remote control RENAULT TWINGO 2002 1.G Alarm 7895-7897 User Manual

Downloaded from www.Manualslib.com manuals search engine 6GB
INTRODUCTION
This anti-intrusion alarm system is controlled by the original remote control of the
vehicle.
Total protection for your vehicle is ensured by:
1.Door, bonnet, boot protection.
2.Volumetric protection.
3.Protection against wire cutting.
4.Protection against attempts to start the engine.
BRIEF INSTRUCTIONS
Arming
When the doors are shut:
The turn indicators will flash twice.
The protections will become activated once 60 seconds have elapsed.
NOTE: if the door on the driver’s side remains open, the doors will not lock, the turn
indicators will not flash and the alarm system will fail to arm.
If one of the other doors, the bonnet or boot remain open, the doors will lock, the turn
indicators will not flash but the system will arm and signal the fault by a continuous
buzzer sound.
Shut the door again.
DisarmingWhen the doors are unlocked with the original remote control:
The turn indicators will flash.
The protections will immediately deactivate.
NOTE: If an alarm has occurred, the buzzer and turn indicators will give 4 signals instead
of 1.
ProtectionAfter the system has been armed for at least 60 seconds (when the led of the internal
door locking button has gone out), opening of the bonnet, boot, one of the doors or
intrusion into the passenger compartment will generate a ringing and visual alarm cycle
lasting about 30 seconds.
The system will remain activated at the end of the cycle.
Interruption of an alarm in progressWhen the system is in the alarm status, the siren and turn indicator flashing function can
be deactivated by unlocking the doors with the original remote control.
ADVANCED FUNCTIONS
Deactivation of the ultrasonic volumetric sensor
The volumetric sensor can be deactivated to prevent alarms from being signalled if the
car is washed, if you wish to arm the system with the windows open or if a passenger
remains inside the vehicle.
ALARM MEMORY (option)
If an alarm has occurred the buzzer and the turn indicators will give four signals instead
of one.
The alarm description information is given by different LED blinking, which will be
available until the ignition key will be turned ON. See the table below.
User manual
LED signal Alarm description
1 blink doors, bonnet, boot have been opened
2 blinks additional sensor triggered
3 blinks ultrasonic volumetric sensor triggered
4 blinks attempts to start (ignition key)
6 blinks tamper mode
7 blinks serial line communication error