navigation system RENAULT TWINGO 2009 2.G Electrical Equipment - Battery Workshop Manual

80A-2
MR-413-X44-80A000$250.mif
V4
80A
BATTERY
Battery – Initialisation
When removing or disconnecting the battery, check that the battery is working correctly by performing a number of
initialisations on different vehicle functions. These initialisations do not require a tool of any kind.
Anti-theft code:
–Entering a 4-digit radio or radionavigation code (see 86A, Radio, Radio: Protection code). Setting the time on
the radio or the radio navigation system:
–To set the radio navigation system time, enter the four digit code. Insert the navigation CD-ROM then drive the
vehicle to pick up the satellite signals. It is now possible to set the time (see 86A, Radio, Radio: Setting the
time).
Initialisation of the window winders:
–Check that the electric windows are still initialised. The windows should open and close when the switch is
pressed. If this does not happen, re-initialise (see 87D, Electric windows - sunroof, Electric windows:
Initialisation).
Initialising the sunroof:
–Check that the sunroof is still initialised. The sunroof should open or close to the requested position without
stopping. If this does not happen, re-initialise (see 87D, Electric windows - Sunroof, Electric sunroof:
Initialisation).
Initialising the electric power assisted steering:
–In order that the electric power-assisted steering recognises the "steering wheel angle" signal, move the steering
wheel from lock to lock with the engine running (see 36B, Power-assisted steering, Fault finding -
Replacement of components).
Initialising the computers:
– The other computers are automatically initialised when the vehicle is being driven. Drive the vehicle for at least
1 minute at a speed greater than 18 mph (30 km/h) so that the tyre pressures are displayed again.
MR-413-X44-80A000$250.mif