buttons RENAULT FLUENCE ZERO EMISSION 2012 1.G Owners Manual

keys ...................................................... (up to the end of the DU)
children ................................................. (up to the end of the DU)
child safety ............................................ (up to the end of the DU)
locking the doors .................................. (up to the end of the DU)
1.15
ENG_UD21527_3
Télécommande à radiofréquence : généralités (L38 -\
X38 - Renault)
ENG_NU_914-4_L38e_Renault_1
Key, radio frequency remote control: general information, use, deadlocking
KeY/rADiO FreqUeNcY remOte cONtrOl: general information
41
2
3
5
radio frequency remote
control operating range
This varies according to the surround-
ings: please take care not to lock or
unlock the doors by inadvertently press-
ing the buttons on the remote control.
interference
The presence of certain objects (metal
objects, mobile telephones, or an area
with strong electromagnetic radiation,
etc.) close to the key may create inter-
ference and affect the operation of the
system.
radio frequency remote
control
1 Locking the doors and tailgate.
2 Unlocking the doors and tailgate.
3 Driver’s door and ignition key.
4 To release the key from its hous -
ing, press button 4 . It will be re -
leased automatically.
To reinsert it in its housing, press
button 4 and guide the key into the
storage position.
5 Unlocking/Locking the boot only.
The key must not be used for any
function other than those described
in the handbook (removing the cap
from a bottle, etc.).
For replacement, or if you
require an additional remote
control
If you lose your remote control or
require another, you can obtain one
from an approved Dealer.
If a remote control is replaced, it
will be necessary to take the vehi -
cle and all of its remote controls to
an approved Dealer to initialise the
system.
You may use up to four remote con-
trol units per vehicle.
remote control unit failure
Make sure that the correct battery
type is being used, and that the
battery is in good condition and in -
serted correctly. These batteries
have a service life of approximately
two years.
Refer to the information on “Radio
frequency remote control: Batteries”
in Section 5.
Advice
Avoid leaving the remote control in
hot, cold or humid areas.

keys ...................................................... (up to the end of the DU)
locking the doors .................................. (up to the end of the DU)
1.16
ENG_UD21528_3
Télécommande à radiofréquence : utilisation (L38 - X38 - Re\
nault)
ENG_NU_914-4_L38e_Renault_1
Unlocking the doors
Press button 2 to unlock.
The hazard warning lights and indica -
tor lights flash once to indicate that the
doors have unlocked.
NB: unlocking the doors will unlock the
vehicle charging cord.
KeY/rADiO FreqUeNcY remOte cONtrOl: use
locking the doors
Press locking button 1.
The indicator lights and hazard warning
lights flash twice to indicate that the
doors have locked:
If an opening element (door or boot) is
open or not properly closed, the open -
ing elements quickly lock then unlock
and the hazard warning lights and indi -
cator lights do not flash.
NB: while charging the traction battery,
locking the opening elements will lock
the vehicle charging cord.
3
1
2
Unlocking/locking the boot
only
(for some countries)
Press button 3 to unlock or lock the
boot.
The hazard warning lights and indica -
tor lights flash once to indicate that the
tailgate is unlocked if the vehicle doors
are locked.
The hazard warning lights and indica -
tor lights flash twice to indicate that the
luggage compartment lid is locked if the
vehicle doors are locked.
Driver’s responsibility
Never leave your vehi -
cle with the key inside and
never leave a child (or a
pet) unsupervised, even for a short
while.
They may pose a risk to themselves
or to others by starting the engine,
activating equipment such as the
electric windows or by locking the
doors.
Risk of serious injury.
The card buttons are deactivated
when the engine is running.
The flashing status of the hazard
warning lights informs you of the ve-
hicle status:
– one flash indicates that the vehi-
cle is completely unlocked;
– two flashes indicate that the ve-
hicle is completely locked.

JauneNoirNoir texte
1.63
ENG_UD25303_2
Ordinateur de bord : paramètres de voyage (L38 électrique - Renau\
lt)
ENG_NU_914-4_L38e_Renault_1
triP cOmPUter AND WArNiNg SYStem: journey parameters (3/4)
examples of selectionsinterpreting the display selected
Service due in
c) Service interval.
Distance remaining until the next service (displayed in miles/kilome -
tres), then when the service nears, several scenarios are possible:
– distance/time remaining less than 900 miles (1,500 km) or one
month: the message “Service due in” is displayed accompanied by
the nearest term (distance or time);
– distance/time remaining 0 km/miles or service date reached: the
message “Service vehicle” is displayed accompanied by the
©
warning light.
The vehicle requires a service as soon as possible.
1936 km
resetting the display after the service in accordance with the maintenanc\
e schedule.
The service interval must only be reset after a service which complies with the recommendations in the maintenance schedule.
Special note: To reset the service interval, press and hold one of the display reset buttons for approximately 10 seconds until
the display shows the mileage permanently.
the display of information shown below DePeNDS ON the vehicle eqUiPmeNt AND cOUNtr
Y.

JauneNoirNoir texte
3.5
ENG_UD23016_2
Climatisation automatique (L38 électrique - Renault)
ENG_NU_914-4_L38e_Renault_3
AuT omATIc clImATE coNTRol (2/5)
Varying the ventilation speed
In automatic mode, the system uses
the most suitable amount of air to reach
and maintain the desired comfort level.
You can still adjust the ventilation speed
by pressing buttons 12 to increase or
reduce the ventilation speed.
In this case, the ventilation speed,
which is no longer controlled automat-
ically, appears in zone A on the dis -
play 13.
Some buttons have an operating
tell-tale which indicates the operat -
ing status.
121
3
Temperature adjustment
Press button 1 or 6 to raise or lower the
left-hand 1 or right-hand 6 temperature.
Pressing button 3 for more than 2 sec-
onds sets the passenger temperature
to the driver’s temperature.
Special note: the highest and lowest
settings allow the system to produce
maximum hot or cold temperature
levels (“LO” and “HI” on display 13).
6
A13
clear View function
Press button 10 : the integrated indica -
tor light comes on.
This function quickly demists and de -
ices the windscreen, the rear screen,
the front side windows, and the door
mirrors (depending on the vehicle). The
air conditioning and rear screen de -ic -
ing functions must be activated.
Press button 9 to stop the heated rear
screen operating; the integrated indica -
tor goes out.
You can change the fan speed: press
buttons 12.
To exit this function, press:
– button 10 again,
– one of either button 2, 3 or 4.
109
24

3.10
ENG_UD26163_3
Climatisation automatique : préchambrage (L38 électrique - Renaul\
t)
ENG_NU_914-4_L38e_Renault_3
Activating the function
– With the ignition switched on and the
air-conditioning operating (please
refer to the information on “Automatic
air-conditioning” in Section 3);
– press button 2
ṗ until the ṕ
or
Ṗ symbol is displayed on dis -
play 1;
– switch off the ignition;
– put your vehicle on charge.
The function is triggered one hour prior
to the programmed time to reach a
comfortable temperature.
Automatically switching off the
function
– about 30 minutes after the pro -
grammed time;
– if the charging socket is discon -
nected;
– if the
ṕ or Ṗ no longer appear
on display 1 when you press button 2
ṗ.
AIR coNDITIoNINg: programming (2/2)
– hold down button A or B - the hours
flash;
– press buttons A and B to set the
hour;
– hold down button A or B to confirm
the hour setting;
– the minutes flash - press buttons A
and B to set the minutes;
– hold down button A or B to confirm
the minutes setting. Your settings are
now saved.3
4
B
Programming the function start time
Two different times can be pro -
grammed.
– to programme the start tie, hold
down button A or B on stalk 4 until
the message “Settings menu” ap -
pears on display 3;
– scroll down the menu using but -
tons A and B until the
ṕ or Ṗ
symbol appears;
A
The two programmed times cannot
be activated simultaneously.