technical specifications RENAULT TWINGO 2009 2.G Sequential Transmission Workshop Manual

2Transmission
V2 MR-413-X44-21B000$TOC.mif
V2
21B
"The repair procedures given by the manufacturer in this document are based on the
technical specifications current when it was prepared.
The procedures may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from
which his vehicles are constructed."
V2
All rights reserved by Renault s.a.s.
Edition Anglaise
Copying or translating, in part or in full, of this document or use of the service part
reference numbering system is forbidden without the prior written authority of
Renault s.a.s.
© Renault s.a.s. 2008
SEQUENTIAL GEARBOX
Vdiag No: 04
Fault finding - Introduction 21B - 2
Fault finding - Fault finding log 21B - 7
Fault finding - System operation 21B - 8
Fault finding - Replacement of components 21B - 13
Fault finding - Configurations and programming 21B - 21
Fault finding - Fault summary table 21B - 22
Fault finding - Interpretation of faults 21B - 24
Fault finding - Conformity check 21B - 78
Fault finding - Status summary table 21B - 79
Fault finding - Interpretation of statuses 21B - 80
Fault finding - Parameter summary table 21B - 105
Fault finding - Interpretation of parameters 21B - 106
Fault finding - Command summary table 21B - 120
Fault finding - Interpretation of commands 21B - 121
Diagnostic - Fault finding chart 21B - 126

21B-84
MR-413-X44-21B000$649.mif
V2
SEQUENTIAL GEARBOX
Fault finding - Interpretation of statuses
Vdiag No: 04
21B
ET027
DRIVER'S DOOR OPEN
STATUS
DEFINITIONStatus ET027 indicates the position of the opening elements by the specifications
"CLOSED " and "OPEN".
NOTESUse the Wiring Diagrams Technical Note for New TWINGO.
Engine stopped, ignition on
CLOSED: Driver's door closed
OPEN: Driver's door open
In the event of a fault, refer to the fault finding procedure below.
Electrical check of the sensor
Check the connection and condition of the connectors of components 140, 1016 and 119 as well as the driver's
door intermediate connector.
If the connectors are faulty and if there is a repair method (see Technical Note 6015A, Repairing electrical
wiring, W iring: Precautions for repair), repair the connectors; otherwise, replace the wiring.
Check the continuity and insulation of connection H24 between components 119, 1016 and 140.
If the connection is faulty and there is a repair procedure (see Technical Note 6015A, Electrical wiring repair,
wiring: precautions for repair), repair the wiring, otherwise replace it.
If the fault is still present, carry out fault finding on the UCH (see 87B, Passenger compartment connection
unit).
AFTER REPAIRCarry out another fault finding check on the system.
Deal with any other faults.
Clear the stored faults.
BVRJH1_V04_ET027