Seat Alhambra 2019 Owner's Manual

Fuses and bulbs
Replacing the rear bulbs in the
body Fig. 115
On the side of the boot: removing the
l eft and right hand side r ear lights. 1 remove
the cap; 2 attachment screw Fig. 116
Tail light on the bodywork: detach the
bulb hol der. 1 a
4 : lock latches.
Complete operations only in the sequence
giv
en.
R emo
ving the rear light units
Complete operations only in the sequence
given: Rear light, left Rear light, right
1. Open the rear lid

Emergencies
Rear light, left Rear light, right
13. Carefully insert the tail light unit into the open-
ing in the bodywork . T
o do this, insert the up-
per rear light unit guide into the attachment ring.
14. Tighten the white attachment screw using the
screw

driver from the vehicle tool kit.
15. Ensure that the tail light unit has been correct-
ly fitted and is firmly secur ed.
16. R

eplace the cap

Fuses and bulbs

Fixed number
plat e light Bolt
ed number
plate light
7. Plug the connect
or in-
to the bulb hol der

.Press on the attach-
ment tabs. The bulb
hol
der must be firmly
att

ached to the num-
ber plate light.
8. Insert the number plate light carefully into the
opening on the bumper. Ensur e that the number
pl

ate light is in the correct position.
9. Insert the number
plat
e light int

o the
bumper until it audibly
clicks into place. Tighten the attach-
ment screws f
or the
number plate light us-
ing the screwdriver. 101

Operation
Fig. 119
Dash panel.102

General instrument panel
Operation
Gener al instrument panel
Instrument panel Door release lever . . . . . . . . . . . . . . . . . . .
123
Central locking and opening but-
ton 
/  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 116
Switch for adjusting the exterior mir-
rors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 143

Operation
Passenger front airbag off warning
l amp
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . .75
Lever for:

General instrument panel
Clock set button 1)
.

Operation
Warning and information texts
The syst em runs a check on cert
ain compo-
nents and functions when the ignition is
s
witched on and while the vehicle is moving.
Faults in the operation are displayed on the
screen using red and yellow symbols and
messages on the instrument panel display
(

General instrument panel
This option cannot be deactivated in models
destined f or countries in which the second
speed must al w
ays be visible.
Start-Stop operating display.
Updated information relating to the status is
displayed on the instrument panel

Operation
SEAT distinguishes between services with en-
gine oil change (Int erv
al Service) and serv-
ices
without engine oil change (Inspection
Service). The service interval display only
gives information for service dates which in-
volve an engine oil change. The dates for the
other services (e.g. the next Inspection Serv-
ice or change of brake fluid) are listed on the
label attached to the door strut, or in the
Maintenance Programme.
In vehicles with Services established by
time or mileage, the service intervals are al-
ready pre-defined.
In vehicles with LongLife Service, the inter-
vals are determined individually. Technical
progress has made it possible to considera-
bly reduce servicing requirements. The tech-
nology used by SEAT ensures that your vehi-
cle only has an Interval Service when it is
necessary. To determine the Maintenance
Service (max. 2 years), the vehicle