warning RENAULT FLUENCE ZERO EMISSION 2012 1.G Owner's Manual

instrument panel messages..................(up to the end of the DU)
trip computer and warning system ........(up to the end of the DU)
instrument panel ................................... (up to the end of the DU)
1.61
ENG_UD25303_2
Ordinateur de bord : paramètres de voyage (L38 électrique - Renau\
lt)
ENG_NU_914-4_L38e_Renault_1
triP cOmPUter AND WArNiNg SYStem: journey parameters (1/4)
examples of selectionsinterpreting the display selected
a) total mileage and trip mileage recorder.
101778 km
112.4 km
Consumption
b) Journey parameters.
energy consumed since the last reset.
20 kWh
Average
Average energy consumption since the last reset.
The value is displayed after having travelled at least 400 metres since
the last reset.
18,5 kWh/100km
current energy consumption.
the display of information shown below DePeNDS ON the vehicle eqUiPmeNt AND cOUNtr
Y.

1.62
ENG_UD25303_2
Ordinateur de bord : paramètres de voyage (L38 électrique - Renau\
lt)
ENG_NU_914-4_L38e_Renault_1
Jaune NoirNoir texte
triP cOmPUter AND WArNiNg SYStem: journey parameters (2/4)
examples of selectionsinterpreting the display selected
Range
estimated range with remaining energy.
Value estimated based on average energy usage over the last 125 miles
(200 km).
118 km
Distance
Distance travelled since the last reset.
522 km
Average
Average speed since the last reset.
The value is displayed after driving 400 metres.
48 km/h
Consumption
t otal energy usage since vehicle first entered service.
487 kWh
the display of information shown below DePeNDS ON the vehicle eqUiPmeNt AND cOUNtr
Y.

JauneNoirNoir texte
1.63
ENG_UD25303_2
Ordinateur de bord : paramètres de voyage (L38 électrique - Renau\
lt)
ENG_NU_914-4_L38e_Renault_1
triP cOmPUter AND WArNiNg SYStem: journey parameters (3/4)
examples of selectionsinterpreting the display selected
Service due in
c) Service interval.
Distance remaining until the next service (displayed in miles/kilome -
tres), then when the service nears, several scenarios are possible:
– distance/time remaining less than 900 miles (1,500 km) or one
month: the message “Service due in” is displayed accompanied by
the nearest term (distance or time);
– distance/time remaining 0 km/miles or service date reached: the
message “Service vehicle” is displayed accompanied by the
©
warning light.
The vehicle requires a service as soon as possible.
1936 km
resetting the display after the service in accordance with the maintenanc\
e schedule.
The service interval must only be reset after a service which complies with the recommendations in the maintenance schedule.
Special note: To reset the service interval, press and hold one of the display reset buttons for approximately 10 seconds until
the display shows the mileage permanently.
the display of information shown below DePeNDS ON the vehicle eqUiPmeNt AND cOUNtr
Y.

1.64
ENG_UD25303_2
Ordinateur de bord : paramètres de voyage (L38 électrique - Renau\
lt)
ENG_NU_914-4_L38e_Renault_1
triP cOmPUter AND WArNiNg SYStem: journey parameters (4/4)
the display of information shown below DePeNDS ON the vehicle eqUiPmeNt AND cOUNtr Y.
examples of selectionsinterpreting the display selected
d) vehicle settings customisation menu.
Enables certain vehicle functions to be set (instrument panel language,
parking distance control, etc.). Refer to the information on “Vehicle set-
tings customisation menu” in Section 1.
SETTINGS MENU
press and hold
Speed limiter
e) cruise control/speed limiter programmed speed. Refer to the information on the “Speed limiter” and “Cruise control” in
Section 2.
90 km/h
Cruise control 90 km/h
No message available
f) t rip log.
Successive display:
– information messages (passenger airbag OFF etc);
– operating fault messages.

instrument panel messages..................(up to the end of the DU)
trip computer and warning system ........(up to the end of the DU)
instrument panel ................................... (up to the end of the DU)
1.65
ENG_UD23104_1
Ordinateur de bord : messages d’information (L38 électrique - Ren\
ault)
ENG_NU_914-4_L38e_Renault_1
triP cOmPUter AND WArNiNg SYStem: information messages
examples of messages interpreting the display selected
“charge remain. 02:10 "Indicates the time remaining before a full charge.
“checking control functions ”Displayed with the ignition on when the vehicle is running self-diagnost\
ics.
“t raction control off ” Indicates that you have deactivated the ASR function.
“No message available” No warning is stored.
“Steering wheel not locked ”Indicates that the steering column has not been locked.
“Performance limited” Indicates deterioration of vehicle performance.
“Brake the vehicle ” Follow these instructions: risk of damage to the motor.
These can help in the vehicle starting phase, or give information about \
a selection or a driving status.
Examples of information messages are given in the following pages.

operating faults ..................................... (up to the end of the DU)
instrument panel messages ..................(up to the end of the DU)
trip computer and warning system ........(up to the end of the DU)
instrument panel ................................... (up to the end of the DU)
1.66
ENG_UD23102_1
Ordinateur de bord : messages d’anomalie de fonctionnement (L38 é\
lectrique - Renault)
ENG_NU_914-4_L38e_Renault_1
triP cOmPUter AND WArNiNg SYStem: operating fault messages
these appear with the © warning light and mean that you should drive very carefully to an authorised dealer as
soon as possible. if you fail to follow this recommendation, you risk damaging your vehicle\
.
They disappear when the display selection key is pressed or after several seconds and are stored in the computer log. The
© warning light stays on. Examples of operating fault messages are given \
in the following pages.
examples of messages interpreting the display selected
« check airbag » Indicates a fault in the restraint system in addition to the seat belts. In the event of an
accident, it is possible that they may not be triggered.
« elec. System to check » Indicates a fault on one of the pedal sensors or in the 12 V battery management
system.
« check braking system »Indicates wear or the need to check the braking system.
« Service required » Indicates that the system linked to the fast traction battery replacement should be
checked.
« elec. System to check » Indicates a fault in the traction system.
« Battery charge impossible » Indicates a fault on the traction battery recharge system.

instrument panel messages..................(up to the end of the DU)
trip computer and warning system ........(up to the end of the DU)
instrument panel ................................... (up to the end of the DU)
1.67
ENG_UD25304_2
Ordinateur de bord : messages d’alerte (L38 électrique - Renault)\
ENG_NU_914-4_L38e_Renault_1
triP cOmPUter AND WArNiNg SYStem: warning message
these appear with the ® warning light and require you to stop immediately, for your own safety, as soon as traffic
conditions allow. Stop your engine and do not restart it. contact an approved Dealer.
Examples of warning messages are given in the following pages. Note: the messages appear on the display either individually
or alternately (when there are several messages to be displayed), and \
may be accompanied by a warning light and/or a beep.
examples of messages interpreting the display selected
“Braking system fault” Indicates a fault in the braking system.
« Power steering fault » Indicates a fault in the steering.
« electrical motor fault » Indicates that the vehicle is losing power.
« electrical fault danger » Indicates a fault in the electric system.

warning buzzer ..................................... (up to the end of the DU)
headlight flashers ................................. (up to the end of the DU)
indicators .............................................. (up to the end of the DU)
lights: hazard warning ............................... (up to the end of the DU)
lights: direction indicators .......................... (up to the end of the DU)
indicators: direction indicators .......................... (up to the end of the DU)
hazard warning lights signal ................. (up to the end of the DU)
hazard warning lights signal ................. (up to the end of the DU)
horn ...................................................... (up to the end of the DU)
horn: flash ................................................................. (current page)
horn: sounding the horn ............................................ (current page)
horn ....................................................................... (current page)
audible and visual signals .....................(up to the end of the DU)
1.70
ENG_UD19234_1
Avertisseurs sonore et lumineux (L38 - X38 - Renault)
ENG_NU_914-4_L38e_Renault_1
Audible and visual signals
AUDiBle AND viSUAl SigNAlS
horn
Press on the sides of the steering wheel
boss A.
headlight flasher
Pull stalk 1 towards you to flash the
headlights.
éhazard warning lights
Press switch 2 . This switch il -
luminates all four direction indicators
and the side-mounted indicator lights
simultaneously. It must only be used in
an emergency to warn drivers of other
vehicles that you have had to stop in
an area where stopping is prohibited or
unexpected or that you are obliged to
drive under special conditions.
Depending on the vehicle, the hazard
warning lights may come on automati -
cally under heavy deceleration. You can
switch them off by pressing switch 2.
Direction indicators
Move stalk 1 parallel to the steering
wheel and in the direction you are going
to turn it.
When driving on the motorway, the
steering wheel is not often turned
enough to return the stalk automatically
to 0. There is an intermediate position
in which the switch may be held when
changing lanes.
When the stalk is released, it automati-
cally returns to 0.
A
2
1
0

lighting:exterior ............................................ (up to the end of the DU)
instrument panel .................................................... (current page)
lights: side lights ......................................................... (current page)
lights: dipped beam headlights ................................... (current page)
hazard warning lights signal .................................. (current page)
signals and lights .................................. (up to the end of the DU)
lighting: instrument panel .............................................. (current page)
daytime running lights ............................................ (current page)
1.71
ENG_UD20073_2
Éclairages et signalisations extérieurs (L38 - X38 - Renault)
ENG_NU_914-4_L38e_Renault_1
ámain beam headlights

With the dipped beam headlights lit,
pull stalk 1 towards you. This indicator
light on the instrument panel comes on.
To return to the dipped headlight posi-
tion, pull the stalk 1 towards you again.
Exterior lighting and signals
Before driving at night:
check the electrical equip -
ment is operating correctly
and adjust your headlights
(if your vehicle is not carrying its
normal load). As a general precau -
tion, check that the lights are not
obscured (by dirt, mud, snow or ob-
jects being transported).
eXteriOr lightiNg AND SigNAlS (1/3)
31
uSide lights
Turn the ring 2 until the symbol
is opposite mark 3.
kDipped beam
headlights

manual operation
Turn the ring 2 until the symbol is oppo -
site mark 3 . This indicator light on the
instrument panel comes on.
Automatic operation
Turn ring 2 until the AUTO symbol is op-
posite mark 3: with the engine running,
the dipped beam headlights switch on
or off automatically depending on the
brightness of the light outside, without
any action on stalk 1.
2

lights:main beam headlights ...................................... (current page)
warning buzzer ...................................................... (current page)
see-me-home lighting ............................................ (current page)
1.72
ENG_UD20073_2
Éclairages et signalisations extérieurs (L38 - X38 - Renault)
ENG_NU_914-4_L38e_Renault_1
Jaune NoirNoir texte
eXteriOr lightiNg AND SigNAlS (2/3)
Switching off the lights
There are two possibilities:
– manually, move ring 2 to position 0;
– the lights will go out automatically
when the engine is switched off, the
driver’s door is opened or the vehicle
is locked. In this case, the next time
the engine is started the lights will be
switched back on according to the
position of the ring 2.
NB: if the fog lights are lit, the lights are
not switched off automatically.
“See-me-home lighting”
function
Depending on the vehicle, this func -
tion allows you to briefly switch on the
dipped beam headlights (to provide
light when opening a gate, etc.).
With the engine and lights off and
ring 2 in the 0 position, pull stalk 1 to-
wards you: the dipped beam head -
lights light up for approximately thirty
seconds. To increase this duration,
you may pull the stalk up to four times
(total time restricted to two minutes).
Depending on the vehicle, the message
“See-me-home _ _ _” accompanied by
the lighting time is displayed on the in-
strument panel to confirm the action.
To switch off the lights before they go
out automatically, turn ring 2 to any po-
sition, then return it to position 0.
lights-on reminder buzzer
If the lights are on after the engine is
switched off, a warning beep sounds
when the driver ’s door is opened to
warn you that the lights are still on.12