trunk SATURN L-SERIES 2004 User Guide

The GVWR includes the weight of the vehicle, all
occupants, fuel and cargo. Never exceed the GVWR for
your vehicle or the Gross Axle Weight Rating (GAWR)
for either the front or rear axle.
If you do have a heavy load, spread it out. Don’t carry
more than 167 pounds (75 kg) in your trunk.
{CAUTION:
Do not load your vehicle any heavier than the
GVWR, or either the maximum front or rear
GAWR. If you do, parts on your vehicle can
break, and it can change the way your vehicle
handles. These could cause you to lose
control and crash. Also, overloading can
shorten the life of your vehicle.
Notice:Overloading your vehicle may cause
damage. Repairs would not be covered by your
warranty. Do not overload your vehicle.
If you put things inside your vehicle — like suitcases,
tools, packages or anything else — they will go as fast
as the vehicle goes. If you have to stop or turn
quickly, or if there is a crash, they’ll keep going.
{CAUTION:
Things you put inside your vehicle can strike
and injure people in a sudden stop or turn, or
in a crash.
Put things in the trunk of your vehicle. In a
trunk, put them as far forward as you can.
Try to spread the weight evenly.
Never stack heavier things, like suitcases,
inside the vehicle so that some of them
are above the tops of the seats.
Do not leave an unsecured child restraint
in your vehicle.
When you carry something inside the
vehicle, secure it whenever you can.
Do not leave a seat folded down unless
you need to.
4-39
ProCarManuals.com

CAUTION: (Continued)
This spray can happen if your tank is nearly full,
and is more likely in hot weather. Open the fuel
cap slowly and wait for any “hiss” noise to stop.
Then unscrew the cap all the way.
Be careful not to spill fuel. Clean fuel from painted
surfaces as soon as possible. SeeCleaning the Outside
of Your Vehicle on page 5-85.
When you put the fuel cap back on, turn it to the right
(clockwise) about 1/4 of a turn until you hear three
clicks. Make sure you fully install the cap. The diagnostic
system can determine if the fuel cap has been left off
or improperly installed. This would allow fuel to
evaporate into the atmosphere and may cause the
malfunction indicator lamp to come on. SeeMalfunction
Indicator Lamp on page 3-34.
Notice:If you need a new fuel cap, be sure to get the
right type. Your dealer can get one for you. If you get
the wrong type, it may not t properly. This may
cause your malfunction indicator lamp to light and
may damage your fuel tank and emissions system.
SeeMalfunction Indicator Lamp on page 3-34.
Filling a Portable Fuel Container
{CAUTION:
Never ll a portable fuel container while it is in
your vehicle. Static electricity discharge from
the container can ignite the gasoline vapor.
You can be badly burned and your vehicle
damaged if this occurs. To help avoid injury to
you and others:
Dispense gasoline only into approved
containers.
Do not ll a container while it is inside a
vehicle, in a vehicle’s trunk, pickup bed or
on any surface other than the ground.
Bring the ll nozzle in contact with the
inside of the ll opening before operating
the nozzle. Contact should be maintained
until the lling is complete.
Do not smoke while pumping gasoline.
5-9
ProCarManuals.com

Center High-Mounted Stoplamp
(CHMSL) (Wagon)
1. Open the liftgate.
2. Remove the center high mounted stop lamp cover
by pulling down on the cover edges.
3. Turn the bulb socket being replaced
counterclockwise one–quarter of a turn and remove
the bulb.
4. Replace it with the appropriate bulb.
Taillamps, Turn Signal, Stoplamps
and Back-up Lamps (Sedan)
1. Open the trunk.
2. Pull back with interior trim.
5-50
ProCarManuals.com

The following steps will tell you how to use the jack and
change a tire.
Removing the Spare Tire and Tools
(Sedan)
The equipment you’ll need is located in the trunk.
1. Open the jack access door on the left side panel of
the trunk.
2. Remove the nut that holds the jack in place and
remove the jack together with the wheel wrench.
5-71
ProCarManuals.com

3. Lift the trunk liner and place the plastic hook in the
lip of the trunk.
4. Remove the nut that holds down the spare tire.
5. Remove the compact spare tire. SeeCompact
Spare Tire on page 5-81
6. The wheel wrench is held in place by two clips
which are attached to the jack. Remove the
wheel wrench from the jack.
7. Fold out the socket portion of the wrench from the
handle.Removing the Spare Tire and Tools
(Wagon)
The equipment you’ll need is in the cargo area.
5-72
ProCarManuals.com

Removing the Wheel
You must take off the wheel cover or hubcap to reach
the wheel bolts.
For steel wheels with full plastic covers and aluminum
wheels with large circular center caps, do the following:
1. Loosen all ve hex-shaped plastic caps by turning
the wrench counterclockwise. Do not try to remove
plastic caps from the cover or center cap.
2. Pull the cover or center cap away from the wheel
and place it in the trunk.
When reinstalling full plastic covers or center caps,
tighten all ve plastic caps hand snug with the aid of the
wheel wrench and tighten them with the wheel wrench
an additional one–quarter of a turn.
Removing the Flat Tire and Installing
the Spare Tire
1. Use the wheel wrench to loosen all the wheel nuts.
Don’t remove them yet.
2. The jack has a bolt head at the end. Attach the
wheel wrench to the jack bolt head and rotate
the wheel wrench clockwise (to the right). That will
raise the lift head a little.
3. Move the jack over to where the at tire is.
5-74
ProCarManuals.com

13. Tighten the wheel nuts
rmly in a crisscross
sequence, as shown.
{CAUTION:
Incorrect wheel bolts or improperly tightened
wheel bolts can cause the wheel to come loose
and even come off. This could lead to an
accident. Be sure to use the correct wheel
bolts. If you have to replace them, be sure to
get new Saturn original equipment wheel bolts.
Stop somewhere as soon as you can and have
the bolts tightened with a torque wrench to the
proper torque specication. SeeCapacities
and Specifications on page 5-98for the wheel
bolt torque specication.Notice:Improperly tightened wheel bolts can lead
to brake pulsation and rotor damage. To avoid
expensive brake repairs, evenly tighten the wheel
bolts in the proper sequence and to the proper
torque specication. SeeCapacities and
Specifications on page 5-98for the wheel bolt
torque specication.
14. Lower the jack all the way and remove the jack
from under the vehicle.
15. Tighten the bolts rmly with the wheel wrench.
Do not try to put a wheel cover on your compact spare
tire. It will not t. Store the wheel cover in the trunk
until you have the at tire repaired or replaced.
Notice:Wheel covers will not t on your compact
spare. If you try to put a wheel cover on the compact
spare, you could damage the cover or the spare.
5-78
ProCarManuals.com

1. Place the wheel wrench into the clips on the jack.
2. Install the jack in the left side panel of the trunk
for sedans or the spare tire compartment for
wagons and secure as shown on the jacking
instruction label located in the trunk or cargo area.3. Place the at tire, face down, into the spare tire
compartment. When placing an aluminum at tire
into the spare tire compartment, be very careful
to avoid scraping the wheel face on the hold-down
bolt and other hard surfaces. The hold-down
bolt should pass through the rear most wheel vent
hold. The at tirel will protrude above the trunk
oor in this position.
4. Place the nut onto the hold-down bolt and tighten
down until it is snug.
The compact spare is for temporary use only. Replace
the compact spare tire with a full-size tire as soon
as you can. See the storage instructions label to replace
your compact spare into your trunk or cargo area
separately.
Store the at tire in the compact spare tire compartment
and secure the adapter, extension (aluminum wheel
only) and wing bolt. Store the jack and wheel wrench in
the foam tray. Wagon
5-80
ProCarManuals.com

Fuses Usage
RADIOAudio, OnStar
®, Rear Seat DVD
(Option)
WIPERWindshield Washers and Wipers
(Front)
IGN 3Left Heated Seat Switch, Right
Heated Seat Switch, Air
Conditioning, Rear Defogger Relay
DEFOG LED Rear Defog LED
BTSI/BCM/
MIRRORBrake Transaxle Shift Interlock,
Body Control Module, Power Mirror
DIMMER Dimmer Switch
RR COMP LP Trunk Compartment Lamp
Relays Usage
RR DEFOG Rear Defogger
IGN 3 Ignition Switch
PARKLAMP Park Lamps
HEADLAMP Headlamps
5-93
ProCarManuals.com

Recommended Fluids and
Lubricants
Fluids and lubricants identied below by name, part
number or specication may be obtained from your
dealer.
Usage Fluid/Lubricant
Engine OilEngine oil which meets GM Standard
GM6094M and displays the
American Petroleum Institute
Certied for Gasoline Engines
starburst symbol. To determine the
proper viscosity for your vehicle’s
engine, seeEngine Oil on page 5-16.
Engine Coolant50/50 mixture of clean, drinkable
water and use only
DEX-COOL
®Coolant. SeeEngine
Coolant on page 5-23.
Hydraulic Brake
SystemDelco Supreme 11 Brake Fluid or
equivalent DOT-3 brake uid.
Windshield
Washer SolventOptikleen
®Washer Solvent.
Parking Brake
Cable GuidesChassis Lubricant (GM Part No.
12377985, in Canada 88901242) or
lubricant meeting requirements of
NLGI #2, Category LB or GC-LB.
Usage Fluid/Lubricant
Power Steering
SystemPower Steering Fluid (Saturn Part
No. 21007583 or GM Part No. U.S.
89021184, in Canada 89021186).
Automatic
TransaxleDEXRON
®-III Automatic
Transmission Fluid.
Key Lock
CylindersMulti-Purpose Lubricant, Superlube
(GM Part No. U.S. 12346241, in
Canada 10953474).
Hood Latch
Assembly,
Secondary
Latch, Pivots,
Spring Anchor
and Release
PawlLubriplate Lubricant Aerosol (Saturn
Part No. 21038869 or GM Part No.
U.S. 12346293, in Canada 992723)
or lubricant meeting requirements of
NLGI #2, Category LB or GC-LB.
Hood, Trunk
and Door
HingesMulti-Purpose Lubricant, Superlube
(GM Part No. U.S. 12346241, in
Canada 10953474).
Sunroof TrackLubriplate Lubricant Aerosol (Saturn
Part No. 21038869 or GM Part No.
U.S. 12346293, in Canada 992723)
or lubricant meeting requirements of
NLGI #2, Category LB or GC-LB.
Weatherstrip
ConditioningDielectric Silicone Grease (GM Part
No. U.S. 12345579, in Canada
992887).
6-12
ProCarManuals.com