stop start RENAULT TWINGO 2009 2.G Chasiss Workshop Manual

37A-56
MECHANICAL COMPONENT CONTROLS
Clutch circuit: Bleed
JH3 or JR5
37A
Bleed screw with two clips.
aTo open the bleed screw, lower the clip (6) and lift
the clip (7) while pulling by one notch.
III - BLEED PROCEDURE IF NO PARTS OF THE
HYDRAULIC CIRCUIT ARE REMOVED
1 - Bleed using the ARC50.
aKeep the clutch pedal in the upper position using a
strap attached to the steering wheel to ensure conti-
nuity of the hydraulic circuit during the bleed opera-
tion.aConnect the brake circuit bleeding device (after
having received Renault approval) to the master cyl-
inder reservoir (see the instructions for the equip-
ment).
aRemove the bleed plug from the clutch slave cylin-
der.
aConnect a transparent pipe to the bleed hole running
to an empty container placed under the bleed hole.
aOpen the bleed screw.
aOpen the circuit between the bleeding device and
the brake fluid reservoir.
aLet the brake fluid run until all air bubbles have been
released.
aStop the bleeding device to dump the pressure in the
clutch circuit.
aClose the bleed screw.
aRemove the transparent pipe from the bleed hole.
aRefit the bleed plug.
aTop up the brake fluid level in the master cylinder
reservoir after disconnecting the bleed device.
aDisengage and engage the clutch quickly around
twenty times.
aCheck that the clutch system is operating correctly.
aRepeat the bleed operation if necessary.
aCheck the adjustment of the switch. (see 37A, Me-
chanical component controls, Clutch pedal
switch: Removal - Refitting, page 37A-52) (37A,
mechanical control elements).
113732
Note:
Ta k e c are not to disrupt the adjustment of the
clutch start of travel switch.