stop start RENAULT TWINGO 2009 2.G Engine And Peripherals Workshop Manual

11A-2
TOP AND FRONT OF ENGINE
Pressure at end of compression: Check
D4F
11A
CHECK
I - PREPARATION OPERATION FOR CHECK
aRemove the plugs (see 17A, Ignition, Plugs: Re-
moval - Refitting, page 17A-12) .
aConnect a petrol compression gauge (1) .
aRun command with Diagnostic tool :
-RZ009: VEHICLE FUNCTION PROGRAMMING,
-VP036: FUEL SUPPLY INHIBITION.
aPut the vehicle under the starting conditions by posi-
tioning the gear lever in neutral.II - TEST OPERATION
aActivate the starter until the needle of the petrol
compression gauge stabilises.
aMeasure the cylinder compressions, cylinder by cyl-
inder.
aFully depress the accelerator pedal in order to open
the throttle valve during the compression measure-
ments.
III - FINAL OPERATION
aDisconnect the petrol compression gauge.
aRefit the plugs (see 17A, Ignition, Plugs: Removal
- Refitting, page 17A-12) .
aRun command VP037: "STOP INHIBIT FUEL SUP-
PLY" using the Diagnostic tool.
aStart the engine. Equipment required
petrol compression gauge
Diagnostic tool
Note:
Use a petrol compression gauge compatible with
the special tools.
The petrol compression gauge must be equipped
with a universal end piece (rubber), or a gaz 1/4
thread bolt.
132699
Note:
It is necessar y to wait for at least 10 seconds
before starting the engine each time (the starter
will not run due to its ther mal protection).
Note:
If the engine does not start, run command
VP037: STOP FUEL SUPPLY INHIBITION using
the Diagnostic tool or switch off the ignition and
wait 1 min before starting the engine again.

11A-33
TOP AND FRONT OF ENGINE
Timing belt: Removal - Refitting
D4F
11A
II - OPERATION FOR REMOVAL OF PART
CONCERNED
1 - Adjusting the timing
aTurn the crankshaft clockwise (timing end). Stop a
half-tooth before the crankshaft sprocket mark is
lined up with the fixed marking.a
aInsert the TDC setting pin (Mot. 1054).
aTurn the crankshaft clockwise until it is stopped.
109737
109735
Note:
Cer tain vehicles are fitted with a flywheel protec-
tor positioned on the setting opening.
In this case, it is necessar y to remove the starter
and protector to be able to insert the TDC setting
pin.