wheel RENAULT TWIZY 2012 1.G Owners Manual

1.3
Electric vehicles have specific features.
We therefore recommend that you read
these instructions describing your elec-
tric vehicle carefully.Batteries
Your electric vehicle has two types of
battery:
– a traction battery;
– a 12 volt battery.
“58 volt” traction battery
This battery stores the energy nec-
essary to operate the motor in your
electric vehicle. As with any battery, it
discharges after use, and must be reg-
ularly recharged.
You do not have to wait until the traction
battery hits the reserve level in order to
recharge it.
Using a domestic socket, it takes ap-
proximately 3.5 hours to complete a full
charge.
Your vehicle range will depend on the
charge level of the traction battery, and
also on your driving style.
Please refer to information on “Vehicle
range: recommendations” in Section 2.12 volt battery
The second battery on your vehicle is
a 12V battery: this supplies the energy
required to operate vehicle equipment
(lights, washer/wipers, etc).
The 12V battery is charged:
– when the traction battery is charged;
– when the ignition is on; or
– when the ignition is off and peri-
odically, provided there is enough
power in the traction battery.
Please see the information under
“12 volt battery” in Section 4.
ELECTRIC VEHICLE: introduction (2/5)
Special feature
This vehicle has been approved
for the four-wheel category. It may
need to meet special regulations re-
garding the type of driving licence
required, the type of road used, etc.
Please ensure that you comply with
the legislation of your country.

1.5
ELECTRIC VEHICLE: introduction (4/5)
For safety reasons, adapt
your driving to driving condi-
tions and avoid any sudden
turning of the steering
wheel, especially on steep slopes or
slippery surfaces.
Failure to respect these recommen-
dations may lead to a loss of control
of the vehicle.
Risk of accident and serious injury.
Obstructions to the driver
On the driver’s side, only
use mats suitable for the
vehicle, attached with the
pre-fitted components, and check
the fitting regularly. Do not lay one
mat on top of another.
There is a risk of wedging the
pedals
Having a passenger effects
vehicle balance, road hold-
ing and increases the vehi-
cle braking distance.
Adapt your driving to the driving
conditions and avoid any sudden
manoeuvre which could lead to a
loss of control over the vehicle. Risk
of accident and serious injury.
Driving
When you lift your foot off the accelera-
tor pedal, the motor generates electri-
cal current during deceleration, and this
energy is used to recharge the traction
battery. Please refer to the information
on the “Charge meter” in Section 2.
An electric motor generates a greater
engine brake than in a petrol or diesel
engine vehicle.

1.6
Special cases
– At very high exterior temperatures, a safety mode is triggered. Warning
light
 comes on the instrument
panel. This mode reduces vehicle
power and can lead to its immobi-
lisation. We recommend that you
stop and allow the electrical system
to cool down, until the warning light
 goes off. The vehicle then re-
covers its performance.
– After a maximum charge for the trac- tion battery and during the first few
miles when driving the vehicle, or
during very low outside tempera-
tures, the engine brake is tempora-
rily reduced. Please adapt your dri-
ving style accordingly.
The engine brake should
under no circumstances be
used as a substitute for the
brake pedal.
Bad weather, flooded roads:
Do not drive through
floods if the depth of
water is above the
lower edge of the wheel
rims.
If a water level reaches
the vehicle floor, do not re-
charge the vehicle. Please
consult an authorised
dealer.
Risk of electric shock and a risk to
life.
ELECTRIC VEHICLE: introduction (5/5)

1.7
IMPORTANT RECOMMENDATIONS
Please read these instructions carefully. Failure to follow these instructions may lead to a risk of fire, burns or elec-
tric shock and serious injury.
In the event of an accident or impact to the vehicle
In the event of an accident or an impact to the underside of the vehicle\
(e.g.: striking a post, raised kerb or other street fu rni-
ture), this may damage the electrical circuit or the traction battery.
Have the vehicle checked by an authorised dealer.
Never touch components or orange cables which are exposed and visible in\
side or outside the vehicle.
In the event of serious damage to the traction battery, leaks may occur:
– never touch the liquids (fluids, etc.) coming from the traction batter\
y;
– in the event of contact with the body, wash the affected area with plenty of water and consult a doctor as soon as possibl\
e.
In the event of fire
In the event of fire, make everyone evacuate the vehicle immediately and\
contact the emergency services, informing them that
this is an electric vehicle.
Only use extinguishing agents ABC or BC that are permitted for use with electrical fires. Do not use w\
ater or other extinguish-
ing agents.
In the event of damage to the electrical circuit, please call an authori\
sed dealer.
All towing operations
Please refer to the information on “Towing, breakdowns” in Section 5.
Washing the vehicle
Never wash the vehicle while it is charging.
Never wash the vehicle or the traction battery with a high-pressure jet.\
Do not wash the vehicle in a roller car wash.
This risks damaging the electric circuit.
Lifting
Using a lifting tool (jack, etc.) directly under the traction battery \
to lift the vehicle is prohibited. To replace a wheel, please go
to an authorised dealer.

1.21
METHODS OF RESTRAINT IN ADDITION TO THE FRONT SEAT BELTS (2/3)
Side support belt
Please see the information on “Seat
belts” in Section 1.
Load limiter
Above a certain severity of impact, this
mechanism is used to limit the force of
the belt against the body so that it is at
an acceptable level.
Airbag
This is fitted in the front seats.
An Airbag marking on the steering
wheel informs you of the presence of
this equipment.
The airbag system consists of:
– an airbag and its gas generator fitted on the steering wheel;
– an electronic unit for system monitor- ing which controls the gas generator
electrical trigger system;
– a single warning light
å on the
instrument panel.
The air bag system uses
pyrotechnic principles. This
explains why, when the air
bag inflates, it will gener-
ate heat, produce smoke (this does
not mean that a fire is about to start)
and make a noise upon detonation.
In a situation where an air bag is
required, it will inflate immediately
and this may cause some minor, su-
perficial grazing to the skin or other
problems.

1.22
METHODS OF RESTRAINT IN ADDITION TO THE FRONT SEAT BELTS (3/3)
Operation
This system is only operational when
the ignition is switched on.
If a severe frontal impact occurs, the
airbag inflates rapidly, cushioning the
impact of the driver’s head and chest
against the steering wheel; the airbag
then deflates immediately after impact
so that the vehicle can be exited with-
out hindrance. All of the warnings below are given
so that the air bag is not obstructed
in any way when it is inflated and
also to prevent the risk of serious in-
juries caused by items which may be
dislodged when the air bag inflates.
Warnings concerning the
driver’s air bag
– Do not modify the steer-
ing wheel or the steering
wheel boss.
– Do not cover the steering wheel boss under any circumstances.
– Do not attach any objects (badge, logo, clock, telephone holder,
etc.) to the steering wheel boss.
– The steering wheel must not be removed (except by qualified per-
sonnel from our Network).
– Do not sit too close to the steering wheel when driving: sit with your
arms slightly bent (see Section 1
“Adjusting your driving position”).
This will allow sufficient space
for the air bag to deploy correctly
and to be fully effective.

1.38
AUDIBLE AND VISUAL SIGNALS
Horn
Press the end of stalk 1.
Headlight flasher
Pull stalk 1 towards you to flash the
headlights.
éHazard warning lights
Press switch 2 . This switch
lights up all four indicators simultane-
ously. It must only be used in an emer-
gency to warn drivers of other vehicles
that you have had to stop in an area
where stopping is prohibited or unex-
pected or that you are obliged to drive
under special conditions.
Direction indicators
Move stalk 1 parallel to the steering
wheel and in the direction you are going
to turn it.
When driving on the motorway, the
steering wheel is not often turned
enough to return the stalk automatically
to 0.
There is also an intermediate position
in which the switch may be held when
changing lanes.
When the stalk is released, it automati-
cally returns to 0.
21
0

2.2
“Accessories” position ANo power-consuming device will oper-
ate when the ignition is switched off.
“On” position MThe ignition is switched on:
Start position D
Starting the engine
Turn the key to the D position and hold
it in this position until you hear a beep.
Release the key.
As soon as warning light
 stops
flashing, your vehicle is ready to drive.“Stop, steering and
handbrake lock” position St
To unlock: turn the key and the steering
wheel slightly.
To lock: remove the key and turn the
steering wheel until the steering column
locks.
To release the handbrake, please see
the information on “Handbrake” in
Section 2.
STARTING, STOPPING THE ENGINE
Driver’s responsibility
Never leave your vehi-
cle with the key inside and
never leave a child (or a
pet) unsupervised, even for a short
while.
There is a risk that this could start
the engine or operate electrical
equipment.
Risk of serious injury.
Never switch off the ignition before
the vehicle has come to a complete
stop. Once the engine has stopped,
the passive safety devices such as
airbag will no longer operate.
The vehicle can only be started if
the charging cord is unplugged from
the vehicle and stored away.
Stopping the engine
Bring the key to “Stop” position.
Warning light
 goes out.

4.6
BODYWORK MAINTENANCE (1/2)
– Scrape off mud or dirt without prewetting.
– Allow dirt to accumulate.
– Allow rust to form following minor im- pacts.
– Use solvents not approved by our Technical Department to remove
stains as this could damage the
paintwork.
– Drive frequently in snow or muddy conditions without washing the ve-
hicle, particularly under the wheel
arches and body.
– minor impacts
You should take a minimum number of
precautions in order to safeguard your
vehicle against such risks and not to
lose the benefit of your vehicle’s anti-
corrosion protection.
What you should not do
– Degrease or clean mechanical com-
ponents, underneath the body, parts
with hinges (e.g. inside the fuel tank
flap) and painted plastic external fit-
tings using high-pressure cleaning
equipment or by spraying on prod-
ucts not approved by our Technical
Department. If adequate precautions
are not taken, this could give rise to
corrosion, damage to paintwork or
operating faults.
– Wash the vehicle in bright sunlight or freezing temperatures.
A well-maintained vehicle will last
longer. It is therefore recommended to
maintain the exterior of the vehicle reg-
ularly.
Some parts may look different over time
(e.g.: bleaching, etc.)
Protection against the effects
of corrosive agents
Although your vehicle has been treated
with very effective anti-corrosion prod-
ucts, it nevertheless remains subject to
the effects of:
– corrosives in the atmosphere
– atmospheric pollution (built-up
and industrial areas),
– saline atmospheres (near the
sea, particularly in hot weather),
– seasonal and damp weather con-
ditions, (e.g. road salt in winter,
water from road cleaners, etc.).
– abrasives Wind-borne dust and sand, mud,
road grit thrown up by other vehi-
cles, etc.
Washing the vehicle
Never wash the vehicle with
a roller or a high-pressure
spray, and under no circum-
stances when charging.
This risks damaging the electrical
circuit.

4.7
BODYWORK MAINTENANCE (2/2)
We have selected special products
to care for your vehicle and you can
obtain these from the manufactur-
er’s accessory outlets.
You should
– Observe the vehicle stopping dis-tances when driving on gravelled
surfaces to prevent paint damage.
– Quickly repair, or have repaired, areas where the paint has been
damaged, to prevent corrosion
spreading.
– Remember to visit the body shop periodically if your vehicle has an
anti-corrosion warranty. Refer to the
Maintenance Document.
– Respect local regulations about washing vehicles (e.g. do not wash
your vehicle on a public highway).
– Spray mechanical components, hinges, etc. with products approved
by our Technical Department to
protect them after they have been
cleaned. – Wash your car frequently, with the
engine off , with cleaning products
recommended by the manufacturer
(never use abrasive products). Rinse
thoroughly beforehand with a jet:
– spots of tree resin and industrial
grime;
– bird droppings , which cause a
chemical reaction with the paint
that rapidly discolours paint-
work and may even cause the
paint to peel off;
wash the vehicle immediately to
remove these marks since it is im-
possible to remove them by pol-
ishing;
– salt, particularly in the wheel
arches and underneath the body
after driving in areas where the
roads have been gritted;
– mud in the wheel arches and un-
derneath the body which forms
damp patches.
Cleaning the roof
Use a soft cloth or cotton wool.
Soak it lightly with a protective agent
recommended by our Technical
Department.
Spread the protective agent carefully
in circular movements using a soft or a
cotton cloth.