language RENAULT TWINGO 2009 2.G Electrical Equipment - Battery Workshop Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 2009, Model line: TWINGO, Model: RENAULT TWINGO 2009 2.GPages: 8, PDF Size: 0.05 MB
Page 5 of 8
80A-5
MR-413-X44-80A000$750.mif
V4
80A
BATTERY
Battery – Check
Test procedure using the MIDTRONICS tool
Test conditions
The measurement must be taken when the vehicle is stationary and the ignition is off.
If the engine has been run in the last hour, switch the battery status to test and carry out the following operations:
•engine switched off,
•switch on the main beam headlights for 2 minutes,
•switch off the main beam headlights,
•wait for 2 minutes,
•switch off the ignition.
Equipment to be used:
•Tester approved by the Service Department: MIDTRONICS MICRO R330.
•Tool available as part no.: Elé. 1593.
•Equipment available in France from the Parts Department.
•Tool available in 6 languages.
For other countries, consult your contact in your country. Special tooling required
Elé. 1593 Battery tester
MIDTRONICS R330
WARNING
Failure to observe the procedure or poorly maintained equipment may result in incorrect measurements, which
could be:
–detrimental to the customer (the battery is not sound),
–detrimental to RENAULT (unnecessary replacement of a sound or rechargeable battery),
–detrimental to the dealership (if the battery is tested as sound or rechargeable for a part return under
warranty, the warranty reimbursement request will be cancelled).
MR-413-X44-80A000$750.mif
Page 6 of 8
80A-6
MR-413-X44-80A000$750.mif
V4
BATTERY
Battery – Check80A
Mode (test on vehicle)
–Connect the tool directly to the battery terminals, without disconnecting the vehicle battery, as close as possible to
the battery terminal but ensuring it is not after the fuse (on-vehicle test) or carry out the battery test after
disconnecting the two terminals if necessary,
–check that the vehicle ignition is switched off,
–select the type of test: "battery connected to vehicle" or "battery disconnected" using
buttons and . Confirm using the green button .
–The test is carried out to the EN standard by default. Confirm using the green button .
–Select the starting power inscribed on the battery label (see page 3) using
buttons and .
–Confirm using the green button
–The tool displays TEST IN PROGRESS.
–The MIDTRONICS tool carries out the test and gives the results of the fault finding procedure.
To set the tool language, carry out the following operations:
–before connecting the tool, simultaneously press buttons and ,
–connect the device to the battery,
–release the buttons,
–scroll through the languages using buttons and ,
–confirm using the green button .
Note:
The battery must always be disconnected in the following order:
–Wait for at least 1 minute between switching the ignition off and disconnecting the battery, to enable the
computer systems to go on standby.
–Wait for the engine cooling fan to stop completely.
–Disconnect the negative terminal first.