turn signal RENAULT CLIO 2009 X85 / 3.G Owners Manual

Downloaded from www.Manualslib.com manuals search engine
audible and visual signals.....................(up to the end of the DU)indicators ..............................................(up to the end of the DU)lighting:exterior ............................................(up to the end of the DU)lights:hazard warning ...............................(up to the end of the DU)indicators:direction indicators ..........................(up to the end of the DU)hazard warning lights signal .................(up to the end of the DU)signals and lights ..................................(up to the end of the DU)hazard warning lights signal .................(up to the end of the DU)lights:direction indicators ..........................(up to the end of the DU)horn ......................................................(up to the end of the DU)
1.74
ENG_UD10540_1Avertisseurs sonores et lumineux (X85 - B85 - C85 - S85 - K85 - Renault)\
ENG_NU_853-3_BCSK85_Renault_1
Audible and visual signals
éHazard warning lights
Press switch 2.This switch activates all four direction indicators and the side indicator lights simultaneously. It must only be used in an emergency to warn drivers of other vehicles that you have had to stop in an area where stopping is prohibited or unexpected, or that you are obliged to drive under special conditions.Depending on the vehicle, the hazard warning lights may come on automati- cally under heavy deceleration. You can
switch them off by pressing switch 2 once.
Direction indicators
Move stalk 1 parallel to the steering wheel and in the direction you are going to turn it.
When driving on the motorway, the steering wheel is not often turned enough to return the stalk automatically to 0. There is an intermediate position in which the switch may be held when changing lanes.
When the stalk is released, it automati- cally returns to 0.
Horn
Press steering wheel boss A.
Headlight flasher
Pull stalk 1 towards you to flash the headlights.
AUDIBLE AND VISUAL SIGNALS
A
2
1

Downloaded from www.Manualslib.com manuals search engine
lighting:exterior ............................................(up to the end of the DU)lights:side lights .........................................................(current page)signals and lights ..................................(up to the end of the DU)lighting:instrument panel ..............................................(current page)
1.75
ENG_UD10541_1Éclairages et signalisations extérieures (X85 - B85 - C85 - S85 -\
K85 - Renault)ENG_NU_853-3_BCSK85_Renault_1
Exterior lighting and signals
EXTERIOR LIGHTING AND SIGNALS (1/5)
uSide lights
Turn the end of stalk 1 until the
symbol is opposite mark 2.
An indicator light on the instrument panel will come on.
Adjusting the brightness of
the instrument panel lighting
Turn control 3 downwards to reduce the brightness and upwards to increase it.
1132
Before driving at night, check that the electrical equipment is operating cor- rectly and adjust the head- light beams (if your vehicle is not carrying its normal load). As a gen-
eral precaution, check that the lights are not obscured (by dirt, mud, snow or objects being transported).

Downloaded from www.Manualslib.com manuals search engine
lights:dipped beam headlights ...................................(current page)lighting:see-me-home ...................................................(current page)
1.76
ENG_UD10541_1Éclairages et signalisations extérieures (X85 - B85 - C85 - S85 -\
K85 - Renault)ENG_NU_853-3_BCSK85_Renault_1
JauneNoirNoir texte
EXTERIOR LIGHTING AND SIGNALS (2/5)
kDipped beam
headlights
Manual operation
Turn the end of stalk
1 until the symbol
is opposite mark 2.
An indicator light on the instrument panel will come on.
Automatic operation (depending on vehicle)
With the engine running, the dipped beam headlights are switched on or off automatically depending on the level of ambient light, without the need to oper-
ate stalk 1 (position 0).
This function can be deactivated or re- activated.
–
To activate it, with the ignition on,
press button 4 for at least four sec- onds. An instrument panel message confirms this action.
–
To deactivate it, with the ignition on and the vehicle stopped, press button 4 for at least four seconds. The ‘Auto lights OFF’ message is displayed on the instrument panel.
If stalk
1 is operated, it overrides and cancels the automatic function tempo- rarily.
See-me-home lighting
function
This function (useful, for example, for opening a gate, a garage, etc.) enables you to switch on dipped headlights mo- mentarily.
With the ignition off and the headlights
off, pull stalk 1 towards you: the dipped beam headlights come on for approxi- mately thirty seconds.
This action may be carried out no more than four times for a maximum lighting period of two minutes.
To switch off the lights before they go out automatically, turn the end of
stalk 1, then return it to position 0.
4
12

Downloaded from www.Manualslib.com manuals search engine
lights:main beam headlights ......................................(current page)lightsmobile directional .............................................(current page)
JauneNoirNoir texte
1.77
ENG_UD10541_1Éclairages et signalisations extérieures (X85 - B85 - C85 - S85 -\
K85 - Renault)ENG_NU_853-3_BCSK85_Renault_1
EXTERIOR LIGHTING AND SIGNALS (3/5)
Cornering lights
Depending on the vehicle, if the dipped beam headlights are on when corner- ing, and under certain driving condi- tions (speed, steering wheel angle, for- wards gear selected, etc.), additional lights are switched on to light the inside of the bend.
Note: under certain conditions of pro- longed use, this system will be switched off automatically as it is intended for use over limited periods.
áMain beam headlights
With the dipped beam head-
lights lit, pull stalk 1 towards you.
When the main beam headlights are lit up, an indicator light on the instrument panel comes on.
To return to the dipped headlight posi- tion, pull stalk 1 towards you again.
Automatic lighting with main
beam headlights
Depending on the vehicle, when you change to main beam headlights, the dipped beam headlight raise to improve lighting.
Note: in the event of an operating fault on this system, when returning from main beam to dipped beam headlights, the dipped beam headlight concerned goes out and the front fog lights come
on, accompanied by the g warning light and a fault message on the instru- ment panel
Warning: as this operating mode is not a normal driving condition, consult an approved Dealer as soon as possible.
1

Downloaded from www.Manualslib.com manuals search engine
lights-on warning buzzer........................................(current page)
1.78
ENG_UD10541_1Éclairages et signalisations extérieures (X85 - B85 - C85 - S85 -\
K85 - Renault)ENG_NU_853-3_BCSK85_Renault_1
JauneNoirNoir texte
EXTERIOR LIGHTING AND SIGNALS (4/5)
Switching off the lights
Manual operation
There are three options (depending on the vehicle):
– return stalk
1 to its initial position;
– the lights go out when the engine
is stopped, when the driver’s door is opened or when the vehicle is
locked. In this case, the next time the engine is started the lights will be switched back according to the posi- tion of the stalk 1.
– a timer will switch off the lights auto
- matically.
Automatic operation (depending on vehicle)
The lights go out when the engine is stopped, when the driver’s door is opened or when the vehicle is locked.
Lights-on reminder buzzer
If the lights are switched on after the engine is switched off, a warning beep sounds when the driver’s door is opened to warn you that the lights are still on.1

Downloaded from www.Manualslib.com manuals search engine
fog lights ................................................................(current page)lights:fog lights ..........................................................(current page)
JauneNoirNoir texte
1.79
ENG_UD10541_1Éclairages et signalisations extérieures (X85 - B85 - C85 - S85 -\
K85 - Renault)ENG_NU_853-3_BCSK85_Renault_1
EXTERIOR LIGHTING AND SIGNALS (5/5)
gFront fog lights
Turn centre ring 5 on stalk 1
until the symbol faces mark 6, then re- lease it.
Operation of the fog lights depends on the exterior lighting selected, and an in- dicator light will light up on the instru- ment panel.
Do not forget to switch off the fog lights when they are no longer needed, to avoid inconveniencing other road users.
fRear fog light
Turn centre ring 5 on stalk 1
until the symbol faces mark 6, then re- lease it.
The fog light can only be switched on if the dipped beam headlights or front fog lights are lit.
To avoid inconveniencing other road users, remember to switch off the rear fog light when it is no longer needed.
Note: the fog light is located on the driver’s side.
Erratic illumination of the dipped beam headlight and front fog light indicator lights coupled with a mes- sage on the instrument panel indi- cates an operating fault with the au- tomatic lighting of the main beam headlights.
R e f e r t o t h e i n f o r m a t i o n o n “Automatic lighting with main beam headlights” in Section 1.
Switching off the lights
Turn ring 5 again until mark 6 is oppo- site the symbol for the fog light you wish to switch off.
The front and rear fog lights switch off when the exterior lights are switched off.
15
6
When driving in fog or snow, or when transporting objects which are higher than the roof, the headlights do not come on automatically.
Switching on the fog lights remains the responsibility of the driver: the indicator lights on the instrument panel inform you whether the fog lights are lit (indicator light on) or not (indicator light not on).

Downloaded from www.Manualslib.com manuals search engine
lighting:exterior ............................................(up to the end of the DU)lights:adjusting .........................................(up to the end of the DU)lightsadjustment ......................................(up to the end of the DU)headlight beam adjustment ..................(up to the end of the DU)signals and lights ..................................(up to the end of the DU)
1.80
ENG_UD10542_1Réglage électrique de la hauteur des faisceaux (X85 - B85 - C85 -\
S85 - K85 - Renault)ENG_NU_853-3_BCSK85_Renault_1
Headlight beam adjustment
ELECTRIC BEAM HEIGHT ADJUSTMENT
On vehicles fitted with this function, control A allows you to adjust the height of the beams according to the load.
Turn control A downwards to lower the headlights and upwards to raise them.
Examples of positions for control A depending on the load
All versions except Utility and Estate vehicles
Commercial vehiclesEstate
Driver only000
Driver with one front passenger110
Driver with one front passenger and one rear passenger1–1
Driver with one front passenger, two or
three rear passengers,
with or without luggage
2–2
Driver with luggage or load reaching the maximum permissible all-up weight
333
A