AUX RENAULT KOLEOS 2015 1.G Owners Manual

JauneNoir Noir texte
29
ENG_UD20768_2
Dispositifs complémentaires aux ceintures arrière (X45 - H45 - Renault) ENG_NU_1057-1_H45_Ph3_Renault_1
METHODS OF RESTRAINT IN ADDITION TO THE REAR SEAT BELTS
Force limiter
Above a certain level of impact force,
this mechanism is used to limit the force
of the belt against the chest so that it is
at an acceptable level.
– Have the entire restraint system checked following an accident.
– No operation whatsoever is permitted on any part of the system (pre-
tensioners, air bags, computers, wiring) and the system components
must not be reused on any other vehicle, even if identical.
– To avoid incorrect triggering of the system which may cause injury, only quali-
fied personnel from an approved dealer may work on the pretensioner and air
bag system.
– The ignition module electrical specifications may only be tested by a specially
trained technician using special equipment.
– When the vehicle is scrapped, contact an approved dealer for disposal of the
pretensioner and air bag gas generators.

JauneNoir Noir texte
70
ENG_UD23570_3
Réglage électrique de la hauteur des faisceaux (X45 - H45 - Renault) ENG_NU_1057-1_H45_Ph3_Renault_1
ELECTRIC BEAM HEIGHT ADJUSTMENT
Examples of positions for adjusting control A according to the load
0
0
1
1
2
3 On equipped vehicles, control A allows
you to adjust the height of the beams
according to the load.
Turn control A downwards to lower the
headlights and upwards to raise them.
For vehicles not fitted with control A,
adjustment is automatic.
A

JauneNoir Noir texte
165
ENG_UD28051_5
Niveaux/filtres (X45 - H45 - Renault) ENG_NU_1057-1_H45_Ph3_Renault_4
LEVELS, FILTERS (1/3)
1
Coolant
With the engine switched off and on
level ground, the level when cold must
be between the “MIN” and “MAX”
marks on coolant reservoir 1.
Top this level up when cold before the
“MIN” mark is reached.Checking intervals
Check the coolant level regularly
(very severe damage is likely to be
caused to the engine if it runs out of
coolant).
If the level needs to be topped up, only
use products approved by our Technical
Department which ensure:
– protection against freezing;
– anticorrosion protection of the cool-
ing system.Replacement intervals
Refer to the Maintenance Document for
your vehicle.
No operations should be
carried out on the cooling
circuit when the engine is
hot.
Risk of burns.
Consult your approved dealer at
once if you notice an abnormal or
repeated drop in any of the fluid
levels.

JauneNoir Noir texte
166
ENG_UD28051_5
Niveaux/filtres (X45 - H45 - Renault) ENG_NU_1057-1_H45_Ph3_Renault_4
LEVELS, FILTERS (2/3)
2
Brake fluid level
This should be checked frequently,
and immediately if you notice even the
slightest loss in braking efficiency.
The level should be read with the engine
switched off and on level ground.Level 2
It is normal for the level to drop as
the linings become worn, but it should
never drop below the “MIN” warning
line.
If you wish to check the disc and drum
wear yourself, you should obtain the
document explaining the checking pro-
cedure from our network or from the
manufacturer’s website.Topping up
After any operation on the hydraulic cir-
cuit, a specialist must replace the fluid.
Only use fluids approved by our
Technical Department (and taken from
a sealed container).
Replacement intervals
Refer to the Maintenance Document for
your vehicle.
The engine may be hot
when carrying out opera-
tions in close proximity. In
addition, the engine cooling
fan can come on at any moment.
Risk of injury.
Consult your approved dealer at
once if you notice an abnormal or
repeated drop in any of the fluid
levels.

JauneNoir Noir texte
167
ENG_UD28051_5
Niveaux/filtres (X45 - H45 - Renault) ENG_NU_1057-1_H45_Ph3_Renault_4
LEVELS, FILTERS (3/3)
Note
Depending on the vehicle, to find
out the fluid level, open cap 3, pull
out the dipstick and read the level
again.
3
Windscreen/headlight washer
reservoir
Topping up
Open cap 3, fill until you can see the
fluid, then refit the cap.Liquid
Screen wash product (product with
antifreeze in winter).
Jets
Use a tool such as a needle to adjust
the height of the windscreen washer
jets.
Filters
The replacement of filter elements (air
filter, passenger compartment filter,
diesel filter, etc.) is scheduled in the
maintenance operations for your vehi-
cle.
Replacement intervals for filter el-
ements: refer to the Maintenance
Document for your vehicle.
The engine may be hot
when carrying out opera-
tions in close proximity. In
addition, the engine cooling
fan can come on at any moment.
Risk of injury.