diagram RENAULT KANGOO 2013 X61 / 2.G Lighting Workshop Manual

8Electrical equipment
V1 MR-376-X76-80D000$TOC.mif
V1
80D
"The repair procedures given by the manufacturer in this document are based on the
technical specifications current when it was prepared.
The procedures may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from
which his vehicles are constructed."
V1
All rights reserved by Renault s.a.s.
Edition Anglaise
Copying or translating, in part or in full, of this document or use of the service part
reference numbering system is forbidden without the prior written authority of
Renault s.a.s.
© Renault s.a.s. 2013
LIGHTING
UCH
Vdiag No.: 0F
Fault finding – Introduction 80D - 2
Fault finding – Role of components 80D - 4
Fault finding – Operating diagram 80D - 5
Fault finding – Function 80D - 11
Fault finding – Configuration 80D - 13
Fault finding – Conformity check 80D - 14
Fault finding – Status summary table 80D - 15
Fault finding – Interpretation of statuses 80D - 16
Fault finding – Command summary table 80D - 20
Fault finding – Interpretation of commands 80D - 21
Fault finding – Customer complaints 80D - 26
Fault finding – Fault Finding Chart 80D - 27

80D-2V1 MR-376-X76-80D000$010.mif
80D
UCH
Vdiag No.: 0F
1. SCOPE OF THIS DOCUMENT
This document presents the fault finding method applicable to all computers with the following specifications:
2. PREREQUISITES FOR FAULT FINDING
Documentation type
Fault finding procedures (this manual):
– Assisted fault finding (integrated into the diagnostic tool), Dialogys.
Wiring Diagrams:
– Visu-Schéma.
Type of diagnostic tools
–CLIP
Special tooling required
*VLL — Very Long LifeVehicle(s): KANGOO VLL*
Function concerned: LIGHTINGName of computer: UCH
Vdiag No.:
0F
Special tooling required:
Diagnostic tool
Multimeter
Elé. 1622Bornier
Elé. 1681Universal bornier
UCH_V0F_PRELI
LIGHTING
Fault finding – Introduction

80D-5V1 MR-376-X76-80D000$030.mif
80D
UCH
Vdiag No.: 0F
Indicator lights
• List of system components and associated component codes:
• Indicator lights diagram645Passenger compartment electrical control unit
260Passenger compartment fuse box and relay
125Hazard warning lights switch
172Rear right-hand light
173Rear left-hand light
255Front right-hand indicator light
256Front left-hand indicator light
267Right-hand repeater
268Left-hand repeater
209Lighting stalk
LIGHTING
Fault finding – Operating diagram

80D-6V1 MR-376-X76-80D000$030.mif
LIGHTING
Fault finding – Operating diagram80D
UCH
Vdiag No.: 0F
Side lights
• List of system components and associated component codes:
• Side lights diagram645Passenger compartment electrical control unit
260Passenger compartment fuse box and relay
166Right-hand number plate light
167Left-hand number plate light
172Rear right-hand light
173Rear left-hand light
184Right-hand side light
185Left hand side lights
209Lighting stalk
247Instrument panel

80D-7V1 MR-376-X76-80D000$030.mif
LIGHTING
Fault finding – Operating diagram80D
UCH
Vdiag No.: 0F
Main beam headlights
• List of system components and associated component codes:
• Main beam headlights diagram226Right hand headlight
227Left hand headlight
247Instrument panel
260Passenger compartment fuse box and relay
209Lighting stalk

80D-8V1 MR-376-X76-80D000$030.mif
LIGHTING
Fault finding – Operating diagram80D
UCH
Vdiag No.: 0F
Dipped headlights
• List of system components and associated component codes:
• Dipped beam headlights diagram260Passenger compartment fuse box and relay
226Right hand headlight
227Left hand headlight
247Instrument panel
537Left headlight corrective motor
538Right headlight corrective motor
209Lighting stalk

80D-9V1 MR-376-X76-80D000$030.mif
LIGHTING
Fault finding – Operating diagram80D
UCH
Vdiag No.: 0F
Front fog lights
• List of system components and associated component codes:
• Front fog lights diagram260Passenger compartment fuse box and relay
176Right-hand front fog light
177Left-hand front fog light
231Front fog relay
247Instrument panel
209Lighting stalk

80D-10V1 MR-376-X76-80D000$030.mif
LIGHTING
Fault finding – Operating diagram80D
UCH
Vdiag No.: 0F
Rear fog light
• List of system components and associated component codes:
• Rear fog light diagram260Passenger compartment fuse box and relay
173Rear left-hand light
247Instrument panel
209Lighting stalk

80D-16
AFTER REPAIRCarry out another fault finding check on the system.
Deal with any other faults.
Clear the stored faults.
V1 MR-376-X76-80D000$080.mif
80D
UCH
Vdiag No.: 0F
ET484SIDE LIGHTS SIGNAL
NOTESThere must be no present or stored faults.
Move the side lights switch.
The status should be PRESENT and the side lights illuminated.
Special Note:
Use Wiring Diagrams Technical Note for Kangoo VLL.
"ABSENT"
Check for the presence and condition of fuses F31 and F32 (10 A) on the passenger
compartment fuse and relay box, component code 260 (see MR 374, Mechanical,
81C, Fuses, Fuses: List and location of components).
Check the connection and condition of the UCH connector, component code 645.
If the connector is faulty and there is a repair method (see Technical Note 6015A,
Repairing electrical wiring, Wiring: Precautions for repair), repair the connector,
otherwise replace the wiring.
Check for + 12 V on connection BP11 of the lighting stalk, component code 209.
If the connection is faulty and there is a repair procedure (see Technical Note 6015A,
Electrical wiring repair, Wiring: Precautions for repair), repair the wiring,
otherwise replace it.
Check the operation of the side light control:
With the side light illuminated, check the continuity between connections BP11 and
L of component 209.
If the connection or connections are faulty and if there is a repair procedure (see
Technical Note 6015A, Electrical wiring repair, Wiring: Precautions for repair)
repair the wiring, otherwise replace it.
Check the continuity of the following connection:
•L between components 209 and 260.
If the connection is faulty and there is a repair procedure (see Technical Note 6015A,
Electrical wiring repair, Wiring: Precautions for repair), repair the wiring,
otherwise replace it.
If the fault is still present, contact the techline.
UCH_V0F_ET484
LIGHTING
Fault finding – Interpretation of statuses

80D-17
AFTER REPAIRCarry out another fault finding check on the system.
Deal with any other faults.
Clear the stored faults.
V1 MR-376-X76-80D000$080.mif
LIGHTING
Fault finding – Interpretation of statuses80D
UCH
Vdiag No.: 0F
ET485HAZARD WARNING LIGHTS SIGNAL
NOTESThere must be no present or stored faults.
Activate the hazard warning lights switch.
The status should be PRESENT.
Special Note:
Use Wiring Diagrams Technical Note for Kangoo VLL.
"ABSENT"
Check for the presence and condition of supply fuse F31 (10 A) on the passenger
compartment fuse and relay box, component code 260 (see MR 374 Mechanical,
81C, Fuses, Fuses: List and location of components).
Check the connection and condition of the hazard warning lights switch connector,
component code 125.
If the connector is faulty and there is a repair method (see Technical Note 6015A,
Repairing electrical wiring, Wiring: Precautions for repair), repair the connector,
otherwise replace the wiring.
Check the operation of the hazard warning lights control.
Check the continuity between the following connections:
•64Q and MK of component 125,
•MK and 64D of component 125.
If the connection or connections are faulty and if there is a repair procedure (see
Technical Note 6015A, Electrical wiring repair, Wiring: Precautions for repair)
repair the wiring, otherwise replace it.
Check the continuity of the following connection:
•64D between components 125 and 645.
If the connection is faulty and there is a repair procedure (see Technical Note 6015A,
Electrical wiring repair, Wiring: Precautions for repair), repair the wiring,
otherwise replace it.
UCH_V0F_ET485