrument
panel will remain illuminated.
To apply
Pull the lever upwards.
The lever should travel about 10
notches to hold the vehicle. Your
vehicle has self adjusting rear brake
shoes and the handbrake should
only be adjusted during a brake
overhaul.
When the vehicle is
stationary, make sure
that the handbrake is
properly applied so that
the vehicle does not move
unintentionally.
Make sure the handbrake is
properly released when driving,
otherwise overheating may
occur.Never leave the steering on full lock
when the vehicle is parked (risk of
damaging the power assisted
steering pump).
Never switch off the
engine when travelling
downhill, and avoid
doing so when driving in
general (power steering and
brake servo will not function).

18IUB*DT[G      3DJH 
X65 - CLIOC:\Documentum\Checkout\Nu607-8gb_T2.WIN 30/9/2000 11:04-page14
2.14
ANTI-LOCK BRAKING SYSTEM (ABS)
When braking sharply, the two main
aims are to reduce the stopping
distance and to keep the vehicle
under control. However, depending
on the nature of the ground, the
atmospheric conditions and your
reactions, dangers due to loss of
adherence may exist: the wheels
may lock and directional control
may be lost. To avoid these risks,
your vehicle has been fitted with
the anti-lock braking system (ABS).
The safety enhancement is that the
brake control system prevents the
wheels from locking, even if the
brakes are applied too sharply,
allowing the vehicle to be steered
and thus its direction to be controlled.
Under these circumstances, it is quite
possible for the driver to steer the
vehicle and avoid an obstacle whilst
at the same time applying the brake.
This system also allows stopping
distances to be improved, especially
when adhesion is limited (wet roads,
slippery or uneven road surface).Although this system allows this
optimisation, the ABS system in no
way increases performance which is
physically related to the local
adherence conditions between the
tyres and the ground. You must still
follow the rules of good driving
practice (driving at a safe distance
from the vehicle in front etc.).The
fact that the vehicle’s safety has been
increased should not encourage you
to take risks.
Each time the system is activated,
you will feel a certain degree of
pulsation at the brake pedal. These
tangible signs will warn you that the
adhesion between the tyres and the
ground has reached its limit and
enable you to adapt your driving
style to suit the road conditions.Operating incidents
Two situations must be considered:
1 - The warning light is
illuminated on the instrument
panel.
Braking is still assured, but
without the action of the ABS
system. Consult a Renault Dealer
as soon as possible.
2 - The warning lights
are illuminated on the instrument
panel.
This indicates a fault in one of
the ABS braking components.
Braking may be partially assured.
It is howeverdangerous to brake
sharply,soyoumuststop
immediately as soon as traffic
conditions allow. Call for the
assistance of a Renault Dealer as
soon as possible.
The braking modulation provided by the ABS system is independent of the force applied at the pedal. In an
emergency, applyfirm, continuous pressureat the brake pedal - there is no need to pump it repeatedly.

18IUB*DT[G      3DJH 
X65 - CLIOC:\Documentum\Checkout_47\Nu607-8gb_T4.WIN 16/10/2000 11:23-page3
4.03
ENGINE OIL LEVEL
It is normal for an engine to use oil
for lubrication and cooling of
moving parts and it is sometimes
necessary to top up the level
between oil changes.
However, if more than 0.5 litre is
used every 625 miles (1000 km)
aftertherunninginperiodconsult
your Renault Dealer.
Oil change frequency: Check the oil
level from time to time and
certainly before any long journey,
to avoid the risk of damaging your
engine.
Reading the oil level
The car must be parked on level
ground and the engine should have
been switched off for some time
beforehand to obtain an accurate
reading.
The oil level can be read:
- on the instrument panel;
- using the dipstick.Reading the level on the instrument
panel
When ignition has been switched
on for approximately 30 seconds:
-if the level is correct, the display
will show “oil OK”: display
message1
Special note:To gain a more
precise indication of the level,
press the trip mileage counter
reset button or the information
scroll button on the onboard
computer.The squares which appear on the
display indicate the level. The
number of squares displayed
reduces as the oil level drops and
they are replaced by a dash: display
message2.
To move to onboard computer
reading, press the button again).
-if the level is at its minimum,the
word “OK” will not appear on the
display, the dashes and the word
“oil” will flash (display message3)
and the indicator light
illuminates in the instrument
panel on some versions.
It is vital to top up the oil as soon
as possible.
Message 1
Maximum
level
Message 2
Level
display
function
Message 3
Minimum
level
(flashing)

18IUB*DT[G      3DJH 
X65 - CLIOC:\Documentum\Checkout_47\Nu607-8gb_T4.WIN 16/10/2000 11:23-page14
4.14
INTERIOR TRIM MAINTENANCE
Whatever type of stain is on the
trim, use soapy water (if necessary
warm) based on:
• natural soap,
• washing up liquid (1 part
washing up liquid to 200 parts of
water)
Rinse with a soft, damp cloth.
Special points
Instrument glass(e.g. instrument
panel, clock, external temperature
display, radio display, etc.).
Use a soft cloth or cotton wool.
If this does not clean the glass, use a
soft cloth (or cotton wool) slightly
dampened with soapy water then
rinse with a soft cloth or damp
cotton wool.
Carefullydry with a soft dry cloth.
Cleaning products containing
alcohol may not be used under any
circumstances.Seat belts
These must be kept clean.
Use products selected by Renault's
Technical Department (Renault
Accessory Outlet) or use warm
soapy water with a sponge and dry
with a dry cloth.
Do not use cleaning agents or dyes
under any circumstances.
We have selected special products
to care for your vehicle which
may be obtained from Renault
Accessory Outlets.

18IUB*DT[G      3DJH 
X65 - CLIOC:\Documentum\Checkout_47\Nu607-8gb_T6.WIN 16/10/2000 11:26-page17
ALPHABETICAL INDEX
FFuel cut-off system
Fuel economy ............................................ 2.06¬2.08
Fuel filler flap ........................................................ 1.63
Fuel level .................................................... 1.36
¬1.52
Fuel tank capacity .................................................. 1.63
Fuses ............................................................. 5.20 - 5.21
GGear lever ................................................................ 2.13
HHandbrake ............................................................... 2.13
Hazard warning lights ............................................ 1.62
Head restraint .............................................. 1.09 - 1.10
Headlight flashers ................................................... 1.62
Headlights .................................................. 1.55
¬1.58
Heated seats ............................................................ 1.12
Heating ....................................................... 3.04
¬3.09
Heating and ventilation ....... 3.02 - 3.03 - 3.10¬3.14
Horn ......................................................................... 1.62
IIgnition switch ........................................................ 2.02
Immobiliser (ignition switch) ................................ 2.02
In the event of a violent impact ........................... 5.23
Indicator lights ........................................... 1.36
¬1.52
Instrument panel (adjustment) .............................. 1.55
Instrument panel ....................................... 1.36
¬1.52
Instruments ................................................ 1.36¬1.52
Interior trim (maintenance) ................................... 4.14
JJack ............................................................... 5.03 - 5.05
KKeys ......................................................................... 1.02LLevels .......................................................... 4.03
¬4.11
Lifting the vehicle (changing a wheel) .... 5.02¬5.08
Lighting: External ............... 1.55¬1.58 - 5.10¬5.15
Interior ............................... 3.15 - 5.16 - 5.17
Lights: Fog lights .............................. 1.56 - 5.12 - 5.13
Dipped beam headlights ...... 1.55 - 5.10 - 5.11
Hazard warning lights ............................... 1.62
Direction
indicators .... 1.62 - 5.10 - 5.11 - 5.13 - 5.15
Side lights .................. 1.55 - 5.10 - 5.11 - 5.13
Reversing lights .......................................... 5.13
Main beam headlights ......... 1.55 - 5.10 - 5.11
Stop lights ....................................... 5.13 - 5.14
Adjustment ...................................... 1.57 - 1.58
Luggage compartment ............................... 3.26
¬3.29
MMap reading lights ...................................... 3.15 - 3.16
Maintenance:
Bodywork ................................................. 4.12 - 4.13
Interior trim ........................................................ 4.14
Mechanical ................................................. 4.03
¬4.11
OOil change ............................................................... 4.07
Oil filter .................................................................. 4.07
On-board computer ................................... 1.50
¬1.52
PPaintwork (maintenance) ............................ 4.12 - 4.13
Paintwork (reference) ............................................. 6.02
Power assisted steering ............................... 2.13 - 4.10
Power-assisted steering pump ............................... 4.11
Practical advice .......................................... 2.06
¬2.08
Puncture ..................................................... 5.02¬5.05