clock SATURN ION 2007 Owner's Manual
[x] Cancel search | Manufacturer: SATURN, Model Year: 2007, Model line: ION, Model: SATURN ION 2007Pages: 440, PDF Size: 2.93 MB
Page 303 of 440

Notice:In cold weather, water can freeze and
crack the engine, radiator, heater core and
other parts. Use the recommended coolant and
the proper coolant mixture.
{CAUTION:
You can be burned if you spill coolant on
hot engine parts. Coolant contains
ethylene glycol and it will burn if the
engine parts are hot enough. Do not spill
coolant on a hot engine.
1. You can remove the coolant surge tank
pressure cap when the cooling system,
including the upper radiator hose, is no longer
hot. Turn the pressure cap slowly
counterclockwise about one-quarter of a turn.
If you hear a hiss, wait for that to stop.
This will allow any pressure still left to be
vented out the discharge hose.
2. Then keep turning the pressure cap slowly,
and remove it.
303
ProCarManuals.com
Page 306 of 440

{CAUTION:
You can be burned if you spill coolant on
hot engine parts. Coolant contains
ethylene glycol and it will burn if the
engine parts are hot enough. Do not spill
coolant on a hot engine.
1. You can remove the Intercooler System
pressure cap when the Intercooler System,
including the upper intercooler hoses, are nolonger hot. Turn the pressure cap slowly
counterclockwise about one-quarter of a turn. If
you hear a hiss, wait for that to stop. This will
allow any pressure still left to be vented.
2. Then keep turning the pressure cap slowly,
and remove it.
3. Add the proper DEX-COOL
®coolant mixture
to the ll neck, until there is coolant visible in
the horizontal tube section of the ll neck.
4. With the Intercooler System pressure cap off,
start the engine and let it run for a couple of
minutes. Watch out for the engine cooling fan.
Turn the engine off.
By this time, the coolant level inside the ll
neck may be lower. If the level drops to where
coolant is no longer visible in the horizontal
tube section of the ll neck, with the engine off
add more of the DEX-COOL
®coolant
mixture to the ll neck until the level is again
visible in the horizontal tube section.
5. Then replace the pressure cap. Be sure the
pressure cap is hand-tight and fully seated.
If the coolant is not at the proper level when the
system cools down again, see your retailer.
306
ProCarManuals.com
Page 319 of 440

Headlamps (Coupe)
To change a headlamp bulb on a coupe model, do
the following:
1. Open the hood. SeeHood Release on
page 279for more information.
2. Pull up on the headlamp retaining pins (A) to
remove them from the headlamp assembly.
3. Pull the headlamp assembly (B) away from the
vehicle and remove the electrical connector.4. Raise the lock tab and pull the connector from
the base of the bulb to remove the electrical
connector from the headlamp bulb.
5. Remove the retaining nut (D) by turning it
counterclockwise.
6. Remove the bulb (C) and replace it with the
appropriate bulb.
7. Reverse the steps to reinstall the headlamp
assembly.
319
ProCarManuals.com
Page 320 of 440

Headlamps (Sedan)
To change a headlamp bulb on a sedan model, do
the following:
1. Open the hood. SeeHood Release on
page 279for more information.
2. Pull up on the headlamp retaining pins (A) to
remove them from the headlamp assembly.
3. Pull the headlamp assembly (B) away from the
vehicle and remove the electrical connector.4. Access the bulb by turning the dust cap
counterclockwise to remove it.
320
ProCarManuals.com
Page 321 of 440

5. Raise the lock tab and pull the connector (C)
from the base of the bulb to remove the
electrical connector.
6. Remove the bulb retaining nut (E) by turning it
counterclockwise.
7. Remove the bulb (D) and replace it with the
appropriate bulb.
8. Reverse the steps to reinstall the lamp
assembly.
321
ProCarManuals.com
Page 322 of 440

Front Turn Signal, Parking and
Daytime Running Lamps (DRL)
(Coupe)
To change this bulb on a coupe model, do the
following:
1. Open the hood. SeeHood Release on
page 279for more information.
2. Reach behind the headlamp from inside
the hood.
3. Turn the bulb socket counterclockwise to
remove it from the housing.
4. Pull the bulb (A) from the socket (B) and
replace it with the appropriate bulb.
5. Reinstall the bulb socket (B) by turning it
clockwise.
322
ProCarManuals.com
Page 323 of 440

Front Turn Signal, Parking and
Daytime Running Lamps (DRL)
(Sedan)
To change this bulb on a sedan model, do the
following:
1. Follow Steps 1 through 4 to remove the
headlamp assembly. See the headlamp
removal for sedan underHeadlamps (Coupe)
on page 319orHeadlamps (Sedan) on
page 320. This bulb is located next to the
high/low-beam headlamp.
2. Remove the bulb socket (B) by turning it
counterclockwise.
3. Remove the bulb (A) and replace it with the
appropriate bulb.
4. Reverse the steps to reinstall the lamp
assembly.
323
ProCarManuals.com
Page 324 of 440

Center High-Mounted
Stoplamp (CHMSL)
To change a CHMSL bulb, do the following:
1. Remove the CHMSL cover by pulling down on
the cover edges from inside the vehicle.
2. Turn the bulb socket counterclockwise to
remove it.3. Replace with the appropriate bulb.
4. Reinstall the bulb socket by turning it
clockwise.
5. Replace the cover.
Taillamps, Turn Signal, Stoplamps
and Back-up Lamps
To change one of these bulbs, do the following:
1. Open the trunk. SeeTrunk on page 98
for more information.
2. Remove the three retaining screws from the
taillamp assembly.
324
ProCarManuals.com
Page 325 of 440

3. Slide the taillamp assembly back and remove
it from the quarter panel.4. Remove the bulb socket (B) by turning it
counterclockwise.
5. Pull the bulb (A) from the socket and replace
it with the appropriate bulb.
6. Reverse the steps to reinstall the taillamp
assembly.
325
ProCarManuals.com
Page 326 of 440

License Plate Lamp
To replace the license plate lamp bulb, do the
following:
1. Remove the two screws holding the license
plate lamp assembly to the fascia.
2. Turn and pull the license plate lamp forward
through the fascia opening.3. Turn the bulb socket counterclockwise and
pull the bulb straight out of the socket.
4. Install the new bulb.
5. Reverse Steps 1 through 3 to reinstall the
lamp assembly.
Replacement Bulbs
Exterior Lamp Bulb Number
Back-up Lamps 921
CHMSL PC-175
Front Turn Signal/Parking
Lamp/DRL5702KA 1
Headlamps 9007
Stoplamp and
Taillamps (Top)3057K
1 Phillips Only
For replacement bulbs not listed here, contact
your dealer/retailer.
326
ProCarManuals.com