clock reset Seat Altea 2011 Owner's Manual
[x] Cancel search | Manufacturer: SEAT, Model Year: 2011, Model line: Altea, Model: Seat Altea 2011Pages: 317, PDF Size: 8.87 MB
Page 64 of 317

Cockpit
62Recommended gear display* 
This display helps to save fuel.Use the gear display to save fuel. If you are driving in the correct gear, a dot 
will be shown next to the gear display. If you are not in the correct gear, an 
arrow will appear next to the gear display indicating whether you should 
change up or down.Odometer or flexible service interval displayOdometer
The left-hand counter in the display registers the total amount of distance 
covered by the vehicle.
The right-hand counter registers the short journeys. The last digit indicates 
steps of 100 metres. The trip recorder counter may be reset by holding down 
the reset button for a few seconds. Service interval display
Ve hi cle s wi th Service intervals dependent on time/distance travelled
 already 
have certain service intervals set. The intervals are calculated individually in 
vehicles with  LongLife service .
The service interval display only indicates the dates of services that include 
engine oil change. The dates of all other services, such as Inspection Service 
or brake fluid change, appear in the sticker on the door pillar or in the Main-
tenance Programme.
A  Service pre-warning  will appear in the odometer if a service is due soon. A 
“spanner” symbol appears and the display “km” with the distance that can 
be driven until the next service appointment is due. The display will change 
after approximately 10 seconds. A “clock symbol” appears and the number 
of days until the service appointment should be carried out. The following 
message is shown in the instrument panel display*:
Service in
[XXXX]
km
or
[XXXX]
days
The service message will disappear approximately 20 seconds after the igni-
tion is switched on or the engine is running. The normal display can be 
resumed by briefly pressing the reset button on the trip counter or by pressing 
the   button on the steering wheel controls.
With the ignition on, you can  check the current service message at any 
moment in the  Vehicle status menu or turning the reset button to access the 
service display.
An  overdue service  is indicated by a minus sign in front of the mileage or day 
information.
Fig. 40  Gear display
OK
Altea_EN.book  Seite 62  Donnersta g, 2. September 2010  2:00 14