air condition RENAULT TWINGO 2009 2.G Trim And Upholstery Workshop Manual

79A-2
SEAT ACCESSORIES
Heated seat pad: Removal - Refitting
FRONT SEAT WITH HEATING
79A
REFITTING
I - REFITTING PREPARATION OPERATION
a
II - REFITTING OPERATION FOR PART
CONCERNED
aRemove the protective backing from the adhesive of
the heated pad.
aBond the heated pad.
aRefit:
-the front seat frame,
-the « foam - heated pad » assembly of the seat
base and seatback.
aConnect the connectors:
-of the heated pad,
-of the heated seat switch.
aConnect the battery (see Battery: Removal - Refit-
ting) (80A, Battery).
aCarry out a function test.
aDisconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
aDisconnect the following connectors :
-of the heated seat switch,
-of the heated pad.
aRemove:
-the « foam - heated pad » assembly of the seat
base and seatback,
-the front seat frame.III - FINAL OPERATION.
aRefit:
-the front seatback trim (see 77A, Front seat trim,
Front seatback trim: Removal - Refitting, page
77A-4) ,
-the front seat base trim (see 77A, Front seat trim,
Front seat base trim: Removal - Refitting, page
77A-1) ,
-the entire front seat (see 75A, Front seat frames
and mechanisms, Complete front seat: Remo-
val - Refitting, page 75A-8) .
aConnect the battery (see Battery: Removal - Refit-
ting) (80A, Battery).
aUnlock the airbag computer using the Diagnostic
tool (see Fault finding - Replacement of compo-
nents) (88C, Airbags and pretensioners). Note:
Check the condition of the seat base and seat-
back foam pads and replace them if necessary.