dashboard warning lights Seat Altea Freetrack 2010 Owner's Manual
[x] Cancel search | Manufacturer: SEAT, Model Year: 2010, Model line: Altea Freetrack, Model: Seat Altea Freetrack 2010Pages: 294, PDF Size: 7.71 MB
Page 34 of 294

Airbag system
32Monitoring of airbag and belt tension device system
Both the airbag and belt tension device systems operation is constantly 
monitored electronically. Each time the ignition is switched on, the warning 
lamp 
 lights for several seconds and the display in the instrument panel* 
shows  AIRBAG / TENSIONER.
The system must be checked when the warning lamp 
 :
•does not light up when the ignition is switched on,•after the ignition is switched on, it turns off after 4 seconds,•it turns off and then lights up again after the ignition is switched on,•lights up or flashes while the car is moving.
In the event of a malfunction, the warning lamp remains on continuously. In 
addition, depending on the malfunction, a fault message appears in the 
display of the combi-instrument for approx. 10 seconds and a short acoustic 
signal is g ive n.  In  th is  ev en t, you  sh ould hav e a  q ual if ie d  wo r ksh op  che ck  the  
system immediately.
If any of the airbags are de-activated by the Authorised Service Centre, the 
indicator lights for several seconds more after the verification and will turn off 
if there is no fault.WARNING
•If there is a malfunction, the airbag and belt tension device system 
cannot properly perform its protective function.•If a malfunction occurred, have the system checked immediately by a 
qualified workshop. Otherwise, in th e event of an accident, the airbag 
system and belt tension devices may not be triggered, or may not be trig-
gered correctly.
Repairs, maintenance and disposal of the airbagsThe parts of the airbag system are installed in various places in your vehicle. 
If you work on the airbag system or remove and fit parts of the system when 
performing other repair work, parts of the airbag system may be damaged. 
The consequence may be that, in the event of an accident, the airbag inflates 
incorrectly or does not inflate at all.
The relevant safety requirements must be observed when the vehicle or 
components of the airbag are  scrapped. The specialist workshops and the 
Vehicle disposal centres are familiar with these requirements.
WARNING
•If repairs are not carried out by a professional, or if the airbags are used 
incorrectl y, the  ris k of severe or fatal inju ries  is  increase d. T he airbags  may  
fail to inflate, or could inflate in the wrong circumstances.•Do not cover or stick anything on the steering wheel hub or the soft 
plastic surface of the airbag unit on the passenger side of the dashboard, 
and do not obstruct or modify them in any way.•It is important not to attach any objects such as cup holders or tele-
phone mountings to the surfaces covering the airbag units.•To clean the steering wheel or dash panel, you may use only a dry or a 
water-moistened cloth. Never clean the dash panel and the airbag module 
surface with cleansers containing solvents. Solvents cause the surface to 
become porous. If the airbag triggered, disintegrating plastic parts could 
cause substantial injuries.•Never attempt to repair, adjust, remove or install parts of the airbag 
system.•Any work on the airbag system or removal and installation of the airbag 
components for other repairs (such as repairs to the steering wheel) should 
be performed only by a qualified wo rkshop. Qualified workshops have the 
necessary tools, repair inform ation and qualified personnel.
Freetrack_EN.book  Seite 32  Donnerstag, 10. September 2009  10:33 10