ECO mode RENAULT CLIO CUP 2013 X85 / 3.G User Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 2013, Model line: CLIO CUP, Model: RENAULT CLIO CUP 2013 X85 / 3.GPages: 35, PDF Size: 2.68 MB
Page 13 of 35
Downloaded from www.Manualslib.com manuals search engine 98CUP_2013 Release
C-13
Area “MAP” “DRY” or “WET” depending on the engine MAP selected on the Facia switch panel
Area “GEAR”
Corresponds to Gearbox ratio engaged (R, N, 1, 2, 3 , 4, 5, 6)
Area “RPM” Current engine speed in RPM (“xxxx RPM”)
Area “RAIN LIGHT”
“OFF” (grey background) or “ON” (green backgound) d epending on the Facia switch
panel interrupter position.
Area “Engine”
Engine oil pressure (bars)
Engine water temperature (°C)
Battery voltage (V)
NOTE :
these 3 Values corresponds to the Category A alarm s
B.6.3.1.2 D
RIVER PAGE 2 : QUALIFICATION PAGE
Area “LAP”, “Speed”, “MAP”, “Events”, “Default”, “r ain light”, “RPM”, “GEAR” and “alarms
LED” remains the same as the RACE PAGE. Only the “S plits” replace the “engine” area
Area “Splits” This Area represents the Qualifying mode (QM) confi guration
- Time difference : current split compared to split recorded from
the best lap
- Bargraph : 1 bar = 1 tenth (+/- 1 sec)
- Split : Current split time : reference
NOTE :
Refer to chapter G-Softwares for the full Qualifying mode configuration
Default
Engine alarm LED
Gearbox alarm
LED
Page 18 of 35
Downloaded from www.Manualslib.com manuals search engine 98CUP_2013 Release
C-18
B.6.3.1.8 DIAGNOSTIC PAGE 5 : CBNT DIAGNOSTIC (PAGE 1/2 : STATES)
Every indication corresponds to the XAP CBNT pinout and shows the state
(ON/OFF) of
each Pin. Please refer to chapter F- wiring for more details.
When XAP Master relay is ON :
- All values from the first column must be “ON” (gr een)
- On the second column, Steer W/A, starter and revG B Sol must be “ON” green, for the
other Pins, please find the action/result below :
Sensors
/actuators Signification Action result
stop light SW Brake Pedal
contactor switch Brake pedal pressed OFF >ON
rain light SW Rain light switch on facia switch
panel “Rain ” switch ON OFF >ON
light left SW Left side lights switch on steering
wheel “light” button pressed OFF >ON
light right SW Right side lights switch on steering
wheel “light” button pressed OFF >ON
ignition Ignition coils switch on facia switch
panel “ignition” switch ON OFF >ON
fuel pump Fuel tower pump (facia switch panel
manual mode or automatic mode) state “fuel pump” button pressed and/or
automatic fuel pump management OFF >ON
brake light Lateral rear brake light state
Brake pedal pressed OFF >ON
rain light** Rear central rain light state Brake pedal pressed
And/or « Rain » switch ON And/or pit limiter ON
And/or Reverse gear ratio engaged OFF >ON
wiper zero “Wiper” position state
When “wiper” leave its rest position ON>OFF
** Please refer to Central rear rain light activati on strategies in this chapter
Page 23 of 35
Downloaded from www.Manualslib.com manuals search engine 98CUP_2013 Release
C-23
B.6.4.3 Turning off the engine
Flick the “IGNITION” switch to the down (OFF) posit ion
NOTE : The vehicle’s electrics remain switched on
Except in the event of an emergency stop, it’s stri ctly not advised to turn off the
engine using the power supply switch (OFF button).
It is also recommended to wait 30seconds between sw itching off the engine and
switching off the power supply.
Respecting these two recommendations will guarantee optimum operation of the power
steering.
B.6.4.4 Switching off the power supply
Press the “OFF” button of the facia switch panel an d hold there for at least half a second.
The dashboard display is switched off.
NOTE: Switching off the power supply also switches off th e engine.
B.6.4.5 Changing gears
2 modes are possible and are completely independent . It’s possible to make randomly
upshift and downshift manually (using the lever) or in semi-auto using paddle shift kit.
Please refer to Chapter D-Transmission/shifting for a complete description of the shifting
modes.
B.6.4.6 Pit limiter
The purpose of this function is to limit the vehicl e's speed to 60kph
. It is enabled and
disabled by the driver.
Principle:
By pressing the button “PIT” of the steering wheel, Engine revs are thus limited (by the
ECU) to those corresponding to a speed of 60kph and the message “PIT LIMITER” is
displayed on the dashboard in the RPM Area :
Page 24 of 35
Downloaded from www.Manualslib.com manuals search engine 98CUP_2013 Release
C-24
If the pit limiter is activated while the current s peed is > 60kph, all the Shiftlights flashes
together till the vehicle reach 60kph (at this part icular moment, all shiftlights remains ON
but without flashing)
NOTE
: The speed limiter does not control the brakes. Cons equently, the vehicle speed
will only slow rapidly to 60kph if the driver appli es the brakes.
To disable the pit limiter mode, the driver has to press the button “PIT” of the steering
wheel : the message “ Pit Limiter” disappears on the display.
Specific conditions:
The driver may only enable and disable the speed li miter when the vehicle is in on a
forward gear (1 to 4)
B.6.4.7 Controlling the rain light
The rain light is switched on by flicking the “rain ” switch to the up position (ON).
The central rear rain light is ON continuously whe n enabled.
However, it is lightning automatically with flashin g phases (flashes at 0.5Hz) in the
following specific situations: - When the Pit limiter is enabled
- For a period of 20 seconds after the engine stall s
- When Reverse Gear ratio is shifted