battery replacement RENAULT SCENIC 2013 J95 / 3.G Electrical Equipment Immobiliser Workshop Manual

82A-11V1 MR-372-J84-82A000$050.mif
82A
SVT
Vdiag No.: 04
To remove and refit the computer, consult the Repair Manual for the vehicle concerned:
– LOGAN and SANDERO: MR 388, Mechanical, 82A, Immobiliser, Tracking unit: Removal - Refitting.
– DUSTER: MR 451, Mechanical, 82A, Immobiliser, Tracking unit: Removal - Refitting.
– MEGANE II: MR 364, Mechanical, 82A, Immobiliser, Tracking unit: Removal - Refitting.
– SCENIC II: MR 370, Mechanical, 82A, Immobiliser, Tracking unit: Removal - Refitting.
– MASTER II ph2 and ph3: MR 377, Mechanical, 82A, Immobiliser, Tracking unit: Removal - Refitting.
– THALIA 2/SYMBOL 2: MR 423, Mechanical, 82A, Immobiliser, Tracking unit: Removal - Refitting.
– Clio II F6: MR 430, Mechanical, 82A, Immobiliser, Tracking unit: Removal - Refitting.
– KANGOO VLL: MR 374, Mechanical, 82A, Immobiliser, Tracking unit: Removal - Refitting.
Procedure to be applied before repair:
– With the approval of the Techline, read the fault code to determine whether the fault is detected before replacing
the computer.
– Switch off the ignition and remove the computer.
Before replacing the computer, switch off the ignition and wait 1 minute for the system to shut down completely.
Note the current configuration of the computer by reading the configuration LC001 External GPS aerial.
Procedure to be applied after repair:
After replacing the computer, apply the programming command VP001 Enter VIN, check the computer configuration
using LC001 External GPS aerial, LC002 Timed + battery feed and LC003 Alarm and configure the new
computer if necessary using CF001 CONFIGURE SVT.
ENGINE IMMOBILISER
Fault finding – Replacement of components

82A-16
AFTER REPAIRAfter replacing the computer, consult the Replacement of components section.
Deal with any faults displayed by the diagnostic tool.
Clear the faults from the computer memory using command RZ001 Fault memory.
V1 MR-372-J84-82A000$070.mif
ENGINE IMMOBILISER
Fault finding – Interpretation of faults82A
SVT
Vdiag No.: 04
DF004
PRESENT
OR
STOREDBATTERY INTERNAL FAULT
NOTESSwitch on the vehicle + after ignition feed.
Conditions for applying the fault finding procedure to stored faults:
The fault is declared present if the battery voltage is X < 3.5 V after 5 voltage checks.
Check the voltage and the battery connections, component code 107.
Repair if necessary.
If the fault is still present and the internal battery is currently charging, wait for approximately 2 hours so that the
internal battery voltage is X > 3.5 V.
If the fault is still present, replace the anti-theft tracking unit, component code 2186 (see MR 388, 451, 364, 370,
377, 423, 430 or 374, Mechanical, 82A, Immobiliser, Tracking unit: Removal - Refitting).
If the fault is still present, contact the Techline.
SVT_V04_DF004