low beam RENAULT TWINGO 2009 2.G Electrical Equipment - Battery Workshop Manual

80A-5
MR-413-X44-80A000$750.mif
V4
80A
BATTERY
Battery – Check
Test procedure using the MIDTRONICS tool
Test conditions
The measurement must be taken when the vehicle is stationary and the ignition is off.
If the engine has been run in the last hour, switch the battery status to test and carry out the following operations:
•engine switched off,
•switch on the main beam headlights for 2 minutes,
•switch off the main beam headlights,
•wait for 2 minutes,
•switch off the ignition.
Equipment to be used:
•Tester approved by the Service Department: MIDTRONICS MICRO R330.
•Tool available as part no.: Elé. 1593.
•Equipment available in France from the Parts Department.
•Tool available in 6 languages.
For other countries, consult your contact in your country. Special tooling required
Elé. 1593 Battery tester
MIDTRONICS R330
WARNING
Failure to observe the procedure or poorly maintained equipment may result in incorrect measurements, which
could be:
–detrimental to the customer (the battery is not sound),
–detrimental to RENAULT (unnecessary replacement of a sound or rechargeable battery),
–detrimental to the dealership (if the battery is tested as sound or rechargeable for a part return under
warranty, the warranty reimbursement request will be cancelled).
MR-413-X44-80A000$750.mif