RENAULT TWINGO RS 2009 2.G Heating And Air Conditioning - Manual Air Conditioning Repair Manual

62C-61
MR-413-X44-62C000$910_eng.mif
V1
MANUAL AIR CONDITIONING
Fault finding - Fault finding charts62C
ALP 12 Water is present in the passenger compartment
NOTESNone.
Pressurise the cooling circuit.
Is there any coolant leaking into the vehicle?
NO
Check that the condensate drain pipe (water from
the evaporator) is not blocked.
Repair if necessary.
Is the fault still present?
YES
Make sure that the scuttle panel (under the windscreen aperture) is not filled with water.
If it is, check that the drain valve is fitted to the scuttle panel and is in good condition.
Replace the valve if necessary.
Has the customer just washed the vehicle?
YES
Explain to the customer that when washing the car
using a hose pipe, the water jet must not be left for
too long on the air inlet in the scuttle panel (on the
bonnet).
YES Repair.
NOEnd of fault finding procedure.
NO End of fault finding procedure.
AFTER REPAIRCarry out a complete check with the diagnostic tool.

62C-62
MR-413-X44-62C000$910_eng.mif
V1
MANUAL AIR CONDITIONING
Fault finding - Fault finding charts62C
ALP 13 No lighting on the control panel in night mode
NOTESCheck fuse F42-10A of component 1016.
Using a test light, check for + 12 V between connection LPD and connection NAM of component 319.
Does the test bulb illuminate?
YES NO
Check the condition of the air conditioning control
panel bulbs.Carry out a continuity test on connection LPD
between component 319 and F42-10A of component
1016.
Are the bulbs sound? Is the test correct?
YES NO YES NO
Replace the air
conditioning control
panel.Replace the air
conditioning control
panel bulb(s).Using the test light,
check for + 12 V
between connection
LPD of component 319
and the chassis earth.Fault on connection LPD
between F42-10A of
components 1016 and
319. Repair the wiring. If
there is a repair
procedure (see
Technical Note 6015A,
Repairing electrical
wiring, Wiring:
Precautions for repair),
repair the wiring,
otherwise replace it.
Is the test correct?
NO YES
Replace the air conditioning control panelFault on connection NAM. Repair the wiring. If there is
a repair procedure (see Technical Note 6015A,
Repairing electrical wiring, W iring: Precautions
for repair), repair the wiring, otherwise replace it.
AFTER REPAIRCarry out a complete check with the diagnostic tool.

62C-63
MR-413-X44-62C000$910_eng.mif
V1
MANUAL AIR CONDITIONING
Fault finding - Fault finding charts62C
ALP 14 Noisy compressor
NOTESConsult this customer complaint after a full check with the diagnostic tool (fault
reading and configuration checks).
WARNING
Check that the computers active in the AIR CONDITIONING function (Injection and
UCH) are correctly configured.
Note:
Before starting any work, check that the noise is indeed coming from the compressor.
Check that the compressor belt is in good condition and check its tension (for engines without automatic
tensioning) (see MR 411, Mechanical, 11A, Top and front of engine, Accessories belt: Removal - Refitting).
Check that the compressor is correctly fixed (see MR 411 Heating and air conditioning system, 62A, Air
conditioning, Compressor: Removal - Refitting).
Check the refrigerant fluid and look for any leaks. Significant loss of fluid causes the compressor to make noises.
(see Technical Note 6001A, Air conditioning, 62A, Air conditioning, Air conditioning: Check).
If the fault is still present, replace the air conditioning compressor (see MR 411, Mechanical, 62A, Air
conditioning, Compressor: Removal - Refitting).
AFTER REPAIRCarry out a complete check with the diagnostic tool.