ignition SAAB 9-2X 2005 Owners Manual

11 - 4Maintenance and service
26 December 2003
improperly used or handled, for example, bat-
tery acid.
!Your vehicle should only be serviced by per-
sons fully competent to do so. Serious person-
al injury may result to persons not experienced
in servicing vehicles.
!Always use the proper tools and make certain
that they are well maintained.
!Never get under the vehicle supported only
by a jack. Always use a safety stands to sup-
port the vehicle.
!Never keep the engine running in a poorly
ventilated area, such as a garage or other
closed areas.
!Do not smoke or allow open flames around
the fuel or battery. This will cause a fire.
!Because the fuel system is under pressure,
replacement of the fuel filter should be per-
formed only by your Saab dealer.
!Wear adequate eye protection to guard
against getting oil or fluids in your eyes. If
something does get in your eyes, thoroughly
wash them out with clean water.
!Do not tamper with the wiring of the SRS air-
bag system or seatbelt pretensioner system, or
attempt to take its connectors apart, as that
may activate the system or it can render it inop-erative. The wiring and connectors of these
systems are yellow for easy identification. NEV-
ER use a circuit tester for these wiring.
If your SRS airbag or seatbelt pretensioner
needs service, consult your nearest Saab deal-
er."Before checking or servicing in the en-
gine compartment!Always stop the engine and set the parking
brake firmly to prevent the vehicle from mov-
ing.
!Always let the engine cool down. Engine
parts become very hot when the engine is run-
ning and remain hot for some time after the en-
gine is stopped.
!Do not spill engine oil, engine coolant, brake
fluid or any other fluid on hot engine compo-
nents. This may cause a fire.
!Always remove the key from the ignition
switch. When the ignition switch is in the “ON”
position, the cooling fan may operate suddenlyeven when the engine is stopped.
ProCarManuals.com

11 - 6 4Maintenance and service
26 December 2003
A) Good
B) BlownIf any lights, accessories or other electrical controls do
not operate, inspect the corresponding fuse. If a fuse
has blown, replace it.
1. Turn the ignition switch to the “LOCK” position and
turn off all electrical accessories.
2. Remove the cover.
3. Determine which fuse may be blown. The back side
of each fuse box cover and the “Fuses and circuits”
section in chapter 12 in this manual show the circuit for
each fuse.
1) Fuse puller4. Pull out the fuse with the fuse puller.
5. Inspect the fuse. If it has blown, replace it with a
spare fuse of the same rating.
6. If the same fuse blows again, this indicates that its
system has a problem. Contact your Saab dealer for
repairs.
AB
HSB067BB
1
HSB068BB
ProCarManuals.com