headlight RENAULT TWINGO 2009 2.G Mechanism And Accessories Workshop Manual

55A-3
EXTERIOR PROTECTION
Front bumper: Stripping - Rebuilding
55A
STRIPPING
I - STRIPPING PREPARATION OPERATION
aRemove the front bumper (see 55A, Exterior pro-
tection, Front bumper: Removal - Refitting, page
55A-1) .
II - STRIPPING OPERATION FOR PART
CONCERNED
aRemove the front fog lights (depending on equip-
ment level) (see Front fog light: Removal - Refit-
ting) (MR 411, 80B, Headlights).
aNote the position of the electrical wiring (depending
on equipment level).
aRemove the electrical wiring (depending on equip-
ment level).
aRemove the bolts (1) .
aUnclip the badge.aUnclip the centre absorber (2) .
aDrill out rivets (3) .
aRemove the lower cover.
120886
120888
120887

55A-5
EXTERIOR PROTECTION
Front bumper: Stripping - Rebuilding
55A
aInsert rivets into the lower cover at (3) .
aClip on:
-the central absorber (2) ,
-the badge.
aRefit:
-the bolts (1) ,
-the electrical wiring (depending on equipment le-
vel),
-the front fog lights (depending on the equipment le-
vel) (see Front fog light: Removal - Refitting)
(MR 411, 80B, Headlights).
II - FINAL OPERATION.
aRefit the front bumper (see 55A, Exterior protec-
tion, Front bumper: Removal - Refitting, page
55A-1) .

55A-6
EXTERIOR PROTECTION
Front bumper: Stripping - Rebuilding
C44, and EQUIPMENT LEVEL SPORT
55A
STRIPPING
I - STRIPPING PREPARATION OPERATION
aRemove the front bumper (see 55A, Exterior pro-
tection, Front bumper: Removal - Refitting, page
55A-1) .
II - STRIPPING OPERATION FOR PART
CONCERNED
aRemove the front fog lights (see Front fog light:
Removal - Refitting) (80B, Headlights).
aRemove the bolts (1) .
aUnclip the badge.aUnclip the centre absorber (2) .
120886
132040

55A-9
EXTERIOR PROTECTION
Front bumper: Stripping - Rebuilding
C44, and EQUIPMENT LEVEL SPORT
55A
II - REBUILDING OPERATION FOR PART
CONCERNED
aPlace the decorative strip to be bonded on the front
bumper and centre it visually.
aStick the decorative strip down taking care to keep it
properly aligned.
aClip:
-the « front side extender - front extender - fog light
support » assembly,
-the aerodynamic component.
aDrill a hole at each clip position (7) using a ∅ 4.5 mm
drill bit.
aRivet the aerodynamic component.
aClip the lower grille and the radiator grille onto the
tabs provided using the clips (part no.: 77 03 076
037).
aRefit the diffuser.
aClip on the lower absorber (4) .
aRefit new rivets.
aClip:
-the central absorber (2) ,
-the badge.
aRefit the front fog lights (see Front fog light: Remo-
val - Refitting) (80B, Headlights).
III - FINAL OPERATION.
aRefit the front bumper (see 55A, Exterior protec-
tion, Front bumper: Removal - Refitting, page
55A-1) .