glove box RENAULT WIND 2012 1.G Owners Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 2012, Model line: WIND, Model: RENAULT WIND 2012 1.GPages: 185, PDF Size: 5.52 MB
Page 88 of 185
3.4
ENG_UD20476_2
Toit rigide escamotable : anomalie de fonctionnement (E33 - X33 - Renaul\
t)
ENG_NU_865-6_E33_Renault_3
Jaune NoirNoir texte
Rotating HaRD RooF: operating fault (1/2)
the roof unlocks but does
not open
Check that the luggage compartment
lid is properly closed. Restart the oper-
ation: lock then unlock the roof without
pushing it upwards.
Repair procedure
If there is a system fault, you can close
the rotating hard roof.
To do this, open the roof cover manu -
ally.
Unclip logo 1 on the luggage compart-
ment lid.
12
Remove plastic cover 2 to access the
screw.Use the emergency key supplied in the
glove box to turn the screw clockwise
until the roof cover opens sufficiently
(point of resistance).
To avoid all risk of injury,
ensure that nobody is in
the proximity of the moving
parts.
When opening/closing the roof,
ensure that nothing interferes with
the moving parts (roof and roof
cover).
Ensure that there are no objects in
roof/roof cover area A.
a
Page 145 of 185
fuses ..................................................... (up to the end of the DU)
5.19
ENG_UD24358_4
Fusibles (E33 - X33 - Renault)
ENG_NU_865-6_E33_Renault_5
clip 3
Remove the fuse using tweezers 3, lo-
cated on the back of cover 1 or in glove
box 2.
To remove the fuse from the tweezers,
slide the fuse to the side.
Fuses
Check the fuse in question
and replace it, if neces-
sary, by a fuse of the same
rating.
If a fuse is fitted where the rating is
too high, it may cause the electrical
circuit to overheat (risk of fire) in the
event of an item of equipment using
an excessive amount of current.
Fuses (1/3)
3
To comply with local legislation, or
as a precaution, you can obtain an
emergency kit containing a set of
spare bulbs and fuses from an ap -
proved dealer.
Fuse box
If electrical equipment does not work,
check the condition of the fuses.
Depending on the vehicle, remove
flap 1 or the flap located in storage
compartment 2.
To identify the fuses, refer to the fuse
allocation label (shown on the following
pages).
It is not advisable to use the free fuse
locations.
1
2