bonnet RENAULT TWINGO 2009 2.G Panelwork User Guide

48A-3
NON-SIDE OPENING ELEMENTS
Bonnet: Stripping - Rebuilding
48A
STRIPPING
STRIPPING OPERATION FOR PART CONCERNED
aDisconnect the pipe at (1) .
aUnclip:
-the pipe at (2) ,
-the jets.
aRemove the different blanking covers from the bon-
net.
REBUILDING
REBUILDING OPERATION FOR PART
CONCERNED
aRefit the different blanking covers on the bonnet.
aClip:
-the jets,
-the pipe at (2) .
aConnect the pipe at (1) .
112036

48A-4
NON-SIDE OPENING ELEMENTS
Bonnet: Adjustment
48A
ADJUSTMENT
aFor information on the adjustment values for the
bonnet (see Vehicle panel gaps: Adjustment va-
lue) (MR 412, 01C, Vehicle bodywork specifica-
tions).
aThere are two options for adjusting the bonnet:
-using the bonnet bolts,
-using the bonnet hinge bolts. This operation requi-
res the removal of the front wheel arch liner (see
Front wheel arch liner: Removal - Refitting) (MR
412, 55A, Exterior protection).
aObserve the adjustment sequence.aSymbols A, B, C and D show the adjustment op-
tions.
The black dot in the centre represents the body of
the bolt.
The grey section represents the component to be
adjusted.
The white section represents the adjustment area.
121253
109496

48A-5
NON-SIDE OPENING ELEMENTS
Bonnet: Adjustment
48A
I - ADJUSTMENT BY MEANS OF THE BONNET
BOLTS
aLoosen the bolts (5) .
aAdjust the bonnet panel gaps.
aTighten the bolts (5) .
II - ADJUSTMENT BY MEANS OF THE BONNET
HINGE BOLTS
aRemove the front wheel arch liner (see Front wheel
arch liner: Removal - Refitting) (MR 412, 55A, Ex-
terior protection).
aLoosen the bolts (6) .
aAdjust the bonnet flush fitting.
aTighten the bolts (6) .
aRefit the front wheel arch liner (see Front wheel
arch liner: Removal - Refitting) (MR 412, 55A, Ex-
terior protection).
121818