reset RENAULT TWINGO 2012 2.G Owners Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 2012, Model line: TWINGO, Model: RENAULT TWINGO 2012 2.GPages: 220, PDF Size: 6.73 MB
Page 42 of 220
1.36
ENG_UD29224_6
sécurité enfants : désactivation/activation airbag (X44 - Rena\
ult)
ENG_NU_952-4_X44_Renault_1
Jaune NoirNoir texte
Deactivating/activating the front passenger airbag
Deactivating the front
passenger airbags
(on equipped vehicles)
In order to fit a child seat to the front
passenger seat when this is allowed,
you must deactivate the front passen-
ger seat additional restraint devices
(side airbags (depending on vehicle),
front airbags, etc.). To deactivate the restraint devices
supplementary to the front passen
-
ger seat belt: switch off the ignition,
press and turn lock 1 to the OFF posi-
tion. The airbag is deactivated.
With the ignition on, it is essential to
check that warning light 2 is lit on the
instrument panel.
This warning light remains lit to con-
firm that you can fit a child seat, as
the passenger air bag has been de -
activated.
1
ChILD sAFETY : deactivating/activating the front passenger airbag (1/3)
2
The passenger air bag must
only be deactivated or acti-
vated with the ignition off.
If it is interfered with when
the vehicle is being driven, indicator
lights
å and © will come
on.
Switch the ignition off then on again
to reset the air bag in accordance
with the lock.
Page 44 of 220
1.38
ENG_UD29224_6
sécurité enfants : désactivation/activation airbag (X44 - Rena\
ult)
ENG_NU_952-4_X44_Renault_1
Activating the front
passenger air bags
You should reactivate the air bag as
soon as you remove the child seat from
the front passenger seat to ensure the
protection of the front passenger in the
event of an impact.
To reactivate the restraint devices
supplementary to the front passen -
ger seat belt: switch off the ignition,
press and turn lock 1 to the ON posi -
tion.
With the ignition on, check that the
warning light 2 goes out.
The front passenger seat belt additional
restraint systems are activated.
Operating faults
If the front passenger air bag activa -
tion/deactivation system is faulty, child
seats must NOT be fitted to the front
seat.
Allowing any other passenger to sit in
that seat is not recommended.
Contact your approved dealer as soon
as possible.
The passenger air bag must
only be deactivated or acti-
vated with the ignition off.
If it is interfered with when
the vehicle is being driven, indicator
lights
å and © will come
on.
Switch the ignition off then on again
to reset the air bag in accordance
with the lock.
2
ChILD sAFETY : deactivating/activating the front passenger airbag (3/3)
1
Page 55 of 220
trip computer and warning system........(up to the end of the DU)
instrument panel ................................... (up to the end of the DU)
display .................................................. (up to the end of the DU)
1.49
ENG_UD24927_5
Ordinateur de bord (X44 - Renault)
ENG_NU_952-4_X44_Renault_1
Trip computer
TRIp COMpUTER (1/5)
Display 1
General reset and trip
mileage recorder reset key 2
Press and hold button 2 to reset the trip
mileage recorder. The display must be
set to “Trip mileage recorder”.
Display selection key 1
Press button 2 multiple times to scroll
through the following information (de -
pending on the vehicle):
– total mileage recorder;
– trip mileage recorder;
– fuel consumed;
– average fuel consumption;
– current fuel consumption;
– estimated range;
– distance travelled;
– average speed;
– programmed speed (speed limiter/
cruise control);
– clock;
– temperature;
– mileage before service.
Refer to the tables on the following
pages for display examples.
Note: resetting is automatic when
the maximum capacity of any of the
memories is exceeded.
Instrument panel in miles
It is possible to switch to km/h.
Press button 2 and switch on the igni -
tion.
The speed measurement unit indica -
tor flashes for approximately three sec-
onds, then the new unit flashes on the
display and is then lit up continuously:
release button 2.
To return to miles, proceed in the same
manner.
Note: once the battery is disconnected,
the trip computer and warning system
automatically returns to the original unit
of measurement.1
2
Page 56 of 220
1.50
ENG_UD24927_5
Ordinateur de bord (X44 - Renault)
ENG_NU_952-4_X44_Renault_1
Jaune NoirNoir texte
TRIp COMpUTER (2/5)
The display of information shown below DEpENDs ON ThE VEhICLE EQUIpMENT AND COUNTRY.
Examples of display selections
by repeatedly pressing button 2Interpreting the display
Total mileage recorder.
Trip mileage recorder.
speed limiter or cruise control programmed speed.
Refer to the information on the “Speed limiter” and “Cruise con\
trol” in Section 2.
Fuel consumed since the last reset.
The value is displayed after having travelled at least 400 metres since the last
reset.
Current fuel consumption.
This value is displayed above a speed of approximately 18 mph (30 km/h)\
.
Page 57 of 220
JauneNoirNoir texte
1.51
ENG_UD24927_5
Ordinateur de bord (X44 - Renault)
ENG_NU_952-4_X44_Renault_1
Examples of display selections
by repeatedly pressing button 2Interpreting the display
Average fuel consumption since the last reset.
The value is displayed after having travelled at least 400 metres since the last
reset.
Estimated range with remaining fuel.
This range takes into account the average fuel consumption since the last time
the reset button was pressed. The value is displayed after driving 400 metres.
Distance travelled since last reset.
Average speed since the last reset.
The value is displayed after driving 400 metres.
The display of information shown below DEpENDs ON ThE VEhICLE EQUIpMENT AND COUNTRY.
TRIp
COMpUTER (3/5)
Page 59 of 220
mileage before service .......................................... (current page)
JauneNoirNoir texte
1.53
ENG_UD24927_5
Ordinateur de bord (X44 - Renault)
ENG_NU_952-4_X44_Renault_1
TRIp COMpUTER (5/5)
Examples of display selections
by repeatedly pressing button 2Interpreting the display selected
Mileage before service
Distance remaining until the next oil change.
There are several scenarios:
– distance less than 900 miles (1,500 km). It appears on the display for approxi -
mately 8 seconds when the ignition is switched on as soon as the distance is
less than or equal to 900 miles (1,500 km).
– distance less than 0 miles/km. The
© indicator light will light up on the
instrument panel.
The vehicle requires an oil change as soon as possible.
NB: depending on the vehicle, the mileage before an oil change varies according to the driving style (frequent driving at low
speed, door-to-door journeys, extensive use at idle speed, towing a trailer etc.). The distance remaining until the next oil change
can therefore decrease more quickly in some cases than the actual distan\
ce travelled.
The oil change intervals are independent of the vehicle’s maintenance schedule: please refer to your vehicle’s Maintenance
Document.
Resetting: to reset the mileage before an oil change, press and hold one of the display reset buttons for approximately 10 sec-
onds until the display shows the mileage permanently.
The display of information shown below DEpENDs ON ThE VEhICLE EQUIpMENT AND COUNTRY.
Page 62 of 220
clock ..................................................... (up to the end of the DU)
external temperature ............................ (up to the end of the DU)
clock ...................................................................... (current page)
indicators: exterior temperature indicator .......................... (current page)
1.56
ENG_UD11028_3
Heure / Température extérieure (X44 - Renault)
ENG_NU_952-4_X44_Renault_1
Jaune NoirNoir texte
Clock and exterior temperature
CLOCK AND EXTERIOR TEMpERATURE
Display A
With the ignition on, the time and,
depending on the vehicle, the exterior
temperature are displayed.
External temperature in -
dicator
As ice formation is related
to exposure, local air hu -
midity and temperature, the external
temperature alone is not sufficient to
detect ice.
If the electrical supply is cut (battery
disconnected, broken supply wire,
etc.), the clock will lose its time set-
ting.
The clock must be reset.
Resetting the clock
Vehicle with button 1:
– Press button 1 for approximately
three seconds;
– when the hour flashes, press
button 1 again to adjust it;
– wait approximately three seconds,
the minutes will flash, press button 1
to adjust them;
– wait approximately three seconds,
the minutes stop flashing, the time is
set.
1
A
For your safety, we recom -
mend that you do not adjust
the clock while driving.
Page 63 of 220
JauneNoirNoir texte
1.57
ENG_UD11028_3
Heure / Température extérieure (X44 - Renault)
ENG_NU_952-4_X44_Renault_1
Resetting the clock
With the ignition on, press button:
H for the hours;
M for the minutes.
Note : for vehicles which are not fitted
with buttons H and M, refer to the spe-
cific equipment instructions to discover
the special features.
TIME AND EXTERIOR TEMpERATURE (continued)
Display B(depending on vehicle)
With the ignition on, the time and,
depending on the vehicle, the exterior
temperature are displayed.
External temperature
indicator
special note:
When the external temperature is be -
tween –3°C and +3°C, the °C figures
flash (indicates risk of ice formation).
If the electrical supply is cut (battery
disconnected, broken supply wire,
etc.), the clock will lose its time set-
ting.
The clock must be reset.
External temperature in -
dicator
As ice formation is related
to exposure, local air hu -
midity and temperature, the external
temperature alone is not sufficient to
detect ice.
h
M
B
For your safety, we recom -
mend that you do not adjust
the clock while driving.